tow TOYOTA VENZA HYBRID 2021 Owners Manual (in English)
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2021, Model line: VENZA HYBRID, Model: TOYOTA VENZA HYBRID 2021Pages: 68, PDF Size: 3.4 MB
Page 19 of 68
17
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
) " / % 4 ' 3 & & ' 6 / $ 5 * 0 / $ 0 / 5 * / 6 & %
Power tilt & telescopic steering wheel
Toggle the control switch to set angle and length.
NOTE: Do not attempt to adjust while the vehicle is in motion.
Power easy access system (if equipped): The steering wheel and driver’s seat
move in accordance with power switch mode and the driver’s seat belt condition.
Up
Control switch
Away from
the driverToward
the driver
DownAngleLength
Power windows
All window auto up/down
Push the switch completely down or pull it completely up and release to fully open
or close. To stop window partway, lightly push the switch in the opposite direction.
Window lock switch
Deactivates all passenger windows. Driver’s window remains operable.
Driver side
UpDown
Indicator
Window lock switch
To automatically open/close Power Liftgate Quickly swipe your foot near the
lower center part of the rear bumper for within 1 second to trigger sensor. To
operate, make sure that the touchless sensor operation is enabled, the vehicle is
OFF and that you are carrying the remote.
Press “
” or “ ” of the meter control switches and select “ 1 # %
w from
the “Vehicle Settings” in the “
” screen J O U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
U P
access hands-free settings. And push “
” to enter selection.
NOTE: Use the same gear and “
” icons from the HUD section.
For more details, refer to the Owner’s Manual.
Page 55 of 68
53
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
TEMPORARILY SWITCHING TO THE LOW BEAMS
Pull the lever toward you and then return it to its original position to switch to the
low beams temporarily.
The high beams are on while the lever is pulled toward you, however, after the lever
is returned to its original position, the low beams remain on for a certain amount of
time. Afterwards, the Automatic High Beams will be activated again.
NOTE: It is recommended to switch to the low beams when the high beams
may cause problems or distress to other drivers or pedestrians nearby.
Refer to the Toyota Owner’s Manual for additional information on AHB operation,
settings adjustments, limitations, and precautions before attempting to use it.
Road Sign Assist (RSA)
6 T J O H B O J O U F M M J H F O U D B N F S B
3 P B E 4 J H O " T T J T U 3 4 "
J T E F T J H O F E U P E F U F D U T Q F F E
limit signs, stop signs, do not enter signs and yield signs, and display them on the
. V M U J * O G P S N B U J P O % J T Q M B Z . * %
* All vehicle actions must be driver-initiated and are not automated. See Toyota.
com/safety-sense for model applicability.
Refer to the Toyota Owner’s Manual for a list of additional situations in which the
system operation may be limited.
RSA DISPLAY
When the driving support system
information is selected, a maximum of
3 signs can be displayed.When a tab other than the driving
support system information is selected,
the following types of road signs will be
displayed.
• Speed limit sign
t % P / P U & O U F S T J H O X I F O O P U J G J D B U J P O
J T O F D F T T B S Z
Page 58 of 68
56
Refer to the Owner’s Manual for tire changing and jack positioning procedures.
Spare tire & tools
TOOL LOCATION
REMOVING THE SPARE TIRE
(1) Pull the tab and open the deck board.
(3) Loosen the center fastener that secures
the spare tire.
(2) Take out the storage box.
SAFETY & EMERGENCY FEATURES
Spare tire
Jack handle
Wheel nut
wrench Towing eyelet
Jack