traction control TOYOTA RAV4 1996 Service Repair Manual

Q08832
Q08831N
RP
Q07907
Neutral
Basic
Line
Groove
DI−134
− DIAGNOSTICSAUTOMATIC TRANSAXLE (A241E)
1996 RAV4 (RM447U)
(f) Inspect and adjust shift lever position.
When shifting the shift lever from the N position to other
positions, check that the lever can be shifted smoothly
and accurately to each position and that the position indi-
cator correctly indicates the position.
If the indicator is not aligned with the correct position, carry out
the following adjustment procedures:
(1) Loosen the nut on the control shaft lever.
(2) Push the control shaft lever fully downward.
(3) Return the control shaft lever 2 notches to the N
position.
(4) Set the shift lever to the N position.
(5) While holding the shift lever lightly toward the R
position side, tighten the shift lever nut.
Torque: 6.9 N·m (70 kgf·cm, 61 in·lbf)
(6) Start the engine and make sure that the vehicle
moves forward when shifting the lever from the N to
D position and reverses when shifting it to the R
position.
(g) Inspect and adjust park/neutral position switch.
Check that the engine can be started with the shift lever
only in the N or P position, but not in other positions.
If not as stated above, carry out the following adjustment proce-
dure:
(1) Loosen the park/neutral position switch bolt and set
the shift lever to the N position.
(2) Align the groove and neutral basic line.
(3) Hold in position and tighten the bolt.
Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)
HINT:
For continuity inspection of the park/neutral position switch, see
page DI−156.
(h) Inspect the idle speed.
Idle speed: 700 ± 50 rpm (In N position and A/C OFF)
8. MECHANICAL SYSTEM TESTS
(a) Measure the stall test
The object of this test is to check the overall performance of the transaxle and engine by measuring
the stall speeds in the D and R positions.
NOTICE:
Do the test at normal operation ATF temperature 50 − 80°C (122 − 176°F).
Do not continuously run this test longer than 5 seconds.
To ensure safety, conduct this test in a wide, clear, level area which provides good traction.
The stall test should be always carried out in pairs. One technician should observe the condi-
tions of wheels or wheel stoppers outside the vehicle while the other is doing the test.
(1) Chock the 4 wheels.
(2) Fully apply the parking brake.
(3) Connect OBD II scan tool or TOYOTA hand−held tester to the DLC3.