BE4331
BE2826
Cassette Tape Slot Cover BE-74
- BODY ELECTRICALAUDIO SYSTEM
2052 Author: Date:
1997 SUPRA (RM502U)
6. CD Player/Disc Cleaning:
MAINTENANCE
If the disc gets dirty, clean the disc by wiping the surface from
the center to outside in the radial directions with a soft cloth.
NOTICE:
Do not use a conventional record cleaner or anti-static pre-
servative.
7. ANTI-THEFT SYSTEM
HINT:
The words ºANTI-THEFT SYSTEMº are displayed on the cas-
sette tape slot cover.
For operation instructions for the anti-theft system, please con-
sult the audio system section in the Owner's Manual (hereafter
called O/M).
(a) Setting system
The system is in operation once the customer has pushed
the required buttons and entered the customer-selected
3-digit ID number.
(Refer to the O/M section, ºSetting the anti-theft systemº)
HINT:
When the audio system is shipped, the ID number has not
been input, so the anti-theft system is not in operation.
If the ID number has not been input, the audio system re-
mains the same as a normal audio system.
(b) Anti-theft system operation
If the normal electrical power source (Connector or bat-
tery terminal) is cut off, the audio system becomes inoper-
able, even if the power supply resumes.
(c) Canceling system
The ID number chosen by the customer is input to cancel
the anti-theft system
(Refer to the O/M section, ºIf the system is activatedº)
HINT:
To change or cancel the ID number, please refer to the O/M
ºCancelling the systemº.
BE0ER-01
Z14749
Insert
Front
Teeth on
Cable
BE4674
Twist BE-100
- BODY ELECTRICALANTENNA
2078 Author: Date:
1997 SUPRA (RM502U)
INSTALLATION
INSTALL ANTENNA ROD
(a) Insert the cable of the rod until it reaches the bottom.
HINT:
When inserting the cable, the teeth on the cable must face
toward the rear of the vehicle.
Insert the cable approx. 400 mm.
(b) Wind the cable to retract the rod by turning the ignition
switch to ºLOCKº position.
HINT:
If the ignition switch is already in ºLOCKº position, do step
1 (c) first, then turn the ignition switch to ºACCº position.
In case the cable is not wound, twist it as shown in the il-
lustration.
Even if the rod has not retracted fully, install the antenna
nut and inspect the antenna rod operation. It will finally re-
tract fully.
(c) Inspect the antenna rod operation by pushing the radio
wave band select buttons.
