lock TOYOTA RAV4 2005 XA30 / 3.G Owner's Manual

'05 Rav4_U (L/O 0409)
35
2005 RAV4 from Sep. '04 Prod. (OM42570U)
BEFORE TUMBLING REAR SEAT1. Stow the rear seat belt buckles as shown in the illustration.
This prevents the buckles from falling out
when you tumble the rear seat.
CAUTION
Before using the seat belt, pull out
the buckle and make sure the belt is
not twisted.
NOTICE
The seat belt buckles must be stowed before you fold the seatback.
2. To stow the rear center seat belt, pull the belt out of its cover a little
and insert the concave end tab into
the higher slot of the cover.3. Insert the round end tab into theslot of the cover. You will hear a
click when the tabs are locked in the
seat belt cover. Make sure the tabs
are securely locked in the cover.
NOTICE
The seat belt must be stowed before
you fold the seatback.
ÐTumbling rear seats

'05 Rav4_U (L/O 0409)
36
2005 RAV4 from Sep. '04 Prod. (OM42570U)
TUMBLING REAR SEATS1. Hold the center of the lever and pull it up. Then slide the front seat fully
forward.
Tumbling the rear seats will enlarge the
luggage compartment. See ÐStowage
precautionsº on page 221 in Section 2 for
precautions when loading luggage.2. Hold the center of the lever and pull it up. Then slide the rear seat fully
backward and pull it forward slightly
until it locks.3. Lower the head restraint to the low-est position. Pull up the strap to
unlock the seatback and fold the
seatback forward until it locks.
NOTICE
Do not fold the seatback forward
while the luggage cover is set.

'05 Rav4_U (L/O 0409)
37
2005 RAV4 from Sep. '04 Prod. (OM42570U)
4. Pull up the seat cushion lock releaselever and swing the whole seat up
and forward.5. Make sure the front legs are lockedand the seat is securely locked in
position.RETURNING REAR SEATS
1. To unlock the seat, hold the upper back of the seat with your hand and
pull the lock release strap up. Swing
the whole seat down and set the
rear legs to the hooks on the floor.
Make sure the rear legs are securely
set to the hooks by trying to pull up
the rear part of the seat.

'05 Rav4_U (L/O 0409)
38
2005 RAV4 from Sep. '04 Prod. (OM42570U)
2. Pull the seatback lock release strapand swing the seatback up.
CAUTION
When returning seats to their original
position, observe the following pre-
cautions in order to prevent personal
injury in a collision or s udden stop:

Make sure the seat is securely
locked by pushing forward and rear-
ward on the top of the seatback or
by trying to pull up the edge of the
bottom cushion. Failure to do so
will prevent the seat belt from oper-
ating properly.

Make sure the seat belts are not
twisted or caught under the seat
and are arranged in their proper
position and are ready to use.1. Tumble the rear seats. (See ÐTum-
bling rear seatsº on page 35 in this
Section for instructions.)
ÐRemoving rear seats

'05 Rav4_U (L/O 0409)
39
2005 RAV4 from Sep. '04 Prod. (OM42570U)
2. Unlock the seat by pulling the lockrelease lever. Pull the seat toward
you slightly and lift.
Removing the rear seats will enlarge the
luggage compartment. See ÐStowage
precautionsº on page 221 in Section 2 for
precautions when loading luggage.
CAUTION
When removing the seat, observe the
following precautions in order to pre-
vent personal injury:

Be careful not to get your hands or
feet pinched in the seat.

Be careful not to hit the removed
seat against a person or drop it on
yourself.
NOTICE
Avoid putting heavy loads on the re- moved seat. The metallic tips of theseat leg may be damaged and theseat cannot be reinstalled.1. While pulling up the lock rel ease le-
ver, place the rear hinge into the
rear hook on the floor.
ÐReinstalling rear seats

'05 Rav4_U (L/O 0409)
40
2005 RAV4 from Sep. '04 Prod. (OM42570U)
2. Push the seat forward until it locks.3. To unlock the seat, hold the upperback of the seat with your hand and
pull the lock release strap up. Swing
the whole seat down and set the
rear legs to the hooks on the floor.
Make sure the rear legs are securely
set to the hooks by trying to pull up
the rear part of the seat.4. Pull the seatback lock release strapand swing the seatback up.

'05 Rav4_U (L/O 0409)
41
2005 RAV4 from Sep. '04 Prod. (OM42570U)
CAUTION
When returning seats to their original
position, observe the following pre-
cautions in order to prevent personal
injury in a collision or sudden stop:

Make sure the seat is securely
locked by pushing forward and rear-
ward on the top of the seatback or
by trying to pull up the edge of the
bottom cushion. Failure to do so
will prevent the seat belt from oper-
ating properly.

