stop start TOYOTA URBAN CRUISER 2012 Workshop Manual

357 4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_EE (OM52C21E)
CAUTION
When raising your vehicle
Make sure to observe the following to reduce the possibility of death or seri-
ous injury.
When using a floor jack, follow the instructions of the manual provided with
the jack.
Do not use the jack that was supplied with your vehicle.
Do not put any part of your body underneath the vehicle when it is sup-
ported only by the floor jack.
Always use floor jack and/or automotive jack stands on a solid, flat, level
surface.
Do not start the engine while the vehicle is supported by the floor jack.
Stop the vehicle on level firm ground, firmly set the parking brake and shift
the shift lever in “R”.
Make sure to set the floor jack properly at the jack point.
Raising the vehicle with an improperly positioned floor jack will damage
the vehicle and may cause the vehicle to fall off the floor jack.
Do not raise the vehicle while someone is in the vehicle.
When raising the vehicle, do not place any objects on top of or underneath
the floor jack.
Lift up the vehicle using a floor jack
such as the one shown in the illustra-
tion.

363 4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_EE (OM52C21E)
After changing the engine oil (diesel engine only)
The oil change system should be reset. Perform the following procedures:
Vehicles without smart entry & start system
Switch the display to trip meter A (P. 190) when the engine is run-
ning.
Turn the engine switch to the “LOCK” position.
While pressing the “MODE” button, set the engine switch to the
“ON” position (but do not start the engine because otherwise the
reset mode will be canceled). Continue to press and hold the button
until the multi-information display indicates that the reset is com-
plete.
Vehicles with smart entry & start system
Switch the display to trip meter A (P. 190) when the engine is run-
ning.
Turn the “ENGINE START STOP” switch OFF.
While pressing the “MODE” button, set the “ENGINE START
STOP” switch to the IGNITION ON mode (but do not start the
engine because otherwise the reset mode will be canceled). Con-
tinue to press and hold the button until the multi-information display
indicates that the reset is complete.
STEP1
STEP2
STEP3
STEP1
STEP2
STEP3

382
4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)
Air conditioning filter
The air conditioning filter must be cleaned or changed regularly to
maintain air conditioning efficiency.
Removal method
Vehicles without smart entry & start system: Turn the
engine switch to the “LOCK” position.
Vehicles with smart entry & start system: Turn the “ENGINE
START STOP” switch OFF.
Open the glove box. Slide off
the damper.
Push in each side of the glove
box to disconnect the claws.
STEP1
STEP2
STEP3

390
4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have
blown. If this happens, check and replace the fuses as necessary.
Vehicles without smart entry & start system
Turn the engine switch to the “LOCK” position.
Vehicles with smart entry & start system
Turn the “ENGINE START STOP” switch OFF.
The fuses are located in the following places. To check the
fuses, follow the instructions below.
Engine compartment
Ty p e A
Push the tab in and lift the lid
off.
Type B (if equipped)
Push the tab in and lift the lid
off.
STEP1
STEP2

396 4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)
Fuse layout and amperage ratings
Engine compartment (type A)
FuseAmpereCircuit
1AM215 AStarting system, multi-port fuel
injection system/sequential multi-
port fuel injection system, Stop &
Start system, smart entry & start
system
2HORN10 A Horn
3
EFI*1, 2, 3, 420 AMulti-port fuel injection system/
sequential multi-port fuel injection
system
ECD*5, 6, 7, 830 A
4 SPARE 30 A Spare fuse
5 SPARE 15 A Spare fuse
6 SPARE 10 A Spare fuse
7HTR SUB2
*340 A
Air conditioning system
HTR SUB1
*750 A
8 EPS 50 A Electric power steering

