child seat TOYOTA TACOMA 2001 (in English) Workshop Manual

’01 Tacoma U (L/O 0009)
942001 TACOMA (OM35766U)
Double cab with rear seat1. Remove the head restraint (outside position only).2. Pull the seatback release lever andswing the seatback forward slightly,
then latch the hook onto the anchor
bracket.
Return the seatback to upright posi-
tion, then tighten the top strap.3. Fix the child restraint system withthe seat belt.
Replace the head restraint (outside
position only).
For instructions on installing the child re-
straint system, see Child restraint" in this
section.

’01 Tacoma U (L/O 0009)
952001 TACOMA (OM35766U)
CAUTION
When returning the seatback to its
original position, make sure the
seatback is securely locked by
pushing forward and rearward on
the top of the seatback.
Make sure the top strap is securely
latched, and check that the child
restraint system is secure by push-
ing and pulling it in different direc-
tions. Follow all the installation in-
structions provided by its manufac-
turer.
Front outside position
Front center position
Rear outside position
Follow the procedure below for a child
restraint system that requires the use
of a top strap.
 U sin g a to p st rap
(Xtra−cab models)

’01 Tacoma U (L/O 0009)
962001 TACOMA (OM35766U)
Routing
device
Upper
anchor bracket
Lower anchor
bracket
Use the routing device and the anchor
bracket to attach the top strap.
Upper anchor bracket is installed for
right−front passenger ’s seating position,
lower anchor bracket is installed for front
center seating position (with split bench
seat) or right−rear seating position.
This symbol indicates the locations of
user ready anchor bracket.TO USE THE ANCHOR BRACKET:
Front outside position 1. Remove the passenger head re- straint.2. Fix the child restraint system withthe seat belt.
Latch the hook onto the anchor
bracket on the back panel and tight-
en the top strap.
For instructions on installing the child re-
straint system, see Child restraint" in this
section.

’01 Tacoma U (L/O 0009)
972001 TACOMA (OM35766U)
CAUTION
Make sure the top strap is securely
latched, and check that the child re-
straint system is secure by pushing
and pulling it in different directions.
Follow all the installation instructions
provided by its manufacturer.
3. Replace the head restraint.Front center position
Fix the child restraint system with the
seat belt.
Latch the hook onto the rear lower an-
chor bracket and tighten the top strap.
For instructions on installing the child re-
straint system, see Child restraint" in this
section.

’01 Tacoma U (L/O 0009)
982001 TACOMA (OM35766U)
CAUTION
Make sure the top strap is securely
latched, and check that the child re-
straint system is secure by pushing
and pulling it in different directions.
Follow all the installation instructions
provided by its manufacturer.
Rear outside position1. Lightly push down on the top sur- face of the anchor bracket cover
with the symbol mark shown in the
illustration, then pull it forward to
remove.
Routing
device
2. Fix the child restraint system withthe seat belt.
Route the top strap through the
routing device as shown in the il-
lustration.
For instructions on installing the child re-
straint system, see Child restraint" in this
section.
CAUTION
Make sure the top strap is not
twisted.