open bonnet VOLKSWAGEN TRANSPORTER 1992 T4 / 4.G Owners Manual
[x] Cancel search | Manufacturer: VOLKSWAGEN, Model Year: 1992, Model line: TRANSPORTER, Model: VOLKSWAGEN TRANSPORTER 1992 T4 / 4.GPages: 164, PDF Size: 25 MB
Page 96 of 164
Downloaded from www.Manualslib.com manuals search engine
GENERAL
MAINTENANCE
Bonnet
To
release
lock, pull lever on
left
under in strument panel until bonnet springs up
slightly.
To
open the bonnet press the safety catch
in (arrow).
Lift bonnet until the strut engages.
Note
Before
opening the bonnet ensure that the
wiper arms are not lifted off the wind
screen.
Otherwise damage can occurto the paintwork. To close bonnet
lift
it slightly adn pull the
strut forward - see illustration. Let bonnet
drop into locks from a height of about 30 cm
- do not press it
closed.
•
Attention
• For
safety
reasons the
bonnet
must
always
be
properly
closed
when
vehicle is moving. Always
check
therefore
after
closing the
bonnet
that
the lock is engaged.
Should
you notice at any time when driving
that the bonnet is not properly
secured,
stop
and
close it.
www.vwT4camper.info - a useful website for owners and enthusiasts of VW T4 Transporter Campervans
Page 126 of 164
Downloaded from www.Manualslib.com manuals search engine
DO-IT-YOURSELF
Changing bulbs
Before
starting to replace a bulb, switch off
the light concerned.
Do
not touch the glass part of the new bulb
with
bare fingers because the finger marks
left
on the glass evaporate when the bulb
becomes
hot, the vapour settles on the re
flector and dims it.
Always
use the same type of bulb. The
des
ignation is marked on the base of the bulb
or on the
glass.
It is advisable to always a carry a box of
spare
bulbs in the vehicle. These can be ob
tained from Volkswagen dealers. It should contain at least the following bulbs which
are essential for traffic safety:
12 V 60/55 W Headlight (H4)
12V21W
Turn signal
12V21/5W
Brake
and tail light
12 V4W
Side
light
12V5W
Glass
base
Number
plate light
Headlights
The
headlight bulbs can be reached through
the opened bonnet.
• Pull off the connector.
• Pull cap off.
•
Squeeze
the spring clip of the bulb holder together and pull down.
• Take the bulb out and insert the new bulb
so
that
the locating lug on the bulb plate en
gages
the recess in the reflector. The centre
of the three terminals on the bulb base is
then at the top.
• Fold the spring clip over bulb
base.
Squeeze
the clip together and engage it in
the retaining lugs.
•
Press
the cap back on.
• Attach the connector.
• Have the headlight beam alignment
checked.
Side
light
bulb
The
side light bulbs are located in the head light reflectors.
• Turn the bulb holder fully to the
left
and take it out of the reflector.
•
Press
the defective bulb into the holder,
turn
it to
left
and take it out.
• Insert the new bulb.
• Insert the bulb holder in the reflector and
turn
the holder fully to the
right.
124
www.vwT4camper.info - a useful website for owners and enthusiasts of VW T4 Transporter Campervans
Page 127 of 164
Downloaded from www.Manualslib.com manuals search engine
DO-IT-YOURSELF
Front
turn
signals
To
change a bulb the
turn
signal housing must be taken out to the
front.
•
Insert
the
flat
blade of a screwdriver be tween headlight and
turn
signal
with
bonnet
open.
This presses the securing tabs which hold the
turn
signal housing to the
side.
• Swing screwdriver to
front
as shown in illustration so
that
the
turn
signal housing is
pressed
out forward. • Turn bulb holder out to the
left.
• Turn bulb out and renew.
•
Insert
bulb holder. •
Insert
turn
signal housing in the grooves provided (top and
bottom)
and press it in
until
the securing tabs engage.
