VOLKSWAGEN ID.5 2022 Owners Manual

Adjusting head restraints
Please refer to and at the start of
the chapter on page 98. Fig. 78
Front head restraint: adjusting.
Adjusting the height of the front head re-
straint 1
button,
push the head restraint up or down in the
direction of the arrows.
The head restraint must securely engage in
the top position or other intermediate posi-
tion. In the lowest position, where the guide
pin is completely pushed into the guide rail,
the head restraint does not engage properly. Fig. 79
Rear head restraint: adjusting. Adjusting the height of the rear head re-
straint 1
if
necessary, push the head restraint up or
down in the direction of the arrows.
The head restraint must engage securely into
position. Removing and installing the
head restraints
Please refer to and at the start of
the chapter on page 98. Fig. 80
F
ront head restraint: removing.
Removing the front head restraints 1
.

Memory function
Fig. 83
On the outside of the driv er seat: mem-
ory buttons.
Memory buttons
The memory buttons can be used to store
and recall settings for the driver seat and the
exterior mirrors.
Storing driver seat and exterior mirror set-
tings for driving forwards

Massage function
Fig. 84
In the lower area of the driv er seat:
button for massage function.
When the massage function is switched on,
the lumbar support moves and massages the
lumbar region.
The curvature of the lumbar support (mas-
sage intensity) can be individually adjusted in
three levels during operation by repeatedly
pressing the corresponding switch

The convenience turn signal can be activated
and deactiv ated in the vehicle settings in the
Infotainment system

WARNING
The side lights or daytime running lights
are not bright enough to illuminate the
road ahead and to ensure that other road
users are able to see you.
x Always switch the dipped beam head-
lights on if it is dark, raining or visibility
is poor.
x The tail lights will not be switched on
with the daytime running lights. If the
tail lights are not switched on, the v
ehi-
cle may not be visible to other road
users if it is dark, raining, or if visibility is
poor. switches the dipped beam headlights on
and off only when there is a change in the
le

vel of brightness.
x Switch the dipped beam on manually if
required by the weather conditions, e.g.
in the event of fog. When reverse gear is engaged, the
cornering light on both sides of the v

e-
hicle switches on to provide better illumina-
tion of the surrounding area when manoeu-
vring. Switching the rear fog light
on and off
The rear f

og light can only be switched on
when the ignition is switched on

Automatic headlights
is switched on
and at speeds abo
ve approximately 10 km/h
(6 mph).
Acoustic warnings if lights are not switched
off
When the ignition has been switched off and
the driver door is opened, acoustic warnings
will sound under the following conditions:

cles driving in front are detected. Main-beam
control normally also recognises illuminated
areas such as towns and deactiv
ates main
beam while driving through them.
Within the limits of the system, main-beam
control automatically switches the main
beam on or off depending on the environ-
mental and traffic conditions and on the driv-
ing speed

x
Regularly check the area of the wind-
screen that is in the camera

x
Always check the lights yourself and ad-
just them to the pre vailing conditions for
lights, visibility and road traffic.
x The main-beam control may not be able
to recognise all driving situations cor-
rectly and may not work properly in cer-
tain situations.
x If the camera