bulb TOYOTA VENZA 2012 Owners Manual (in English)

1
2
3
4
5
6
7
5
VENZA_U (OM73013U)
3-6. Using the interior lightsInterior lights list .................. 446
• Personal/interior light main switch ....................... 447
• Personal/interior lights ...... 448
• Luggage compartment light ................................... 448
3-7. Using the storage features List of storage features ....... 450
• Glove box.......................... 451
• Console boxes .................. 452
• Overhead console............. 454
• Cup holders ...................... 455
• Bottle holders .................... 457
• Auxiliary boxes.................. 458
3-8. Other interior features Sun visors ........................... 461
Vanity mirror........................ 462
Power outlets ...................... 463
Seat heaters........................ 466
Armrest ............................... 468
Floor mats ........................... 469
Luggage compartment features ............................. 471
Garage door opener............ 473
Compass ............................. 480 4-1. Maintenance and care
Cleaning and protecting the vehicle exterior ........... 486
Cleaning and protecting the vehicle interior ............ 489
4-2. Maintenance Maintenance requirements .................... 492
General maintenance ......... 495
Emission inspection and maintenance (I/M)
programs .......................... 498
4-3. Do-it-yourself maintenance Do-it-yourself service precautions....................... 499
Hood ................................... 503
Positioning a floor jack ....... 505
Engine compartment .......... 507
Tires ................................... 522
Tire inflation pressure ......... 529
Wheels ............................... 533
Air conditioning filter ........... 536
Key battery ......................... 539
Checking and replacing fuses................................. 543
Light bulbs .......................... 553
4Maintenance and care

173
2-1. Driving procedures
2
When driving
VENZA_U (OM73013U)
Tur n signal lever
■Turn signals can be operated when
Vehicles with smart key system
The “ENGINE START STOP” switch is in IGNITION ON mode.
Vehicles without smart key system
The engine switch is in the “ON” position.
■ If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
Right turn
Left turn
Move and hold the lever
partway to signal a lane
change.
The right hand signal will flash
until you release the lever.
Move and hold the lever
partway to signal a lane
change.
The left hand signal will flash
until you release the lever.

Maintenance and care4
485
VENZA_U (OM73013U)
4-1. Maintenance and careCleaning and protecting the vehicle exterior ......... 486
Cleaning and protecting the vehicle interior .......... 489
4-2. Maintenance Maintenance requirements .................. 492
General maintenance....... 495
Emission inspection and maintenance (I/M)
programs ........................ 498
4-3. Do-it-yourself maintenance Do-it-yourself service precautions .................... 499
Hood ................................ 503
Positioning a floor jack ..... 505
Engine compartment ........ 507
Tires ................................. 522
Tire inflation pressure ...... 529
Wheels ............................. 533
Air conditioning filter......... 536
Key battery ....................... 539
Checking and replacing fuses .............................. 543
Light bulbs........................ 553

552 4-3. Do-it-yourself maintenance
VENZA_U (OM73013U)
■After a fuse is replaced
● If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (P. 553)
● If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■ If there is an overload in the circuits
The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury.
● Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.
● Do not modify fuses or the fuse box.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer.

553
4-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_U (OM73013U)
Light bulbs
You may replace the following bulbs yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perfor m, contact your Toyota dealer.
For more information about replacing other light bulbs, contact your
Toyota dealer.
■ Prepare a replacement light bulb.
Check the wattage of the light bulb being replaced. ( P. 637)
■ Turn the power back door main switch off. (vehicles with
power back door)
P. 5 8
■ Front bulb locations
Headlight low beam
Headlight high beam and
daytime running lights
Front turn signal/parking light Front fog light
Front side marker light

554 4-3. Do-it-yourself maintenance
VENZA_U (OM73013U)
Replacing light bulbs■ Headlight low beams (halogen bulb)
Turn the bulb base counterclock-
wise.
■Rear bulb locations
Stop/tail and rear side
marker lights
Back-up light Tail light
License plate light
Rear turn signal light
STEP1

555
4-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_U (OM73013U)
Unplug the connector while
pushing the lock release.
Exchange the light bulb, and
install the light bulb.
Align the 3 tabs on the light bulb
with the mounting, and insert.
Turn and secure the bulb base.
After installing the light bulb, turn
the headlights on once and visu-
ally confirm that no light is leaking
through the mounting.
STEP2
STEP3
STEP4

556 4-3. Do-it-yourself maintenance
VENZA_U (OM73013U)■
Headlight high beams and daytime running lights
Unplug the connector while
pushing the lock release.
Turn the bulb base counterclock-
wise.
Exchange the light bulb, and
install the light bulb.
Align the 3 tabs on the light bulb
with the mounting, and insert.
STEP1
STEP2
STEP3

557
4-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_U (OM73013U)
Turn and secure the bulb base.
Install the connector.
After installing the light bulb, turn the headlights on once and visually
confirm that no light is leaking through the mounting.
STEP4
STEP5

558 4-3. Do-it-yourself maintenance
VENZA_U (OM73013U)■
Front fog lights (if equipped)
Remove the engine under cover
bolt and pull down the engine
under cover.
Turn the bulb base counterclock-
wise.
Unplug the connector while
pushing the lock release.
STEP1
STEP2
STEP3