Fog
lights*
The foglight bulbs can betaken out from un
derneath the bumper.
• Turn cap on rear of fog
light
to the
left
to remove it.
• Unhook spring clip of bulb holder and swing it away.
• Take bulb out.
•
Insert
new bulb so
that
the locating lug on bulb plate engages
recess
in the reflec
tor.
• Swing spring clip over bulb plate,
squeeze
it together and engage it in the re
taining lugs.
• Fit cap again.
• Have beam alignment
checked.
Rear
lights
Renewal
of the bulbs for the rear lights is
done from the luggage compartment
through the rear panel trim.
•
Reach
into
the hole in the rear panel
trim
with
one hand and squeeze the two retaining tabs of bulb carrier together.
• Take bulb carrier out (illustration). •
Press
defective bulb
into
holder slightly,
turn
it to the
left
and take it out.
•
Insert
new bulb and
turn
fully to the
right
• Install bulb carrier.
125
www.vwT4camper.info - a useful website for owners and enthusiasts of VW T4 Transporter Campervans
Page 130 of 164
Downloaded from www.Manualslib.com manuals search engine
DO-IT-YOURSELF
Adjusting
headlights
I he setting of the headlights is very import
ant to traffic safety. The adjustment should
tnerefore only be done
with
a special
appliance.
Note official regulations when
setting headlights.
On vehicles
with
beam
control* the
knurled disc on the instrument panel must
be
in the
basic
position (-).
Both illustrations show the adjustment on
the
right
hand headlight. On the
left
hand headlight the adjustment is symmetrically
opposite.
Main
headlights
The
headlights are adjusted from the
front
with
a suitable Phillips screwdriver
(from
ve
hicle
tools). The bonnet must be released or
open..
A
- Vertical adjustment
Turning clockwise lowers the headlights.
B
- Lateral adjustment
PIPS
|B7Q-
)55|
Fog
lights*
The
front
foglights are adjusted by a knurled
wheel mounted on the foglight behind the bumper. To adjust, push the
flat
end of a
screwdriver through the opening adjacent
to the foglight (see Fig.) and rotate knurled
wheel.
On
vehicles without a spoiler the knurled
wheel can also be turned by hand.
To
reduce the beam range,
turn
screwtothe
left.
128
www.vwT4camper.info - a useful website for owners and enthusiasts of VW T4 Transporter Campervans
Page 162 of 164
Downloaded from www.Manualslib.com manuals search engine
ROUTINE
CHECKS
WHEN
FILLING
THE TANKS
n order to ensure
that
your vehicle remains ready for the road at all
times between Inspections you should carry out a few checks reg-
jlarly
- preferably when filling the tank.
Attention
Take
particular
care
when
working
in the
engine
compartment
- see
page
95.
We
have listed the most important points to be checked here. How
to open the bonnet is explained on page 94. 1 -
Coolant
reservoir
(expansion
tank)
Attention
Do not
open
expansion
tank
when
engine
is hot -
danger
of scalding!
If the level is below the min. mark, top it up
with
coolant additive G 11 V 8 B and water - see page 101. When unavoidable plain water
can
be used temporarily.
2 -
Brake
fluid
reservoir
The fluid level must always be between the min. and max. marks
-see
page 104.
3 - Engine oil
level
Every
engine
uses
a certain amount of oil. If the level is too low it
can
lead to serious engine damage. For this reason the level must be checked regularly - see page 97.
4- Engine oil
filler
opening
The approved types of oil are given on page 96.
5 -
Windscreen
washer
container
Always
fill
with
water and a glass cleaner. Think about frost precau
tions in winter.
6 -
Tyre
inflation
pressures
Check
the pressures at least once a month. The pressures are given
on page 147 and on a sticker on the driver's door lock pillar. For
further
information, see page 110.
60
www.vwT4camper.info - a useful website for owners and enthusiasts of VW T4 Transporter Campervans