Make sure the seat belts are not
twisted or caught under the seat
and are arranged in their proper
position and are ready to use.
When removing or reinstalling the
seat, observe the following precau-
tions in order to prevent personal in-
jury:

Do not fold or remove the seat
while the vehicle is moving.

Be careful not to get your hands or
feet pinched in the seat.

Be careful not to hit the removed
seat against a person or drop it on
yourself.

After folding or installing the seat,
push it forward and backward to
make sure it is locked in position.
To prevent personal injury in a colli-
sion or sudden stop:

Do not sit on or place anything on
the folded seatback while driving.

Do not leave the removed seat
loose in the vehicle.

Do not try to sit on or place any-
thing on the removed seat.

When reinstalling the seat, be care-
ful not to hit the seat against you
or inside of the vehicle.

Install each seat in the same posi-
tion from which it was removed.
Failure to do so will prevent rear
seat occupants from using seat
belts properly.
For flattening seatbacks, do the follow-
ing: 1. Hold the center of the lever and pull it up. Then slide the rear seat fully
backward and pull it forward slightly
until it locks.
Flattening seatbacks
(front seat only)

'05 Rav4_U (L/O 0409)
42
2005 RAV4 from Sep. '04 Prod. (OM42570U)
2. Remove the head restraint. Hold thecenter of the lever and pull it up.
Then slide the front seat further for-
ward than the front- most lock posi-
tion.3. Pull the seatback angle adjusting le-ver up to unlock and push down the
seatback.
When returning the seatback to the up-
right position, be careful not to make
yourself hit by the seatback which will
bound with considerable spring force.
After returning the seat to its original
position, be certain to replace the head
restraint.
CAUTION

Do not allow passengers to ride on
the flattened seat while driving; use
the seat in the normal position.

After returning the seat to its origi-
nal position, try pushing the seat
and seatback forward and rearward
to make sure it is secured in place.
Be certain to replace head restraint.

'05 Rav4_U (L/O 0409)
43
2005 RAV4 from Sep. '04 Prod. (OM42570U)
For your safety and comfort, adjust the
head restraint before driving.
To raise: Pull it up.
To lower: Push it down while pressing the
lock release button.
The head restraint is most effective when
it is close to your head. Therefore, using
a cushion on the seatback is not recom-
mended.
CAUTION

Adjust the center of the head re-
straint so that it is closest to the
top of your ears.

After adjusting the head restraint,
make sure it is locked in position.

Do not drive with the head re-
straints removed.
To turn on the seat heater, push the
switches (Lº switch for the left front
seat and Rº switch for the right front
seat).
At this time, the indicator light on ei-
ther side of each switch will illuminate
to indicate the seat heater is operating.
The seat heater switches have the follow-
ing positions.
HIºÐHigh heating temperature
LOºÐLow heating temperature
The key must be in the ONº position to
operate seat heaters.
Pushing lightly on the opposite side will
turn it off.
Head restraintsSeat heaters

'05 Rav4_U (L/O 0409)
46
2005 RAV4 from Sep. '04 Prod. (OM42570U)
Ta b
Buckle
Adjust the seat as needed and sit up
straight and well back in the seat. To
fasten your belt, pull it out of the re-
tractor and insert the tab into the
buckle.
You will hear a click when the tab locks
into the buckle.
The seat belt length automatically adjusts
to your size and the seat position.
The retractor will lock the belt during a
sudden stop or on impact. It also may
lock if you lean forward too quickly. A
slow, easy motion will allow the belt to
extend, and you can move around freely. When a passenger 's shoulder belt is com-
pletely extended and is then retracted
even slightly, the belt is locked in that
position and cannot be extended. This fea-
ture is used to hold the child restraint
system securely. (For details, see Child
restraintº on page 69 in this Section.) To
free the belt again, fully retract the belt
and then pull the belt out once more.
If the seat belt cannot be pulled out of the
retractor, firmly pull the belt and release
it. You will then be able to smoothly pull
the belt out of the retractor.CAUTION

After inserting the tab, make sure
the tab and buckle are locked and
that the belt is not twisted.

Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and
buckle.

If the seat belt does not function
normally, immediately contact your
Toyota dealer. Do not use the seat
until the seat belt is fixed, because
it cannot protect an adult occupant
or your child from injury.
Ta k e u p
slack
To o h i g h
Keep as low on
hips as possible
Adjust the position of the lap and
shoulder belts.
Position the lap belt as low as possible
on your hipsÐnot on your waist, then ad-
just it to a snug fit by pulling the shoulder
portion upward through the latch plate.
ÐFastening front and rear
seat belts