headlights TOYOTA xD 2014 Owners Manual (in English)

6
Scion_xD_OM_OM52E36U_(U)
Windshield wipers P. 153
Pictorial indexExterior
Outside rear viewmirrors
P. 61
Side turn signal lights P. 138
Front side marker lights P. 150
Parking lights P. 150
Hood P. 233
Front turn signal lights P. 138
Headlights P. 150
Daytime running lights P. 152

60
1-3. Adjustable components (seats, mirrors, steering wheel)
Scion_xD_OM_OM52E36U_(U)
Anti-glare inside rear view mirror
Adjusting the height of rear view mirrorAdjust the height of the rear view
mirror by moving it up and down.
Glare from the headlights of vehicles behind can be reduced by
using the following functions:
Normal position
Anti-glare position
CAUTION
■Caution while driving
Do not adjust the position of the mirror while driving.
Doing so may lead to mishandling of the vehicle and cause an accident,
resulting in death or serious injury.

150
Scion_xD_OM_OM52E36U_(U)
2-3. Operating the lights and Windshield wipers
Headlight switch
The headlights can be operated manually.
Turning the end of the lever turns on the lights as follows:
Ty p e AThe side marker,
parking, tail, license
plate and instrument
panel lights turn on.
Vehicles with day-
time running light
system:
The daytime running
light turn on.
The headlights and
all lights listed above
turn on.
U.S.A. Canada

151
2-3. Operating the lights and Windshield wipers
2
When driving
Scion_xD_OM_OM52E36U_(U)
Ty p e B
The side marker,
parking, tail, license
plate and instrument
panel lights turn on.
Vehicles with day-
time running light
system:
The daytime running
light turn on.
The headlights and
all lights listed above
turn on.
U.S.A. Canada

152 2-3. Operating the lights and Windshield wipers
Scion_xD_OM_OM52E36U_(U)
Turning on the high beam headlightsWith the headlights on, push
the lever away from you to
turn on the high beams.
Pull the lever toward you to the
center position to turn the high
beams off.
Pull the lever toward you and
release it to flash the high
beams once.
You can flash the high beams
with the headlights on or off.
■Daytime running light system (if equipped)
●To make your vehicle more visible to other drivers, the headlights turn on
automatically (at a reduced intensity) whenever the engine is started and
the parking brake is released. Daytime running lights are not designed for
use at night.
● Compared to turning on the headlights, the daytime running light system
offers greater durability and consumes less electricity, so it can help
improve fuel economy.
■ Light reminder buzzer
A buzzer sounds when the driver’s door is opened with the key removed
from the engine switch while the lights are turned on.
NOTICE
■To prevent battery discharge
Do not leave the lights on longer than necessary when the engine is not run-
ning.

286 4-3. Do-it-yourself maintenance
Scion_xD_OM_OM52E36U_(U)
Replacing light bulbs■ Headlights and daytime running lights (for Canada)
Unplug the connector and
remove the rubber cover.
Release the bulb retaining
spring.
Remove the bulb.
To install a new bulb, align the
tabs of the bulb with the cutouts
of the mounting hole.
STEP 1
STEP 2
STEP 3

292 4-3. Do-it-yourself maintenance
Scion_xD_OM_OM52E36U_(U)
■LED light bulbs
The side turn signal lights and high mounted stoplight consist of a number of
LEDs. If any of the LEDs burn out, take your vehicle to your Scion dealer to
have the light replaced.
■ Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction. Contact your Scion dealer for more information in
the following situations:
● Large drops of water have built up on the inside of the lens.
● Water has built up inside the headlight.
CAUTION
■Replacing light bulbs
●Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
● Do not touch the glass portion of the light bulb with bare hands. When i\
t is
unavoidable to hold the glass portion, use and hold with a clean dry cloth
to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
● Fully install light bulbs and any parts used to secure them. Failing to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
● Do not attempt to repair or disassemble light bulbs, connectors, electric
circuits or component parts.
Doing so may result in death or serious injury due to electric shock.
■ To prevent damage or fire
Make sure bulbs are fully seated and locked.

332
5-2. Steps to take in an emergency
Scion_xD_OM_OM52E36U_(U)
If the engine will not star t
If the engine will not start even though correct starting procedures
are being followed ( P. 130), consider each of the following points:
■The engine will not start even though the starter motor
operates normally.
One of the following may be the cause of the problem:
●There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
● The engine may be flooded.
Try to restart the engine again following correct starting proce-
dures. ( P. 130)
● Vehicles with engine immobilizer system: There may be a
malfunction in the engine immobilizer system. (P. 6 9 )
■ The starter motor turns over slowly, the interior lights and
headlights are dim, or the horn does not sound or sounds at
a low volume.
One of the following may be the cause of the problem:
●The battery may be discharged. ( P. 336)
● The battery terminal connec tions may be loose or corroded.
■ The starter motor does not turn over, the interior lights and
headlights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem:
● One or both of the battery terminals may be disconnected.
● The battery may be discharged. ( P. 336)
Contact your Scion dealer if the problem cannot be repaired, or if
repair procedures are unknown.

338 5-2. Steps to take in an emergency
Scion_xD_OM_OM52E36U_(U)
■Starting the engine when the battery is discharged
Vehicles with an automatic transmission, the engine cannot be started by
push-starting.
■ To prevent battery discharge
●Turn off the headlights and the air conditioning system while the engine is
turned off.
● Turn off any unnecessary electrical components when the vehicle is run-
ning at a low speed for an extended period, such as in heavy traffic.
Maintain the engine speed of the second vehicle and start
the engine of your vehicle by turning the engine switch to
the “ON” position.
Once the vehicle’s engine has started, remove the jumper
cables in the exact reverse or der from which they were con-
nected.
Reinstall the service cover as
shown in the illustration.
Reinstall the engine cover: Conduct the removal procedure
in reverse. After installing, ch eck that the clips are inserted
securely.
Once the engine starts, have the vehicle inspected at your Scion
dealer as soon as possible.STEP 5
STEP 6
STEP7
STEP8

360 6-1. Specifications
Scion_xD_OM_OM52E36U_(U)
Light bulbs
A: H2 halogen bulbsB: Wedge base bulbs (clear)
C: Wedge base bulbs (amber) D: Double end bulbs
Light BulbsBulb No.WTy p e
Exterior Headlights
60/55 A
Front turn signal lights 7440 21 B
Parking lights 5B
Front side marker
lights 
5B
Rear turn signal lights 7440 21 C
Stop/tail lights and
rear side marker lights 7443 21/5 B
Back-up lights 921 16 B
Licence plate lights 5B
Interior Personal lights
8D
Interior lights 8D
Luggage
compartment light 
5D