disconnect VOLKSWAGEN ID.4 2022 Owners Manual

The yellow indicator lamp flashes if a pos-
sible critical situation is detected when you
indicate in the direction of the detected v
ehi-
cle.
The faster another vehicle approaches, the
earlier there is a corresponding display in the
exterior mirror.
Lane change system “Side Assist Plus”
If the vehicle is equipped with a lane keeping
system (Lane Assist) and the system is
switched on, the driver is warned by a correc-
tive steering intervention when changing
lanes during a possible critical situation (in-
formation level, warning level). The steering
intervention also occurs when the turn signal
is activated for the corresponding direction. If
the steering intervention is overridden by the
driver, the steering wheel vibrates to give an
additional warning. For this, steering wheel
vibration must be activated in the Assist sys-
tems menu in the Infotainment system.
Automatic deactivation
The lane change system will switch off auto-
matically if the radar sensors are permanent-
ly covered. This can be caused by a layer of
ice or snow in front of the radar sensor, for
example.
A text message will be shown on the instru-
ment cluster display.
If you use the factory-fitted trailer towing
coupling and have set up the necessary elec-
trical connection, the lane change system
switches off automatically. After you have
disconnected the electrical connection, the
lane change system is switched back on au-
tomatically.
If the trailer towing coupling is not factory-
fitted, you must manually switch off the lane
change system and then switch it back on
again.
Brightness
The brightness of the visual display will
change automatically depending on the am-
bient light levels. You can adjust the basic brightness of the
display in the Assist systems menu in the In-
f
otainment system. The lane change system
is not active during the setting procedure. Troubleshooting
Please refer to at the start of the chap-
ter on page 172. Lane change system fault.
The indicator lamp lights up yellow. The yel-
low central warning lamp also lights up.

WARNING
Improper use of the sockets and electrical
accessories can cause fires and se vere inju-
ries.
x Never leave children unsupervised in the
vehicle. Sockets and the devices connec-
ted to them can be used when the igni-
tion is switched on.
x If the electrical device gets too hot,
switch off the device immediately and
disconnect it from the socket. NOTICE
x In order to pre
vent damage to the electri-
cal system, never connect equipment that
supplies electric power, such as solar pan-
els or battery chargers for charging the
12-volt battery, to the 12-volt socket.
x Use only electrical devices that have been
approved in accordance with current
guidelines concerning electromagnetic
compatibility.
x In order to avoid damage due to voltage
fluctuations, always switch off any electri-
cal devices before switching the ignition
on or off and before activating the vehi-
cle

Cable and wireless con-
nections
Introduction to the topic
Some e xternal devices can be connected to
the Infotainment system by cable and wire-
less connections present in the vehicle (if in-
stalled).
The type and number of cable and wireless
connections differ according to country and
vehicle. The connections may also be differ-
ent within a model series or in special-edition
models.
In the case of cable connections, use only the
original device connecting cables or, if availa-
ble, the factory-supplied connecting cables
for your vehicle.
If the plug on the connecting cable cannot be
inserted, check the angle of insertion and the
connections. NOTICE
Use only suitable and undamaged connecting
cables f
or cable connections.
x When inserting the plugs of the connect-
ing cables into the appropriate connection,
ensure that they are correctly positioned
and apply only light pressure. Applying too
much pressure may damage both the unit
connection and the plug of the connecting
cable.
x Make sure that the connecting cable is not
pinched or sharply bent.
x Using unsuitable or damaged connecting
cables may damage devices and cause
malfunctions. If a connected device is not recog-
nised, disconnect all de

vices and con-
nect the device again. If necessary, check
that the connecting cable you are using is
working properly. If a connected device malfunctions, re-
start the de

vice. In some cases this will
remedy the fault. USB port
Please refer to at the start of the chap-
ter on page 215.
USB port types
The f

ollowing USB ports may be available in
the vehicle:

Replacing the 12-volt vehicle battery
The 12-
volt vehicle battery has been devel-
oped to suit the conditions of its installation
location and has special safety features. If
a 12-volt vehicle battery has to be replaced,
discuss the electromagnetic compatibility,
size and necessary servicing, output and safe-
ty requirements for the new 12-volt vehicle
battery with a Volkswagen dealership before
purchase. The ventilation opening of the 12-
volt vehicle battery must always be on the
negative terminal side: the ventilation open-
ing on the positive terminal side must always
be sealed.
Only maintenance-free 12-volt vehicle bat-
teries compliant with the standards
TL 825 06 and VW 7 50 73 should be used.
These standards must be dated October 2014
or later.
Always have the 12-volt vehicle battery re-
placed by a qualified workshop, as the vehicle
electronics must be adapted as part of the
replacement process. Only qualified work-
shops have the technology required to carry
out this adjustment correctly. Volkswagen
recommends that the 12-volt vehicle battery
is replaced by a Volkswagen dealership.
Disconnecting the 12-volt vehicle battery
Please observe the following if the 12-volt
vehicle battery has to be disconnected from
the electrical system in the vehicle:

dimensions as the factory-fitted 12-volt
v
ehicle battery. NOTICE
x Ne
ver connect or disconnect 12-volt vehi-
cle batteries when the electric drive is ac-
tivated. Never use a 12-volt vehicle bat-
tery that does not correspond with the ve-
hicle

Unlocking or locking with Keyless Ac-
cess 75
Vehicle battery (12-volt) 320
Automatic switch-off for electrical con- sumers 322
Charging 321
Checking the electrolyte level 321
Connecting 321
Discharge 322
Disconnecting 321
Earth connection for jump start- ing 302
Explanation of symbols 320
Jump starting 302
Location 320
Preparations 321
Replacing 321
Vehicle care 355
Aerials 371
Automatic car washes 356
Car wash 355
Controls 359
Displays, screens 359
Electrically adjustable seats 359
Exterior 355, 358
Fabrics 359
Hand wash 356
High-pressure cleaners 356
Interior 355, 359
Leatherette 359
Microfibre fabrics 359
Natural leather 359
Plastic parts 359
Polishing (paintwork) 356
Rubber seals 359
Seat belts 359
Seat covers 359
Seat cushions with seat heating 359
Seats with airbag components 359
Service position for windscreen wip- ers 293
Trim parts 359
Trim strips 359
Waxing (paintwork) 356
Windows 359
Winter conditions 356
Wiper blades 293
Wooden trims 359
Vehicle data sticker 389
Vehicle functions Online 205Vehicle identification number
387, 389
Displaying 29
Position 388
Vehicle key 73
Replacing the button cell 74
Spare key 73
Vehicle overview Driver side 10
Vehicle overviews Centre console 13
Driver door 9
Front passenger side 14
Front view 7
Rear view 8
Roof 14
Vehicle settings menu Opening 31
Setting 31
Vehicle toolkit 292
Contents 292
Stowage 292
Vehicle