ignition VAUXHALL CASCADA 2017.5 Manual PDF
[x] Cancel search | Manufacturer: VAUXHALL, Model Year: 2017.5, Model line: CASCADA, Model: VAUXHALL CASCADA 2017.5Pages: 263, PDF Size: 7.71 MB
Page 216 of 263

214Vehicle care9Warning
If the pressure is too low, this can
result in considerable tyre warm-
up and internal damage, leading to tread separation and even to tyre
blow-out at high speeds.
9 Warning
For specific tyres the
recommended tyre pressure as
shown in the tyre pressure table may exceed the maximum tyre
pressure as indicated on the tyre.
Never exceed the maximum tyre
pressure as indicated on the tyre.
If the tyre pressure must be reduced
or increased on a vehicle with tyre
pressure monitoring system, switch
off ignition. After adjusting tyre
pressure switch on ignition and select
the relevant setting on the page Tyre
load in the Driver Information Centre
3 93.
Temperature dependency
The tyre pressure depends on thetemperature of the tyre. During
driving, tyre temperature and
pressure increase. Tyre pressure
values provided on the tyre
information label and tyre pressure
chart are valid for cold tyres, which
means at 20 °C.
The pressure increases by nearly
1.5 psi for a 10 °C temperature
increase. This must be considered
when warm tyres are checked.
The tyre pressure value displayed in
the Driver Information Centre shows
the actual tyre inflation pressure. A
cooled down tyre will show a
decreased value, which does not
indicate an air leak.
Tread depth Check tread depth at regular
intervals.
Tyres should be replaced for safety
reasons at a tread depth of 2-3 mm
(4 mm for winter tyres).For safety reasons it is recommended
that the tread depth of the tyres on
one axle should not vary by more than 2 mm.
The legally permissible minimum
tread depth (1.6 mm) has been
reached when the tread has worn
down as far as one of the tread wear
indicators (TWI). Their position is
indicated by markings on the
sidewall.
If there is more wear at the front than
the rear, swap round front wheels and rear wheels periodically. Ensure that
the direction of rotation of the wheels
is the same as before.
Page 229 of 263

Vehicle care227
Screw in the towing eye anticlockwise
as far as it will go until it stops in a
horizontal position.
Attach a tow rope – or better still a tow
rod – to the towing eye.
The towing eye must only be used for
towing and not for recovering the
vehicle.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wiper.
Transmission in neutral.
Caution
Drive slowly. Do not drive jerkily.
Excessive tractive force can
damage the vehicle.
When the engine is not running,
considerably more force is needed to
brake and steer.
To prevent the entry of exhaust gases from the towing vehicle, switch on the
air recirculation and close the
windows, when soft top is closed.
Vehicles with automatic transmission: The vehicle must be towed facing
forwards, not faster than 50 mph nor further than 60 miles. In all other
cases and when the transmission is
defective, the front axle must be
raised off the ground.
Seek the assistance of a workshop. After towing, unscrew the towing eye
clockwise.
Insert cap at the top and engage
downwards.
Towing another vehicle
Insert a screwdriver in the slot at the
lower bend of the cap. Release the
cap by carefully moving the
screwdriver downwards.
The towing eye is stowed with the
vehicle tools 3 208.
Page 256 of 263

254Customer informationenables the workshop to offer you
efficient maintenance and repair, tailored to your individual vehicle,
each time you bring it back to the
workshop.
The manufacturer will not access driver's behaviour related information
about a crash event or share it with
others except:
● with the consent of the vehicle owner or, if the vehicle is leased,
of the lessee
● in response to an official request of police or similar government
office
● as part of the manufacturer's defense in case of legal
proceedings
● as required by lawIn addition, the manufacturer may use
the collected or received diagnostic
data:
● for the manufacturer's research needs
● to make it available for research needs where appropriate
confidentiality is maintained and
need is shown
● to share summary data which is not tied to a specific vehicle with
other organisations for research
purposesRadio Frequency
Identification (RFID)
RFID technology is used in some vehicles for functions such as tyre
pressure monitoring and ignition
system security. It is also used in
connection with conveniences such
as radio remote controls for door
locking/unlocking and starting, and in-
vehicle transmitters for garage door
openers. RFID technology in
Vauxhall vehicles does not use or
record personal information or link
with any other Vauxhall system
containing personal information.
Page 260 of 263

258Headlight flash ........................... 113
Headlight range adjustment ......113
Headlights................................... 110 Headlights when driving abroad 113
Head restraint adjustment .............8
Head restraints ............................ 45
Heated mirrors ............................. 30
Heated rear window ..................... 34
Heated steering wheel .................77
Heating ........................................ 53
Heating and ventilation system . 123
High beam ........................... 92, 112
High beam assist ..................92, 112
Hill start assist ........................... 151
Horn ....................................... 13, 78
I Identification plate .....................235
Ignition switch positions .............135
Immobiliser ............................ 28, 92
Indicators ...................................... 83
Information displays...................... 93
Instrument cluster ........................83
Instrument panel fuse box .........205
Instrument panel illumination .....202
Instrument panel illumination control .................................... 119
Instrument panel overview ........... 10
Interactive driving system ...........153
Interior care ............................... 230Interior lighting............................ 119
Interior lights ...................... 120, 202
Interior mirrors .............................. 30
Interruption of power supply ......147
Introduction .................................... 3
ISOFIX child restraint systems ....67
J Jump starting ............................. 225
K Key, memorised settings ..............21
Keys ............................................. 19
Keys, locks ................................... 19
L
Lane departure warning .......90, 175
Lashing eyes ............................... 74
Light switch ................................ 110
Load compartment ................24, 71
Load compartment fuse box ......206
Loading information .....................75
Low fuel ....................................... 92
M
Malfunction indicator light ............88
Manual anti-dazzle ......................30
Manual mode ............................. 146
Manual seat adjustment ...............48
Manual transmission .................. 148
Memorised settings ......................21Mirror adjustment ........................... 8
Misted light covers .....................119
N
New vehicle running-in ..............135
Number plate light .....................201
O Object detection systems ...........161
Odometer ..................................... 83
Oil, engine .......................... 233, 237
OnStar ........................................ 105
Operate pedal ............................... 88
Outside temperature ....................79
Overrun cut-off ........................... 136
P Parking ................................ 17, 138
Parking assist ............................ 161
Parking brake ............................ 149
Parking lights ............................. 119
Particulate filter ........................... 140
Performance .............................. 241
Performing work ........................188
Pollen filter ................................. 131
Power outlets ............................... 81
Power seat adjustment ................51
Power steering.............................. 90
Power windows ............................ 31
Preheating ................................... 90
Puncture ..................................... 219