397 4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_EE (OM52C21E)
FuseAmpereCircuit
9 ABS1/VSC1 50 A ABS, VSC
10 HTR 40 A Air conditioning system
11 RDI 30 A Electric cooling fan
12
HTR SUB1*3
30 A Air conditioning system
HTR SUB2*7
13H-LP CLN/PWR
HTR*530 A Air conditioning system
HTR SUB3
*7
14 FR DEF 20 A No circuit
15 ABS2/VSC2 30 A ABS, VSC
16 H-LP MAIN 30 A“H-LP HI LH”, “H-LP HI RH”, “H-LP
RH/H-LP LO RH”, “H-LP LH/H-LP
LO LH” fuses
17 ST 30 A Starting system
18 S-LOCK 20 A Smart entry & start system
19 DOME 15 AInterior light, personal lights, lug-
gage compartment light, smart
entry & start system, wireless
remote control, audio system
20 ECU-B 7.5 ADaytime running light system,
power windows, power door lock
system, smart entry & start system,
gauges and meters, air condition-
ing system, VSC, Active Torque
Control 4WD system, Stop & Start
system
21
ALT-S*1, 2, 3, 47.5 A
Charging system, fuel system
F/PMP*5, 6, 7, 830 A
22 ETCS 10 A Electronic throttle control system

398 4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)
*1: Gasoline engine (vehicles with a Stop & Start system)
*2: Gasoline engine (vehicles without a Stop & Start system)
*3: Gasoline engine (vehicles with PTC heater)
*4: Gasoline engine (vehicles without PTC heater)
*5: Diesel engine (vehicles with power heater)
*6: Diesel engine (vehicles without power heater)
*7: Diesel engine (vehicles with PTC heater)
*8: Diesel engine (vehicles without PTC heater)
FuseAmpereCircuit
23 HAZ 10 ATurn signal lights, emergency
flashers
24
BBC*140 A Stop & Start system
AMT*5, 6, 7, 850 A No circuit
25H-LP RH/H-LP
LO RH10 A Right-hand headlight
26H-LP LH/H-LP
LO LH10 A Left-hand headlight
27EFI2
*1, 2, 3, 4
10 AMulti-port fuel injection system/
sequential multi-port fuel injection
system ECD2
*5, 6, 7, 8
28 ECD3*5, 6, 7, 87.5 AMulti-port fuel injection system/
sequential multi-port fuel injection
system

400 4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)Under the instrument panel (type A)
Fuse nameAmpereCircuit
1TA I L
*110 AFront position lights, tail lights,
license plate lights, manual head-
light leveling dial, multi-port fuel
injection system/sequential multi-
port fuel injection system, instru-
ment cluster lights PA N E L 2
*27.5 A
2 PANEL1
*27.5 ASwitch illuminations, instrument
cluster lights, steering switches,
Stop & Start system, gauges and
meters
3A/C 7.5 AAir conditioning system, rear win-
dow defogger, power heater

401 4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_EE (OM52C21E)
Fuse nameAmpereCircuit
4 D DOOR 20 A Power windows
5 RL DOOR 20 A Power windows (rear left)
6 RR DOOR 20 A Power windows (rear right)
7 CIG 15 A Cigarette lighter
8ACC 7.5 APower door lock system, outside
rear view mirrors, audio system
9ID/UP / MIR
HTR10 A Outside rear view mirror defoggers
10 AM1 NO2
*37.5 A No circuit
11 RR FOG 7.5 A Rear fog light
12 IGN 7.5 AMulti-port fuel injection system/
sequential multi-port fuel injection
system, SRS airbag system, smart
entry & start system, Stop & Start
system
13 MET 7.5 A Gauges and meters
14 P S-HTR 15 A Seat heater
15 D S-HTR 15 A Seat heater
16 WIP 20 A Windshield wipers
17 RR WIP 15 A Rear window wiper
18 WSH 15 AWindshield washers, rear window
washer

402 4-3. Do-it-yourself maintenance
URBAN CRUISER_EE (OM52C21E)
Fuse nameAmpereCircuit
19 ECU-IG 10 ADaytime running light system, ABS,
electric power steering, power win-
dows, power door lock system,
VSC, Active Torque Control 4WD
system, smart entry & start system,
Stop & Start system, electric cool-
ing fan
20 GAUGE 10 ACharging system, turn signal lights,
emergency flashers, back-up
lights, air conditioning system, rear
window defogger, gauges and
meters
21 OBD2 7.5 A On-board diagnosis system
22 STOP 10 AStop lights, high mounted stop-
light, multi-port fuel injection sys-
tem/sequential multi-port fuel
injection system, ABS, VSC
23 D/L 25 APower door lock system, double
locking system
24 FR FOG 15 A Front fog lights
25 4WD 7.5 A Active Torque Control 4WD system