tow bar TOYOTA TERCEL 1996 Service Repair Manual

R11822
SST
SA12A-05
SA1459
R09694
Inboard Joint Boot Outboard Joint Boot
- SUSPENSION AND AXLEFRONT DRIVE SHAFT
SA-21
1996 TERCEL (RM440U)
REASSEMBLY
1. w/o ABS:
INSTALL DUST DEFLECTOR NO.2
Using SST and a press, install a new dust deflector No.2.
SST 09309-36010, 09316-20011
2. INSTALL DUST COVER
Using a press, install a new dust cover to the inboard joint tulip.
3. TEMPORARILY INSTALL BOOTS, CLAMPS AND
DAMPER (RH DRIVE SHAFT)
HINT:
Before installing the boots, wrap vinyl tape around the spline of
the drive shaft to prevent damaging the boot.
(a) Temporarily install a new outboard joint boot.
(b) RH drive shaft:
Temporarily install the damper.
(c) Temporarily install a new inboard joint boot.
4. INSTALL TRIPOD
(a) Place the beveled side of the tripod axial spline toward the
outboard joint.
(b) Align the matchmarks before removal.
(c) Using a brass bar and hammer, tap in the tripod to the
drive joint shaft.
NOTICE:
Do not tap the roller.
(d) Using a snap ring expander, install a new snap ring.
5. INSTALL BOOT TO OUTBOARD JOINT
Before assembling the boot, pack the outboard joint and boot
with grease in the boot kit.
Grease capacity: 65 - 75 g (2.3 - 2.6 oz.)
6. INSTALL INBOARD JOINT TO FRONT DRIVE SHAFT
(a) Pack the inboard tulip and boot with grease in the boot kit.
Grease capacity: 112 - 122 g (4.0 - 4.3 oz.)
(b) Align the matchmarks as they were placed before disas-
sembly
(c) Install the inboard joint tulip to the drive shaft.
(d) Temporarily install the boot to the inboard joint shaft.