engine TOYOTA URBAN CRUISER 2015 Owners Manual

5
449
5-2. Steps to take in an emergency
When trouble arises
URBAN CRUISER_OM_OM52F47E_(EE)
If you have a flat tire (vehicles with a spare tire)
Remove the flat tire and replace it with the spare provided.
■Before jacking up the vehicle
● Stop the vehicle on a hard, flat surface.
● Set the parking brake.
● Shift the shift lever to “R”.
● Stop the engine.
● Turn on the emergency flashers. ( →P. 428)
■ Location of the spare tire and tools
2WD models
Jack handle
Spare tire
Tool bag
(Towing eyelet
and wheel nut
wrench)

5
461
5-2. Steps to take in an emergency
When trouble arises
URBAN CRUISER_OM_OM52F47E_(EE)
CAUTION
■
Using the tire jack
Improper use of the tire jack may lead to death or serious injuries due to the
vehicle suddenly falling off the jack.
●Do not use the tire jack for any purpose other than replacing tires or install-
ing and removing tire chains.
● Only use the tire jack that comes with this vehicle for replacing a flat tire.
Do not use it on other vehicles, and do not use other tire jacks for replac-
ing tires on this vehicle.
● Always check that the tire jack is securely set to the jack point.
● Do not put any part of your body under the vehicle supported by a jack.
● Do not start or run the engine while your vehicle is supported by the jack.
● Do not raise the vehicle while someone is in it.
● When raising the vehicle, do not put an object on or under the jack.
● Do not raise the vehicle to a height greater than that required to replace
the tire.
● Use a jack stand if it is necessary to get under the vehicle.
Take particular care when lowering the vehicle to ensure that no one working
on or near the vehicle will be injured.

464
5-2. Steps to take in an emergency
URBAN CRUISER_OM_OM52F47E_(EE)
If you have a flat tire (vehicles without a spare tire)
Your vehicle is equipped with an emergency tire puncture repair kit.
A puncture caused by a nail or screw passing through the tire tread
can be repaired temporarily with the emergency tire puncture repair
kit.
■ Before repairing the vehicle
● Stop the vehicle in a safe place on a hard, flat surface.
● Set the parking brake.
● Shift the lever to “N”.
● Stop the engine.
● Turn on the emergency flashers. ( →P. 428)
■ Location of the emergency tire puncture repair kit and jack
*: Use of the jack (→P. 452)
Emergency tire
puncture repair
kit
Jack*

470
5-2. Steps to take in an emergency
URBAN CRUISER_OM_OM52F47E_(EE)
Check the specified tire inflation
pressure.
Tire inflation pressure is speci-
fied on the label in the glove box
as shown. ( →P. 521)
Start the engine.
To inject the sealant and inflate
the tire, turn the compressor
switch on.
Use the kit with the top facing
upward.
STEP8
STEP9
STEP10

480
5-2. Steps to take in an emergency
URBAN CRUISER_OM_OM52F47E_(EE)
If the engine will not start
If the engine still does not start after following the correct starting
procedure (→P. 185, 181), confirm the following points.
■ The engine will not start even though the starter motor
operates normally.
One of the following may be the cause of the problem.
● There may not be sufficient fuel in the vehicle’s tank.
Gasoline engine: Refuel the vehicle.
Diesel engine: ( →P. 497)
● The engine may be flooded. (gasoline engine)
Try to restart the engine again following correct starting proce-
dures. ( →P. 185, 181)
● There may be a malfunction in the engine immobilizer system.
(→ P. 1 1 0 )
■ The starter motor turns over slowly, the interior lights and
headlights are dim, or the horn does not sound or sounds at
a low volume
One of the following may be the cause of the problem.
● The battery may be discharged. ( →P. 487)
● The battery terminal connections may be loose or corroded.

484
5-2. Steps to take in an emergency
URBAN CRUISER_OM_OM52F47E_(EE)
If the electronic key does not operate properly
Locking and unlocking the doors and key linked functionsUsing the mechanical key (
→P. 3 3 )
in order to perform the following
operations.
Locks all doors
Unlocks all doors
An alarm will sound if the alarm is
set. ( →P. 120)
For vehicles with smart entry & start system: If communication
between the electronic key and vehicle is interrupted ( →P. 40) or the
electronic key cannot be used because the battery is depleted, the
smart entry & start system and wireless remote control cannot be
used. In such cases, the doors can be opened or the engine can be
started by following the procedure below.

5
485
5-2. Steps to take in an emergency
When trouble arises
URBAN CRUISER_OM_OM52F47E_(EE)
Starting the engine
Shift the shift lever to “N” and depress the clutch pedal. Touch the Toyota emblem side of
the electronic key to the
“ENGINE START STOP” switch.
An alarm will sound to indicate
that the start function cannot
detect the electronic key that is
touched to the “ENGINE START
STOP” switch if any of the doors
is opened while the key is
touched to the switch.
Press the “ENGINE START STOP” switch within 5 seconds
after the buzzer sounds, keeping the clutch pedal depressed.
In the event that the “ENGINE START STOP” switch still cannot be
operated, contact any authorized Toyota dealer or repairer, or another
duly qualified and equipped professional.
STEP1
STEP2
STEP3

486
5-2. Steps to take in an emergency
URBAN CRUISER_OM_OM52F47E_(EE)
■ Stopping the engine
Shift the shift lever to “N” and press the “ENGINE START STOP” switch as
you normally do when stopping the engine.
■ Replacing the key battery
As this procedure is a temporary measure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery depletes.
(→ P. 399)
■ Alarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set,
the alarm may be triggered. ( →P. 120)
■ Changing “ENGINE START STOP” switch modes
Within 5 seconds of the buzzer sounding, release the clutch pedal and press
the “ENGINE START STOP” switch.
The engine does not start and modes will be changed each time the switch
is pressed. ( →P. 186)

5
487
5-2. Steps to take in an emergency
When trouble arises
URBAN CRUISER_OM_OM52F47E_(EE)
If the batter y is discharged
The following procedures may be used to start the engine if the vehi-
cle’s battery is discharged.
You can call any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional.
If you have a set of jumper (or booster) cables and a second vehi-
cle with a 12-volt battery, you can jump start your Toyota following
the steps below.Push the tab in and lift the cover off.
Left-hand drive vehicles
Right-hand drive vehicles
STEP1

488
5-2. Steps to take in an emergency
URBAN CRUISER_OM_OM52F47E_(EE)
Connect the jumper cables.
Gasoline engine
Positive (+) battery terminal on your vehicle
Positive (+) battery terminal on the second vehicle
Negative (-) battery terminal on the second vehicle
Connect the jumper cable to ground on your vehicle as shown in
the illustration.
Diesel engineSTEP2