’02 TUNDRA_U (L/O 0108)
2212002 MY TUNDRA_U (OM 34417U)
Ty p e C
Ty p e D
10. Reinstall the wheel ornament.
1. Put the wheel ornament in position.
Type A—Align the cutout of the wheel
ornament with the valve stem as shown. 2. Then firmly tap the outer edge of the wheel cap with the side or heel of your
hand to snap it into place.
CAUTION
Take due care in handling the orna-
ment to avoid unexpected personal
injury.
11. Check the air pressure of the re- placed tire.
Adjust the air pressure to the specification
designated in Section 8. If the pressure is
lower, drive slowly to the nearest service
station and fill to the correct pressure.
Do not forget to reinstall the tire inflation
valve cap as dirt and moisture could get
into the valve core and possibly cause air
leakage. If the cap is missing, have a new
one put on as soon as possible.
12. Restow all the tools, jack and flat tire securely.
With a spare tire of the same wheel type
as the installed tires—
As soon after changing wheels as pos-
sible, tighten the wheel nuts to the torque
specified in Section 8 with a torque
wrench. Have a technician repair the flat
tire.
With a spare tire of different wheel type
from the installed tires—
As soon after changing wheels as pos-
sible, tighten the wheel nuts to the torque
specified in Section 8 with a torque
wrench. Have a technician repair the flat
tire and replace the spare tire with it.
—After changing wheels
’02 TUNDRA_U (L/O 0108)
2802002 MY TUNDRA_U (OM 34417U)
Tires
Engine compartment (2UZ FE engine)
Tire size and pressure:
Tire size
P245/70R16
P265/70R16 Tire pressure kPa, (kgf/cm2 or bar, psi)
Front Rear
180 (1.8, 26) 240 (2.4, 35) 200 (2.0, 29)
180 (1.8, 26)
Wheel size: Two wheel drive models 16 7J or 7JJ
Off road package 16 7JJ
Others 16 7J or 7JJ
Wheel nut torque, N·m (kgf·m, ft·lbf): 110 (11.5, 83.2)
NOTE: For a complete information on tires (e.g. replacing tires or replacing wheels), see “Checking tire pressure” through “Aluminum wheel precautions” in Section
7 2.
Fuses
