clock VOLVO 850 1996 User Guide

1996 Volvo 850
pg. 2:6 Front seats
1 Height adjustment (manual)

The front section of both front seats can be adjusted to eight different\
height settings and the rear section
of both seats can be adjusted to nine different height settings.

Lever forward = adjustment of front section
Lever rearward = adjustment of rear section
WARNING! Do not adjust the seat while driving. The seat should be adjust\
ed so that the brake pedal
can be depressed fully. In addition, position the seat as far rearward a\
s comfort and control allow. The
seat rails on the floor must not be obstructed in any way when the seat \
is moved.

2 Forward-rearward seat adjustment (manual)

Pull the control upward, then slide the seat forward or rearward to the \
desired position. Make sure that
the seat is properly secured when you release the control.

Folding front seat

The passenger's seat backrest has a quick forward release mechanism whic\
h can be used when long
loads are carried.
See page 2:22.

3 Backrest angle (manual)

Rotate the control mechanism counterclockwise to tilt the backrest rearw\
ard and clockwise to tilt the
backrest forward.

4 Lumbar support*

file:///K|/ownersdocs/1996/1996_850/96850_206.htm (1 of 11)12/30/2006 \
9:59:22 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850
Firm: turn clockwise.
Soft: turn counter-clockwise.
*Driver's seat only on certain models


Electrically operated seats with memory function (certain models)


Power seat control panel

A Seat front (raise/lower)
B Forward - rearward
C Seat rear (raise/lower)
D Backrest tilt

file:///K|/ownersdocs/1996/1996_850/96850_206.htm (2 of 11)12/30/2006 \
9:59:22 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850

Trunk lid

The trunk lock is incorporated in the central locking system. This means\
that you can either lock or
unlock the trunk by means of either of the front doors.
You can also operate the trunk lock directly with the master key even if\
the vehicle is centrally locked.

The trunk can also be disconnected from the central locking system by tu\
rning the key counterclockwise
as shown below:


Withdraw key in the horizontal position.

The trunk is now always locked. The optional folding rear seatback can a\
lso be locked from the trunk
(
see page 2:16). This feature can be used for example, if you lend your car to someon\
e. If you give only
the service key to the driver, it will not be possible to gain access to\
the trunk. To reconnect the lock to
the central locking system:
file:///K|/ownersdocs/1996/1996_850/96850_212.htm (2 of 12)12/30/2006 \
9:59:24 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850
Withdraw key in vertical position
pg. 2:13 Tailgate, Child safety lock (wagon)

Opening the tailgate

Tailgate

To unlock - fold down the flap covering the lock (see inset illustratio\
n above) insert the key, turn it
clockwise and allow it to spring back.

To lock - turn the key counter-clockwise and allow it to spring back.

NOTE: The tailgate is also unlocked and locked at the same time as the d\
river's door.

file:///K|/ownersdocs/1996/1996_850/96850_212.htm (3 of 12)12/30/2006 \
9:59:24 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850
Volvo allows the use of the following "oxygenated fuels"; however, the o\
ctane ratings listed on this page
must still be met.

Alcohol -- Ethanol

Fuels containing up to 10% ethanol by volume may be used.
Ethanol may also be referred to as Ethyl alcohol, or "Gasohol".
Ethers -- MTBE
Fuels containing up to 15% MTBE may be used.

Refueling

The fuel tank filler cap is located behind the door on the left rear fen\
der. Open cap slowly during hot
weather conditions.
When filling, position the cap in the special bracket on the door.

NOTE: Turn the ignition off or to position I when refueling. If the igni\
tion is on, an incorrect reading
could occur in the fuel gauge (low fuel will be indicated).

After filling the tank, install the cap and turn until a "click" is hear\
d.
The fuel tank is designed to hold approximately 19.3 US gals (73 liters\
) with sufficient volume left over
to accommodate possible expansion of the fuel in hot weather. The "usabl\
e" tank capacity will be
somewhat less than the specified maximum. When the fuel level is low, su\
ch factors as ambient
temperature, the fuel's "vapor pressure" characteristics, and terrain ca\
n affect the fuel pumps' ability to
supply the engine with an adequate supply of fuel. Therefore, it is advi\
sable to refuel as soon as possible
when the needle nears the red zone, or when the fuel warning light comes\
on.
CAUTION: Do not refuel with the engine running. After refueling, close t\
he fuel filler cap by turning
it clockwise until it clicks into place.

NOTE: if the filler cap is not closed tightly or if the engine is runnin\
g when the car is refueled, the
Malfunction Indicator Lamp may indicate a fault. Use only Volvo original\
or approved fuel filler caps.

file:///K|/ownersdocs/1996/1996_850/96850_401.htm (4 of 8)12/30/2006 9\
:59:32 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850
Loosen wheel bolts Insert flat end of lug wrench and turn


Pull straight out

Changing a wheel

The spare wheel is located under the carpet on the trunk floor. The jack\
and crank are secured in the
wheel recess.
l Engage the parking brake.
l Put the gear selector in (P)ark (automatic) or in Reverse (manual)\
.
l Remove the wheel cap (where applicable) using the lug wrench in the to\
ol kit.
l With the car still on the ground, use the lug wrench to loosen the wheel\
bolts 1/2 - 1 turn. Turn the
bolts counterclockwise to loosen.
l Fold out the crank handle on the jack by pressing the nob on the handle \
downward. To attach the jack,
refer to the illustration on the following page.

