warning VOLKSWAGEN GOLF 1995 Owner's Manual
[x] Cancel search | Manufacturer: VOLKSWAGEN, Model Year: 1995, Model line: GOLF, Model: VOLKSWAGEN GOLF 1995Pages: 274, PDF Size: 28.67 MB
Page 136 of 274

B31-113C
Engine oil iden tifica tion symbol
symbol
( A). The starburst symbol indicates that the
oil has been certifjed by the American Petro
leum
Another oil identificatio n symbo l (B ) could be added to th e oil con taine r to help you se
lect the correct oil.
1 The top portion indicate s the oil q uality
by designations.
2
The center portion sh ows the oil
viscosity grade.
3
The lowe r portion indica tes that the oil
has fuel saving capabili ties. No
te
is normal for your engine to consume oil.
The rate of the oil consumption depends on
the quality
and viscosity of oil, the speed at
which the engine operated, the climate, road
conditio ns
as well as amount of dilution an d
oxidatio n of the lubricant.
Beca u
se of these variables, no standard
rate of oil consumption can be established ,
but drivers should expect an increased oil
consum ption at high speeds and when the
engine is
new.
The engine in your vehicle depends
on oil to lubricate and cool all of its ing parts. Therefore the engine oil should be checked regularly and kept at the required level.
Make it a habit to have the engine oil lev el checked with every fuel filling.
Lack of sufficient engine oil may lead
to severe engine damage .
The oil pressure warning
Page 143 of 274

Brake fluid
The brake fluid reservo ir is located in the en
gi ne compa rtment o n th e left side .
136
----------------
Checking
The correct fluid level is importa nt for the
proper functioning of the brake system. The
fluid level
in the brake fluid reservoir should
always be between the and markings.
The fluid level may drop slightly
some
time due to the automatic adjustment of the
brake pads. This is no cause for alarm.
mark , the brake warning light come o n. Do not continue to operate the
v ehicle . The comp le te brake system shou ld
be thoroughly checked by an authoriz ed
Volk sw age n dea l
er or any other qualified
workshop and the cause corr ecte d.
The brake warning lamp lights up
to indicate
a low fluid leve l in the reservoir.
Use only 4 brake fluid that meets SAE specification J and conforms to Federal Motor Vehicle
Standard 116.
The brake
fluid must be new .
Do not add or mix
Brake fluid is poisonous. Therefore , it must only be stored in the closed original container out of the reach of children.
J
Page 157 of 274

CARE
Exceeding the maximum speed for which tires are rated and approved
Always observe speed limits and adjust your vehicle to prevailing road and traffic conditions.
The manufacturing date is also to be seen on the tire wall (poss ibly only on the inside of
t h e wheel):
WARNING
ing based on the wear rate of the tire when
tested on a government test course. Fo r
T he relat ive performance of tires pends on actual conditions of use, however ,
and may depart significantly fr om the norm
due to variat ions in driving habits , service
p ractices and differences in road
The tr act ion grades , fr om highest to lowest ,
are A, B and C and represent the tire 's ability
t o s top on wet pavement as measured on
gove
rnment test surfaces of asphal t and
concrete . A tire marked C may have poor
tract ion perfo rmance.
The traction grade is based
on braking
( straight ahead) tract ion tests and does not
include cornering (turn ing) traction.
Temperatur e A, B ,
The temperature grades A (the highest), B
and C, represent the tire's resistance to the
gene ration of heat. Sustained high
ty Standard No. 1
quired by law.
Always heed on next
p age .
Page 166 of 274

Changing a wheel
you have a
on and use other warning devices to other motorists.
Passengers must not remain in the
away from the and away from the roadway and
traffic.
Before you change a be sure the ground is
After make sure that you remount the tire in its storage area and tighten the nut
To from moving set the parking brake and
being changed. When one front is
transmission not prevent movement.
YOURSELF
Remove the
Remove the center cover using the wrench and the hub cap of your hub cap , the
wrench through the and pry the
cover off. have
covers which you can pry off using the