recommended oil TOYOTA SIENNA 2012 XL30 / 3.G Owners Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2012, Model line: SIENNA, Model: TOYOTA SIENNA 2012 XL30 / 3.GPages: 860, PDF Size: 15.08 MB
Page 642 of 860
642
4-2. Maintenance
SIENNA_U (OM45477U)
General maintenance
Engine compartment
ItemsCheck points
Battery Check the indicator and
connections. (
P. 667)
Brake fluid Is the brake fluid at the correct
level?
(P. 665)
Engine coolant Is the engine coolant at the
correct level? (
P. 662)
Engine oil Is the engine oil at the correct
level?
(P. 657)
Exhaust system There should not be any fumes or
strange sounds.
Radiator/condenser The radiator and condenser
should be free from foreign
objects.
(P. 664)
Washer fluid Is there sufficient washer fluid?
(P. 671)
Listed below are the general maintenance items that should be per-
formed at the intervals specified in the “Owner’s Warranty Informa-
tion Booklet” or “Owner’s Manual Supplement/Scheduled
Maintenance Guide”. It is recommended that any problem you notice
should be brought to the attention of your Toyota dealer or qualified
service shop for advice.
Page 788 of 860
788 6-1. Specifications
SIENNA_U (OM45477U)
Lubrication system
*: The engine oil capacity is a reference quantity to be used when changing theengine oil. Warm up and turn off the engine, wait more than 5 minutes, and
check the oil level on the dipstick.
■ Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use
Toyota approved “Toyota Genuine Motor Oil” or equivalent to satisfy
the following grade and viscosity.
Oil grade: ILSAC multigrade engine oil
Recommended viscosity: SAE 0W-20
SAE 0W-20 is the best choice for
good fuel economy and good
starting in cold weather.
If SAE 0W-20 is not available,
SAE 5W-20 oil may be used.
However, it must be replaced
with SAE 0W-20 at the next oil
change.
Oil capacity
(Drain and refill
reference
*)
1AR-FE engine
2GR-FE engine Without filter: 4.2 qt. (4.0 L, 3.5 Imp.qt.)
With filter: 4.6 qt. (4.4 L, 3.9 Imp.qt.)
Without filter: 6.0 qt. (5.7 L, 5.0 Imp.qt.)
With filter: 6.4 qt. (6.1 L, 5.4 Imp.qt.)
Outside temperature
Page 808 of 860
808 6-1. Specifications
SIENNA_U (OM45477U)
Glossary of tire terminology
Tire related termMeaning
Cold tire inflation pres-
sure Tire pressure when the vehicle has been
parked for three hours or more, or has not
been driven more than 1 mile or 1.5 km under
that condition
Maximum inflation
pressure The maximum cold inflated
pressure to which a
tire may be inflated, s hown on the sidewall of
the tire
Recommended infla-
tion pressure Cold tire inflation pressure recommended by a
manufacturer
Accessory weight The combined weight (in excess of those stan-
dard items which may be replaced) of auto-
matic transmission, power steering, power
brakes, power windows, power seats, radio
and heater, to the extent that these items are
available as factory-installed equipment
(whether installed or not)
Curb weight The weight of a motor vehicle with standard
equipment, including the maximum capacity of
fuel, oil and coolant, and if so equipped, air
conditioning and additional weight optional
engine
Maximum loaded vehi-
cle weight The sum of:
(a) Curb weight
(b) Accessory weight
(c) Vehicle capacity weight
(d) Production options weight
Page 860 of 860
860
SIENNA_U (OM45477U)
GAS STATION INFORMATION
Auxiliary catch leverP. 651Fuel filler doorP. 155
Hood release lever P. 6 5 1Fuel filler door opener P. 1 5 5Tire inflation pressure
P. 794
Back door openerP. 8 2
Fuel tank capacity
(Reference) 20.9 gal. (79 L, 17.4 Imp.gal.)
Fuel typeUnleaded gasoline with an Octane Rating of 87
(Research Octane Number 91)
Cold tire inflation
pressure
P. 7 9 4
Engine oil capacity
(Drain and refill
reference)qt. (L, Imp.qt.)
1AR-FE engine 2GR-FE engine
Without filter 4.2 (4.0 , 3.5) 6.0 (5.7, 5.0)
With filter 4.6 (4.4, 3.9) 6.4 (6.1, 5.4)
Engine oil type Toyota Genuine Motor Oil or equivalent
Oil grade:
P. 788
ILSAC multigrade engine oil
Recommended oil viscosity: 0W-20