seats VOLKSWAGEN PASSAT 1995 B3, B4 / 3.G Service Workshop Manual

Downloaded from www.Manualslib.com manuals search engine 40-50

10 - Dished washer Outer diameter
(concave side)
contacts thrust washer
11 - Thrust washer
12 - Circlip Always replace Insert in shaft groove 13 - Outer constant velocity joint, 90 mm diameter Only replace complete Removing Fig. 2 Installing: drive onto
shaft with plastic
hammer until
compressed circlip
seats Greasing Notes
Page 40-46 Checking Page 40-60 Page 50 of 82Front Wheel Suspension, Shafts and Axle12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.40.1

Downloaded from www.Manualslib.com manuals search engine 40-51

14 - Outer constant velocity joint, 90 mm diameter For vehicles with 16V
and VR6 Wedge splines, larger
diameter Only replace complete Removing Fig. 2 Installing: drive onto
shaft with plastic
hammer until
compressed circlip
seats Greasing Notes
Page 40-46 Checking Page 40-60 15 - Vibration damper Removing and
installing Fig. 1 Installation position
Fig. 1 Available as spare part Is only installed on the
right drive shaft tube. Exception: On vehicles with 85 kW (115 hp)
and manual
transmission 02C only
installed on left solid
drive shaft Page 51 of 82Front Wheel Suspension, Shafts and Axle12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.40.1

Downloaded from www.Manualslib.com manuals search engine 40-73

Drive axle with triple-rotor
joint, servicing
1 - Outer constant velocity (CV) joint Replace complete part
only Removing Fig. 1 Installing: drive onto
shaft with plastic
hammer until circlip
seats (springs into
groove) Greasing page 40-
12 2 - Circlip Always replace Insert in groove in
shaft
3 - Thrust ring
4 - Belleville spring Larger diameter
(concave side)
contacts with thrust
ring
5 - Clamp Always replace Tightening page 40-
7 6 - Boot Check for tears and
chafing
7 - Clamp
8 - Axle shaft Page 73 of 82Front Wheel Suspension, Shafts and Axle12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.40.1

Downloaded from www.Manualslib.com manuals search engine 42-50

11 - Circlip Always replace Insert in shaft groove 12 - Outer constant velocity joint: 81 mm diameter Only replace complete Removing Page 40-54 Installing: drive onto
shaft with plastic
hammer until
compressed circlip
seats Greasing Notes
Page 42-46 Checking Page 40-60 13 - Inner support rings Prevents boot inflating Only installed on left
drive shaft
transmission end Page 5 of 7Rear drive shafts, servicing12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.42.4