hood release TOYOTA SEQUOIA 2010 2.G Owners Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2010, Model line: SEQUOIA, Model: TOYOTA SEQUOIA 2010 2.GPages: 660, PDF Size: 12.29 MB
Page 18 of 660
18
Pictorial indexInstrument panel
Headlight switch
Turn signal lever
Fog light switch
P. 182
P. 160
P. 185
Windshield wipers and
washer switch
P. 186
Parking brake pedal
P. 161
Gauges and meters
P. 163
Hood lock release
lever
P. 497
Tire pressure warning
reset switch
P. 514
Rear window wiper and
washer switch
P. 188
SRS knee air-
bags
P. 108
Page 497 of 660
497
4-3. Do-it-yourself maintenance
4
Maintenance and care
Hood
CAUTION
■Pre-driving check
Check that the hood is fully closed and locked.
If the hood is not locked properly, it may open while the vehicle is in motion
and cause an accident, which may result in death or serious injury.
Release the lock from the inside of the vehicle to open the hood.
Pull the hood release lever.
The hood will pop up slightly.
Pull up the hood catch lever
and lift the hood.
Page 600 of 660
600 5-2. Steps to take in an emergency
■Overheating
If you observe the following, your vehicle may be overheating.
●The engine coolant temperature gauge enters the red zone or a loss of
power is experienced.
● Steam is coming from under the hood.
● “ENGINE COOLANT HOT” is shown on the multi-information display
(vehicles with multi-information display).
CAUTION
■To prevent an accident or injury when inspecting under the hood of
your vehicle
● If steam is seen coming from under the hood, do not open the hood until
the steam has subsided. The engine compartment may be very hot, caus-
ing serious injury such as burns.
● Keep hands and clothing away from the fan and other belts while the
engine is running.
● Do not loosen the radiator cap while the engine and radiator are hot.
Serious injury, such as burns, may result from hot coolant and steam
released under pressure.
NOTICE
■When adding engine coolant
Wait until the engine has cooled down before adding engine coolant.
When adding coolant, do so slowly. Adding cool coolant to a hot engine too
quickly can cause damage to the engine.
Page 660 of 660
660
GAS STATION INFORMATION
Auxiliary catch leverP. 497Fuel filler doorP. 9 6
Tire inflation pressure
P. 615
Hood lock release lever P. 497
Fuel tank capacity 26.4 gal. (100.0 L, 22.0 lmp.gal.)
Fuel type P. 608
Cold tire inflation
pressureP. 6 1 5
Engine oil capacity
(Drain and refill)qt. (L, Imp.qt.)
With filter 7.9 (7.5, 6.6)
Without filter 7.4 (7.1, 6.2)
Engine oil type Toyota Genuine Motor Oil or equivalent
Oil grade: P. 608
ILSAC multigrade engine oil
Recommended oil viscosity: SAE 0W-20 (4.6 L V8 [1UR-FE] engine)
SAE 5W-20 or 0W-20 (5.7 L V8 [3UR-FE,
3UR-FBE] engine)