ignition VAUXHALL CROSSLAND X 2018.5 Repair Manual

192Vehicle careWiper blade replacementWindscreen
Lift the wiper arm until it stays in the
raised position, press button to
disengage the wiper blade and
remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
Rear window
Lift wiper arm. Disengage wiper blade as shown in illustration and remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
Bulb replacement
Switch off the ignition and switch off
the relevant switch or close the doors.
Only hold a new bulb at the base. Do not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Replace headlight bulbs from within
the engine compartment.
Bulb check
After a bulb replacement switch on
the ignition, operate and check the
lights.
Halogen headlights Halogen headlights with separate
housings for low beam and high
beam/turn light.

200Vehicle care4. Insert bulb holder and turnclockwise.
5. Insert left end of the lamp, slide to
the left and insert right end.
Number plate light
The number plate light is designed as
LEDs and can not be changed. In
case of defective LEDs, have them
replaced by a workshop.
Interior lights
Courtesy light, reading lights
Have bulbs replaced by a workshop.
Load compartment light
Have bulbs replaced by a workshop.
Instrument panel illumination
Have bulbs replaced by a workshop.Electrical system
Fuses Data on the replacement fuse must
match the data on the defective fuse.
There are three fuse boxes in the
vehicle:
● engine compartment
● instrument panel
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognised by its melted wire.Caution
Do not replace the fuse until the
cause of the fault has been
remedied.
Some functions are protected by
several fuses.
Fuses may also be inserted without
existence of a function.
Fuse extractor
A fuse extractor may be located in the
fuse box in the engine compartment.

220Vehicle care
Screw in the towing eye as far as it will
go until it stops in a horizontal
position.
Attach a tow rope – or better still a tow
rod – to the towing eye.
The towing eye must only be used for towing and not for recovering the
vehicle.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wiper.
Switch the selector lever to neutral.
Release the parking brake.
Caution
Drive slowly. Do not drive jerkily.
Excessive tractive force can
damage the vehicle.
When the engine is not running,
considerably more force is needed to
brake and steer.
To prevent the entry of exhaust gases from the towing vehicle, switch on the
air recirculation and close the
windows.
Vehicles with automatic transmission: The vehicle must be towed facing
forwards, not faster than 50 mph nor further than 60 miles. In all other
cases and when the transmission is
defective, the front axle must be
raised off the ground.
Seek the assistance of a workshop. After towing, unscrew the towing eye.
Insert cap with the outer flange into
the recess and fix cap by pushing.
Towing another vehicle
Wrap a cloth around the tip of a flat
screwdriver to prevent paint damage. Insert a screwdriver in the slot at the
bottom of the cap. Release the cap by carefully moving the screwdriver
downwards.
The towing eye is stowed with the vehicle tools 3 205.

Customer information251processing and use of personal data
for the purposes of preparation of services take place solely on the
basis of legal permission, e.g. in the
case of the eCall emergency
communication system or a
contractual agreement, or by virtue of
consent.
You can activate or deactivate the
services and functions (which are
subject to charges to some extent)
and, in some cases, the vehicle's
entire radio network connection. In
particular, this does not include
statutory functions and services such
as eCall.
Third party services
If you make use of online services
from other providers (third parties),
these services are subject to the
liability and data protection and usage conditions of the provider in question.
The manufacturer frequently has no
influence over the content exchanged
in this regard.Therefore, please note the nature,
scope and purpose of the collection
and use of personal data within the
scope of third party services provided by the service provider in question.
Radio Frequency Identification (RFID)
RFID technology is used in somevehicles for functions such as tyre
pressure monitoring and ignition
system security. It is also used in
connection with conveniences such
as radio remote controls for door
locking / unlocking and starting, and
in-vehicle transmitters for garage
door openers. RFID technology in
Vauxhall vehicles does not use or
record personal information or link
with any other Vauxhall system
containing personal information.

254Headlights................................... 108Head restraint adjustment .............8
Head restraints ............................ 41
Head-up display............................ 97 Heated mirrors ............................. 34
Heated rear window ..................... 37
Heated steering wheel .................72
Heated windscreen .......................38
Heating ........................................ 45
Heating and ventilation system . 117
High beam ........................... 92, 109
High beam assist ..........................92
Hill start assist ........................... 147
Horn ....................................... 13, 73
I
Identification plate .....................229
Ignition switch positions .............130
Immobiliser .................................. 33
Indicators ...................................... 83
Inductive charging ........................77
Info Display ................................... 96
Instrument cluster ........................79
Instrument panel fuse box .........202
Instrument panel illumination .....200
Instrument panel illumination control .................................... 114
Instrument panel overview ........... 10
Interior care ............................... 223
Interior lighting ............................ 114Interior lights ...................... 114, 200
Interior mirrors .............................. 35
Interruption of power supply ......144
Introduction .................................... 3
J Jump starting ............................. 218
K Keys ............................................. 20
Keys, locks ................................... 20
L
Lane departure warning .......90, 173
Lashing eyes ............................... 67
LED headlights ........................... 195
Lighting features .........................115
Light switch ................................ 108
Load compartment ................29, 63
Load compartment cover .............66
Loading information .....................69
Low beam ..................................... 92
Low fuel ....................................... 92
LPG ...................................... 84, 176
M Malfunction indicator light ............89
Manual anti-dazzle ......................35
Manual mode ............................. 143
Manual transmission .................. 145Mirror adjustment ........................... 9
Misted light covers .....................113
N New vehicle running-in ..............130
Number plate light .....................200
O Object detection systems ...........159
Odometer ..................................... 83 Oil, engine .......................... 227, 231
OnStar ........................................ 104
Outside temperature ....................75
Overrun cut-off ........................... 135
P Panoramic view system ..............169
Parking ................................ 18, 137
Parking assist ............................ 159
Parking brake ............................ 147
Parking lights ............................. 113
Particulate filter ........................... 138
Performance .............................. 236
Performing work ........................187
Power button .............................. 131
Power outlets ............................... 76
Power saving mode ....................132
Power windows ............................ 36
Preheating ................................... 91
Puncture ..................................... 214