center console TOYOTA RAV4 2006 Service Repair Manual

OTHER SYSTEM – CENTER POWER OUTLET SOCKETOT–5
OT
INSTALLATION
1. INSTALL CENTER POWER OUTLET SOCKET
ASSEMBLY
(a) Align the protrusion on the backside of the socket
with the groove of the cover. Then push the socket
into the cover.
2. INSTALL UPPER REAR CONSOLE PANEL SUB-
ASSEMBLY (See page IP-27)
3. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
(See page IP-27)
4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
5. INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH
(See page IP-28)
6. INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH
(See page IP-28)
7. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
B110252

RS–26SUPPLEMENTAL RESTRAINT SYSTEM – AIRBAG SYSTEM
RS
(3) The deceleration sensor is built into the front
airbag sensor, and the distortion that is created
in the sensor is converted into an electric signal
based on the vehicle deceleration rate during a
frontal collision. Accordingly, the extent of the
initial collision can be detected in detail.
(b) SIDE AIRBAG SENSOR
(1) The side airbag sensors are installed on the
bottom of the right and left center pillars.
(2) The side airbag sensor consists of the
deceleration sensor and ignition control circuit.
(3) The deceleration sensor is built into the side
airbag sensor, and the distortion that is created
in the sensor is converted into an electric signal
based on the vehicle deceleration rate during a
front side collision. Accordingly, the extent of the
initial collision can be detected in detail.
(c) REAR AIRBAG SENSOR
(1) The rear airbag sensors are installed on the right
and left rear pillars.
(2) The rear airbag sensor consists of the
deceleration sensor and ignition control circuit.
(3) The deceleration sensor is built into the rear
airbag sensor, and the distortion that is created
in the sensor is converted into an electric signal
based on the vehicle deceleration rate during a
rear side collision. Accordingly, the extent of the
initial collision can be detected in detail.
(d) CENTER AIRBAG SENSOR
(1) General
• The center airbag sensor is installed on the
center floor under the console box.
• The center airbag sensor consists of the
deceleration sensor, safing sensor, electronic
safing sensor, ignition control circuit and
diagnostic circuit.
• The center airbag sensor receives signals
from the deceleration sensor and safing
sensor built into the center airbag sensor and
front airbag sensor. Then the center airbag
sensor determines whether or not the driver
airbag, front passenger airbag, driver side
knee airbag and seat belt pretensioner should
be activated, and diagnoses system
malfunctions.
• The center airbag sensor causes the side
airbag and the curtain shield airbag to deploy
when receiving signals from the side and rear
airbag sensor.

LIGHTING – LIGHTING SYSTEMLI–17
LI
Stop light system
Illuminated entry system
Foot light system
Others
Symptom Suspected area See page
Stop light does not operate (All).1. STOP fuse LI-26
2. BRK relayLI-151
3. Stop light switchBR-13
4. Wire harnessLI-24
Only one stop light does not operate.1. Rear combination lightLI-107
2. Wire harnessLI-24
Symptom Suspected area See page
Illuminated entry of multiplex network body ECU
control does not operate (All).1. Ignition switchST-18
2. Door lock position circuitLI-70
3. Door courtesy switch circuitLI-66
4. Illumination circuitLI-75
5. Instrument panel junction blockLI-19
Symptom Suspected area See page
Step light of body ECU control does not operate.1. Ignition switchST-18
2. Door lock position switchLI-70
3. Door courtesy switch circuitLI-66
4. Footwell light circuitLI-73
5. Instrument panel junction blockLI-19
Symptom Suspected area See page
Vanity light does not operate.1. BulbLI-127
2. Vanity light switchLI-128
3. Wire harness -
Back-up light does not come on (All).1. GAUGE1 fuse LI-61
2. Park / neutral position switchAX-108
3. Wire harnessLI-59
Back door courtesy light does not come on.1. BulbLI-122
2. DOME fuse -
3. Back door courtesy switchLI-143
4. Wire harness -
Center console illumination does not come on.1. Center console lightLI-130
2. Wire harness -

LI–20LIGHTING – LIGHTING SYSTEM
LI
Stop light system
Illuminated entry system
Foot light system
Others
Symptom Suspected Area See page
Stop light does not operate (All).1. STOP fuse LI-26
2. BRK relayLI-151
3. Stop light switchBR-13
4. Wire harnessLI-24
Only one stop light does not operate.1. Rear combination lightLI-107
2. Wire harnessLI-24
Symptom Suspected Area See page
Illuminated entry of multiplex network body ECU
control does not operate (All).1. Ignition switchST-18
2. Door lock position circuitLI-70
3. Door courtesy switch circuitLI-66
4. Illumination circuitLI-75
5. Instrument panel junction blockLI-19
Symptom Suspected Area See page
Step light of body ECU control does not operate.1. Ignition switchST-18
2. Door lock position switchLI-70
3. Door courtesy switch circuitLI-66
4. Footwell light circuitLI-73
5. Instrument panel junction blockLI-19
Symptom Suspected Area See page
Vanity light does not operate.1. BulbLI-127
2. Vanity light switchLI-128
3. Wire harness -
Back-up light does not come on (All).1. GAUGE1 fuse LI-61
2. Park / neutral position switchAX-108
3. Wire harnessLI-59
Back door courtesy light does not come on.1. BulbLI-122
2. DOME fuse -
3. Back door courtesy switchLI-143
4. Wire harness -
Center console illumination does not come on.1. Center console lightLI-130
2. Wire harness -