MT06O-01
Q04417
Q06365
Q09475
Filler Plug
Drain PlugOil Level
0 - 5 mm
Q04419
R06858
- MANUAL TRANSMISSION (V160)MANUAL TRANSMISSION UNIT
MT-3
1571 Author: Date:
1997 SUPRA (RM502U)
REMOVAL
1. REMOVE UPPER CONSOLE PANEL, SHIFT LEVER
BOOT RETAINER AND SHIFT AND SELECT LEVER
BOOTS NO.1 AND NO.2
(a) Remove the shift lever knob.
(b) Using a screwdriver, pry out the upper console panel.
(c) Remove the 4 bolts and boot retainer.
(d) Remove the shift and select lever boots No.1 and No.2.
2. REMOVE 4 TRANSMISSION SHIFT LEVER SET
BOLTS
Torque: 7.8 N´m (80 kgf´cm, 69 in.´lbf)
3. RAISE VEHICLE
NOTICE:
Make sure that the vehicle is securely supported.
4. DRAIN TRANSMISSION OIL
Oil type: TOYOTA GEAR OIL V160 or ESSO ATF
DEXRON®D-21065
Capacity: 1.8 liters (1.9 US qts, 1.6 Imp. qts)
Torque: 39 N´m (400 kgf´cm, 29 ft´lbf)
5. REMOVE ENGINE UNDER COVER
6. REMOVE EXHAUST FRONT PIPE AND PIPE SUP-
PORT BRACKET
(a) Remove the 2 nuts, cover, oxygen sensor and gasket.
Torque: 20 N´m (200 kgf´cm, 14 ft´lbf)
(b) Remove the 2 bolts, nuts and gasket.
Torque: 58 N´m (590 kgf´cm, 43 ft´lbf)
(c) Remove the 2 bolts and pipe support bracket from the
clutch housing.
Torque: 37 N´m (380 kgf´cm, 27 ft´lbf)
(d) Remove the 2 bolts, nuts and gasket.
Torque: 58 N´m (590 kgf´cm, 43 ft´lbf)
(e) Remove the exhaust front pipe.
Z04031
R08549
Less than 5 mm (0.20 in.)
- SUSPENSION AND AXLEREAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
SA-61
1751 Author: Date:
1997 SUPRA (RM502U)
7. INSTALL SIDE GEAR SHAFT
(a) Install a new snap ring to the side gear shaft.
(b) Coat MP grease onto the snap ring.
(c) Using a brass bar and hammer, install the side gear shaft
to the differential.
NOTICE:
Be careful not damage the side gear shaft and oil seal.
HINT:
Whether or not the side gear shaft is making contact with the
pinion shaft can be determined by the sound or feeling when
driving it in.
8. CHECK INSTALLATION OF SIDE GEAR SHAFT
Check that the side gear shaft will not come out by trying to pull
it out by hand.
9. INSTALL REAR DRIVE SHAFT (See page SA-58)
10. FILL DIFFERENTIAL WITH HYPOID GEAR OIL
Torque: 49 N´m (500 kgf´cm, 36 ft´lbf)
Oil grade: Hypoid gear oil API GL-5
Viscosity:
Above -18 °C (0 °F) SAE 90
Below -18 °C (0 °F) 80W-90 or SAE 80W
Capacity: 1.35 liters (1.43 US qts, 1.19 lmp. qts)
