bulb TOYOTA URBAN CRUISER 2015 Owners Manual

1
2
3
4
5
6
5
URBAN CRUISER_OM_OM52F47E_(EE)
4-2. Maintenance Maintenance requirements..................... 358
4-3. Do-it-yourself maintenance Do-it-yourself service precautions ....................... 362
Hood ................................... 366
Positioning a floor jack ........ 368
Engine compartment........... 370
Tires .................................... 388
Tire inflation pressure ......... 391
Wheels ................................ 393
Air conditioning filter ........... 395
Key battery.......................... 398
Checking and replacing fuses ................................. 402
Light bulbs .......................... 418
5-1. Essential information Emergency flashers ............ 428
If your vehicle needs to be towed ....................... 429
If you think something is wrong ............................ 437
Fuel pump shut off system (gasoline engine) .............. 438 5-2. Steps to take in an emergency
If a warning light turns on or a warning buzzer
sounds ............................. 439
If you have a flat tire (vehicles with
a spare tire) ...................... 449
If you have a flat tire (vehicles without
a spare tire) ...................... 464
If the engine will not start ... 480
If you lose your keys .......... 482
If you cannot operate the back door opener ....... 483
If the electronic key does not operate properly ......... 484
If the battery is discharged ....................... 487
If your vehicle overheats .... 493
If you run out of fuel and the engine stalls
(diesel engine) ................. 497
If the vehicle becomes stuck................................. 500
If your vehicle has to be stopped in an
emergency ....................... 502
5When trouble arises

193
2-1. Driving procedures
2
When driving
URBAN CRUISER_OM_OM52F47E_(EE)
Tur n signal lever
■Turn signals can be operated when
Vehicles without smart entry & start system
The engine switch is in the “ON” position.
Vehicles with smart entry & start system
The “ENGINE START STOP” switch is in the IGNITION ON mode.
■ If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out. The turn signal lever can be used to show the following intentions of
the driver:
Right turn
Left turn
Lane change to the right
(push and hold the lever
partway)
The right hand signal will flash
until you release the lever.
Lane change to the left
(push and hold the lever
partway)
The left hand signal will flash
until you release the lever.

4Maintenance and care
349
URBAN CRUISER_OM_OM52F47E_(EE)
4-1. Maintenance and care Cleaning and protecting the vehicle exterior ......... 350
Cleaning and protecting the vehicle interior .......... 354
4-2. Maintenance Maintenance requirements................... 358
4-3. Do-it-yourself maintenance Do-it-yourself service precautions ..................... 362
Hood ................................. 366
Positioning a floor jack ...... 368
Engine compartment......... 370
Tires .................................. 388
Tire inflation pressure ....... 391
Wheels .............................. 393
Air conditioning filter ......... 395
Key battery........................ 398
Checking and replacing fuses ............................... 402
Light bulbs ........................ 418

417
4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_OM_OM52F47E_(EE)
■
After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. ( →P. 418)
● If the replaced fuse blows again, have the vehicle inspected by any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
■ If there is an overload in the circuits
The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury.
●Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.
● Do not modify the fuse or the fuse box.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by any autho-
rized Toyota dealer or repairer, or another duly qualified and equipped pro-
fessional, as soon as possible.

418
4-3. Do-it-yourself maintenance
URBAN CRUISER_OM_OM52F47E_(EE)
Light bulbs
You may replace the following bulbs by yourself. The difficulty level
of replacement varies depending on the bulb. As there is a danger
that components may be damaged, we recommend that replacement
is carried out by any authorized Toyota dealer or repairer, or another
duly qualified and equipped professional.
■Prepare a replacement light bulb
Check the wattage of the light bulb being replaced. ( →P. 522)
■ Front bulb locations
Front turn signal light
Front position light
Headlight
Front fog light
(if equipped)

419
4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_OM_OM52F47E_(EE)
■
Rear bulb locations
Back-up light
or rear fog light
License plate lights
Stop/tail light
Rear turn signal lightBack-up light
or rear fog light

420
4-3. Do-it-yourself maintenance
URBAN CRUISER_OM_OM52F47E_(EE)
Replacing light bulbs ■ Headlight
Unplug the connector and
remove the rubber cover.
Release the bulb retaining
spring.
Remove the bulb.
To install a new bulb, align the
tabs of the bulb with the cutouts
of the mounting hole.
When installing, reverse the steps listed.
STEP1
STEP2
STEP3
STEP4

421
4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_OM_OM52F47E_(EE)
■
Front fog light (if equipped)
Remove the fender liner bolts.
Partly remove the fender liner
and unplug the connector while
pushing the lock release.
Turn the bulb base counterclock-
wise.
When installing, reverse the steps listed.
STEP1
STEP2
STEP3
STEP4

422
4-3. Do-it-yourself maintenance
URBAN CRUISER_OM_OM52F47E_(EE)
■ Front position light
Turn the bulb base counterclock-
wise.
Remove the light bulb.
When installing, reverse the steps listed.
STEP1
STEP2
STEP3

423
4-3. Do-it-yourself maintenance
4
Maintenance and care
URBAN CRUISER_OM_OM52F47E_(EE)
■
Front turn signal light
Turn the bulb base counterclock-
wise.
Remove the light bulb.
When installing, reverse the steps listed.
STEP1
STEP2
STEP3