headlights TOYOTA VERSO 2012 User Guide

460 4-3. Do-it-yourself maintenance
VERSO_WE_OM64524E
When replacing the front headlight, front position light and front turn
signal light bulbs
Replacing the air cleaner duct and/or washer fluid filler opening.
Left side
Right side
Replacing the engine compartment cover. (P. 407)
Condensation build-up on the inside of the lens
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional, for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water are built up on the inside of the lens.
Water has built up inside the headlight.
Discharge headlights (if equipped)
If voltage to the discharge bulbs is insufficient, the bulbs may not come on,
or may go out temporarily. The discharge bulbs will come on when normal
power is restored.
After replacing the bulbs, make sure to
secure the upper part of the air cleaner
duct with the clip.
After replacing the bulbs, make sure to
secure the washer fluid filler opening with
the clip.

461 4-3. Do-it-yourself maintenance
4
Maintenance and care
VERSO_WE_OM64524E
LED light bulbs
The stop lights and high mounted stoplight consist of a number of LEDs. If
any of the LEDs burn out, take your vehicle to any authorized Toyota dealer
or repairer, or another duly qualified and equipped professional to have the
light replaced.
If two or more LEDs in a stop light burn out, your vehicle may not conform to
local laws (ECE).
CAUTION
Replacing light bulbs
Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. Hold the
bulb by the plastic or metal portion.
If the bulb is scratched or dropped it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failing to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
Discharge headlights (if equipped)
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional, before replacing the discharge headlights
(including light bulbs).
Do not touch the high-intensity discharge headlight’s high voltage socket
when the headlights are turned on.
An extremely high voltage of 20000V will be discharged and could result in
serious injury or death by electric shock.
Do not attempt to repair or disassemble light bulbs, connectors, electric
circuits or component parts.
Doing so may result in death or serious injury due to electric shock.
To prevent damage or fire
Make sure bulbs are fully seated and locked.

5
519
5-2. Steps to take in an emergency
When trouble arises
VERSO_WE_OM64524E
If the engine will not start
If the engine still does not start after following the correct starting
procedure (P. 186, 190) or releasing the steering lock (P. 188,
193), confirm the following points.
The engine will not start even if you are carrying the correct
key
One of the following may be the cause of the problem.
There may not be sufficient fuel in the vehicle’s tank.
Gasoline engine: Refuel the vehicle.
Diesel engine: (P. 535)
The engine may be flooded. (gasoline engine)
Try to restart the engine once more following correct starting
procedures. (P. 186, 190)
There may be a malfunction in the engine immobilizer system.
(P. 112)
The starter motor turns over slowly, the personal/interior
lights and headlights are dim, or the horn does not sound or
sounds at a low volume
One of the following may be the cause of the problem.
The battery may be discharged. (P. 528)
The battery terminal connections may be loose or corroded.
The starter motor does not turn over (vehicles with smart
entry & start system)
The engine starting system may be malfunctioning due to an
electrical problem such as an open circuit or a blown fuse. How-
ever, an interim measure is available to start the engine.
(P. 520)

520 5-2. Steps to take in an emergency
VERSO_WE_OM64524E
Emergency start function (vehicles with smart entry & start system)
When the engine does not start, the following steps can be used as
an interim measure to start the engine if the “ENGINE START STOP”
switch is functioning normally.
Vehicles with a Multidrive or an automatic transmission
Set the parking brake.
Put the shift lever in “P”.
Set the “ENGINE START STOP” switch to the ACCESSORY
mode.
Press and hold the “ENGINE START STOP” switch about 15
seconds while depressing the brake pedal firmly.
The starter motor does not turn over, the personal/interior
lights and headlights do not turn on, or the horn does not
sound
One of the following may be the cause of the problem.
One or both of the battery terminals may be disconnected.
The battery may be discharged. (P. 528)
There may be a malfunction in the steering lock system. (vehi-
cles with smart entry & start system)
Contact any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional, if the problem cannot be
repaired, or if repair procedures are unknown.

