low beam VAUXHALL CROSSLAND X 2018.5 User Guide

192Vehicle careWiper blade replacementWindscreen
Lift the wiper arm until it stays in the
raised position, press button to
disengage the wiper blade and
remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
Rear window
Lift wiper arm. Disengage wiper blade as shown in illustration and remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
Bulb replacement
Switch off the ignition and switch off
the relevant switch or close the doors.
Only hold a new bulb at the base. Do not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Replace headlight bulbs from within
the engine compartment.
Bulb check
After a bulb replacement switch on
the ignition, operate and check the
lights.
Halogen headlights Halogen headlights with separate
housings for low beam and high
beam/turn light.

Vehicle care193
High beam, turn light (1)
Low beam ( 2)
High beam
1. Rotate the cap (1) anticlockwise and remove it.
2. Withdraw the upper bulb holderfrom the reflector housing.
3. Remove the bulb from the plugconnector by pulling.
4. Replace the bulb and connect it to
the plug connector.
5. Insert and push the bulb holder into the reflector housing by
setting the lug into position.
6. Fit the cap and rotate clockwise.
Turn light
1. Rotate the cap (1) anticlockwise and remove it.

194Vehicle care
2. Rotate the lower bulb holderanticlockwise to disengage.
Withdraw the bulb holder from the
reflector housing.
3. Press latch and remove the bulb from the bulb holder.
4. Replace the bulb and attach it to the bulb holder.
5. Insert the bulb holder into the reflector housing and rotate
clockwise.
6. Fit the cap and rotate clockwise.
Low beam
1. Rotate the cap (2) anticlockwise and remove it.
2.Lift the retainer, then pull the plug
connector backwards.
3. Fold down the retainer and remove the bulb from the reflectorhousing.

Vehicle care1954. Replace the bulb and push it intothe reflector housing by setting
the lug into position.
5. Fold up the retainer and hold in position.
6. Attach the plug connector to the bulb and fix it with the retainer.
7. Fit the cap and rotate clockwise.
Sidelight/Daytime running light In case of defective LEDs, have them
replaced by a workshop.
LED headlights
Headlights for low and high beam,
sidelights, daytime running lights and turn lights are designed as LEDs and
can not be changed.
Have lights repaired by a workshop in
case of failure.
Fog lights
The bulbs are accessible from the
underside of the vehicle.
1. Turn the bulb holder anti- clockwise and remove it from the
reflector housing.
2. Disengage the bulb socket from the plug connector by pressing
the retaining lug.
3. Remove and replace the bulb socket with bulb and attach the
plug connector.
4. Insert the bulb socket into the reflector housing by turning
clockwise and engage.
Tail lights
Depending on version, tail lights and
brake lights are designed as LEDs. In case of failure, have LEDs replaced
by a workshop.

254Headlights................................... 108Head restraint adjustment .............8
Head restraints ............................ 41
Head-up display............................ 97 Heated mirrors ............................. 34
Heated rear window ..................... 37
Heated steering wheel .................72
Heated windscreen .......................38
Heating ........................................ 45
Heating and ventilation system . 117
High beam ........................... 92, 109
High beam assist ..........................92
Hill start assist ........................... 147
Horn ....................................... 13, 73
I
Identification plate .....................229
Ignition switch positions .............130
Immobiliser .................................. 33
Indicators ...................................... 83
Inductive charging ........................77
Info Display ................................... 96
Instrument cluster ........................79
Instrument panel fuse box .........202
Instrument panel illumination .....200
Instrument panel illumination control .................................... 114
Instrument panel overview ........... 10
Interior care ............................... 223
Interior lighting ............................ 114Interior lights ...................... 114, 200
Interior mirrors .............................. 35
Interruption of power supply ......144
Introduction .................................... 3
J Jump starting ............................. 218
K Keys ............................................. 20
Keys, locks ................................... 20
L
Lane departure warning .......90, 173
Lashing eyes ............................... 67
LED headlights ........................... 195
Lighting features .........................115
Light switch ................................ 108
Load compartment ................29, 63
Load compartment cover .............66
Loading information .....................69
Low beam ..................................... 92
Low fuel ....................................... 92
LPG ...................................... 84, 176
M Malfunction indicator light ............89
Manual anti-dazzle ......................35
Manual mode ............................. 143
Manual transmission .................. 145Mirror adjustment ........................... 9
Misted light covers .....................113
N New vehicle running-in ..............130
Number plate light .....................200
O Object detection systems ...........159
Odometer ..................................... 83 Oil, engine .......................... 227, 231
OnStar ........................................ 104
Outside temperature ....................75
Overrun cut-off ........................... 135
P Panoramic view system ..............169
Parking ................................ 18, 137
Parking assist ............................ 159
Parking brake ............................ 147
Parking lights ............................. 113
Particulate filter ........................... 138
Performance .............................. 236
Performing work ........................187
Power button .............................. 131
Power outlets ............................... 76
Power saving mode ....................132
Power windows ............................ 36
Preheating ................................... 91
Puncture ..................................... 214