NOTE:
To avoid excessive wear and the necessity of rebalancing, mark and reins\
tall wheels in same location
and position as before removal. To lessen the chance of imbalance, each \
wheel hub is equipped with a
guide stud to ensure that a removed wheel can be reinstalled in its orig\
inal position (as when changing
over to winter tires/wheels).

*The guide stud in not visible from the outside of the wheel on turbo mo\
dels.
file:///K|/ownersdocs/1996/1996_850/96850_601.htm (2 of 5)12/30/2006 9\
:59:39 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850
WARNING!
l The jack attachment must engage the bar in the jack attachment (A). Th\
e car's weight must not rest
on the jack's attachment (B).
l Be sure the jack is on a firm, level, non-slippery surface.
l Never allow any part of your body to be extended under a car supported b\
y a jack.
l Use the jack intended for the car when replacing a wheel. For any other \
job, use stands to support
the end of the car being worked on.
l Apply the parking brake, select position P (automatic transmission) or\
Reverse gear (manual
transmission).
l Block the wheels standing on the ground. Use rigid wooden blocks or larg\
e stones.
l The jack should be kept well-greased.

Installing the wheel

Clean the contact surfaces on the wheel and hub. Lift the wheel and plac\
e it on the hub. Make sure that
you align the wheel with the guide stud on the wheel hub prior to instal\
lation. Install the wheel bolts
cross-wise (see illustration) and tighten by turning lightly clockwise\
. Lower the vehicle to the ground
and alternately tighten the bolts to 81 ft. lbs. (110 NM). Install the\
wheel cap (where applicable).
CAUTION: Correct tightening torque on wheel bolts must be observed. The \
wheel bolts should never
be greased or lubricated. The extended, chromed wheel bolts must not be \
used with steel rims, as they
make is impossible to fit the hub caps.


Correct tightening order for wheel bolts
pg. 6:4 Spare tire
file:///K|/ownersdocs/1996/1996_850/96850_601.htm (4 of 5)12/30/2006 9\
:59:39 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850

1 - Plastic cover, 2 - Bulb HB4/9006
3 - Bulb HB3/9005, 4 - Connector

Headlight bulb replacement

1. Turn the plastic cover counter-clockwise and remove it.
2. Turn the bulb and connector (one unit) 1/4 turn counter-clockwise a\
nd remove.
3. Disconnect the wiring from the bulb unit.
4. Connect a new bulb unit into the wiring without touching the bulb its\
elf.
5. Re-insert the bulb into the headlight housing and turn 1/4 turn clock\
wise until the unit seats properly.
The unit has three guide lugs to ensure proper seating.
6. Reinstall the plastic cover.

Headlight adjustment

The height of the headlight beams can be adjusted according to vehicle l\
oad. The headlights should be re-
aimed if heavy loads are carried in the trunk/cargo area or rear seat, o\
r when towing a trailer.
To adjust the headlights:
l Park the car on a level surface and open the hood.
l The headlights are equipped with a level which can be seen by looking th\
rough the clear "window" on
the top of the headlight lens.
l Turn the height adjustment knob (A) until the bubble in the level alig\
ns with the "0" marks or within
the dark marking lines.
file:///K|/ownersdocs/1996/1996_850/96850_605.htm (2 of 13)12/30/2006 \
9:59:43 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850

Location of bulbs in holder

All the bulbs in the tail light unit are replaced from inside the trunk \
as follows:

1. Turn the two plastic screws and open the cover over the rear lamp uni\
t.
2. Loosen and remove the bulb holder.
3. Let the connector with its wires remain attached to the bulb holder. \

4. Remove the bulb by pressing in and turning counter-clockwise.
5. Insert a new bulb into the holder and reinstall the holder into the t\
ail light assembly.
6. Close the cover.


Bulbs 1, 4:
5W/4 cp BA 15 s


Bulbs 2, 3, 5, 6:
21W/32 cp BA 15 s
pg. 6:8 Replacing bulbs
file:///K|/ownersdocs/1996/1996_850/96850_605.htm (4 of 13)12/30/2006 \
9:59:43 AMClassic Cars & Cycles www.ClassicCycles.org

1996 Volvo 850

Press in the springs (sedans) Remove the cover (wagons)

High-mounted brake light

Sedans:
l Turn off the ignition.
l Press in the springs on both sides of the holder.
l Pull the cover towards you.
l Depress the catches on both sides of the reflector and withdraw it from \
the holder.
l Replace the bulb.
l Reinstall the reflector.
l Press the cover into place.

Wagons:
l Turn off the ignition.
l Press the sides of the cover using both hands and pull it out and down. \
l Remove the inner protective cover from the bulb.
l Remove the bulb by pressing in and turning slightly counter-clockwise.
l Replace the bulb.
l Reinstall the protective cover over the bulb.
l Press the cover into place.
pg. 6:10 Replacing bulbs
file:///K|/ownersdocs/1996/1996_850/96850_605.htm (7 of 13)12/30/2006 \
9:59:43 AMClassic Cars & Cycles www.ClassicCycles.org