5
529 5-2. Steps to take in an emergency
When trouble arises
VERSO_WE_OM64524E
Starting the engine when the battery is discharged (vehicles with a
Multidrive or an automatic transmission)
The engine cannot be started by push-starting.
Avoiding a discharged battery
Turn off the headlights and the audio system while the engine is turned
off.
Turn off any unnecessary electrical components when the vehicle is run-
ning at a low speed for an extended period, such as in heavy traffic, etc.
Charging the battery
The electricity stored in the battery will discharge gradually even when the
vehicle is not in use, due to natural discharge and the draining effects of cer-
tain electrical appliances. If the vehicle is left for a long time, the battery may
discharge, and the engine may be unable to start. (The battery recharges
automatically during driving.)
Vehicles without smart entry & start system: Maintain the
engine speed of the second vehicle and turn the engine
switch to the “ON” position, then start the vehicle’s engine.
Vehicles with smart entry & start system: Maintain the
engine speed of the second vehicle and turn the “ENGINE
START STOP” switch to IGNITION ON mode, then start the
vehicle’s engine.
Once the vehicle’s engine has started, remove the jumper
cables in the exact reverse order in which they were con-
nected.
Once the engine starts, have the vehicle checked at any autho-
rized Toyota dealer or repairer, or another duly qualified and
equipped professional, as soon as possible.

563 6-1. Specifications
6
Vehicle specifications
VERSO_WE_OM64524E
Light bulbs
A: H11 halogen bulbs B: D4R discharge bulbs
C: HB3 halogen bulbs D: Wedge base bulbs (amber)
E: Wedge base bulbs (clear) F: Single end bulbs (amber)
G: Single end bulbs (clear) H: Double end bulbs
Light BulbsWTy p e
ExteriorHeadlights
Low beam (Halogen bulbs)
Low beam (Discharge bulbs)
High beam55
35
60A
B
C
Front fog lights (if equipped) 55 A
Front position lights 5 E
Front turn signal lights 21 F
Rear turn signal lights 21 F
Tail lights 5 G
Back-up lights 21 G
Rear fog lights 21 G
License plate lights 5 E
Side turn signal lights 5 D
InteriorPersonal/interior lights 5 E
Personal lights 8 E
Vanity lights 8 E
Door courtesy lights 5 E
Luggage compartment light 5 H

579 Alphabetical index
VERSO_WE_OM64524E
Gas station information .......... 588
Gauges...................................... 217
Glove box ................................. 353
Glove box light ......................... 353
Hazard lights switch ................ 464
Head restraints
Adjusting ................................. 86
Headlight cleaner ..................... 249
Headlights
Discharged headlights
precautions ......................... 461
Replacing light bulbs ............. 450
Switch ................................... 239
Wattage................................. 563
Heaters
Seat heaters.......................... 368
Side mirror ............................ 306
Hill-start assist control ............ 273
Hood.......................................... 401
Hooks
Cargo hook ........................... 379
Horn .......................................... 216
Identification
Engine ................................... 545
Vehicle .................................. 544
Ignition
Engine switch ................ 186, 190
Keys ........................................ 38
Ignition switch ............... 186, 190
Ignition switch.................. 186, 190
Ignition switch light ................. 349
Illuminated entry system......... 349
Immobilizer system ................. 112
Indicator lights ......................... 222Initialization
Items to initialize ................... 572
Inside rear view mirror .............. 97
Instrument cluster light
control .................................... 220
Intercooler ................................ 415
Intrusion sensor ...................... 124
Interior lights
Interior lights ......................... 351
Switch ................................... 350
Wattage ................................ 563
Jack
Positioning a floor jack .......... 403
Replacing the wheel ............. 490
Vehicle-equipped
jack ............................. 490, 506
Jack handle ...................... 490, 506
Keyless entry ....................... 41, 58
Keys
Electronic key ......................... 38
Engine switch................ 186, 190
If you lose your keys ............. 523
If the electronic key does not
operate properly ................. 525
If your key battery does
not operate properly ........... 432
Ignition switch ............... 186, 190
Key number plate.................... 38
Keyless entry .................... 41, 58
Keys ........................................ 38
Mechanical key ....................... 38
Wireless remote control key ... 58
Knee airbag .............................. 133G
H
I
J
K