immobilizer VOLVO C30 2008 Owners Manual

measure, the code of the lost remote control must be erased from the system.
Each key blade has a unique code, which is used if new key blades are required. A maximum of six remote
controls/key blades can be programmed and used for one car.
Immobilizer (start inhibitor)
Each of the keys supplied with your vehicle contains a coded transponder. The code in the key is transmitted to an
antenna in the ignition switch where it is compared to the code stored in the start inhibitor module. The vehicle will
start only with a properly coded key. If you misplace a key, take the other keys to an authorized Volvo retailer for
reprogramming as an antitheft measure.USA - FCC ID: LTQWFS 125VO
This device complies with part 15 of the FCC rules. Operation is subject to the following condition: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Canada - IC: 3659A-WFS125VO
Operation is subject to the following conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
CAUTION
Never use force on the narrow section of the remote control - this is where the transponder is located. The vehicle
cannot be started if the transponder is damaged.
117 05 Locks and alarm
Remote control and key blade
Remote control functions
1. Lock - Press the Lock button on the remote once to lock all doors and the rear liftgate. The turn signals will flash
once to confirm locking.
NOTE
The vehicle can also be locked if a door is open (does not apply to vehicles with the optional keyless drive.

141 06 Starting and driving
Starting the vehicle
To start the engine
1. Fasten the seat belt.
WARNING
Before starting, check that the seat, steering wheel and mirrors are adjusted properly. Make sure the brake pedal can
be depressed completely. Adjust the seat if necessary.
2. Apply the parking brake if not already set. The gear selector should be locked in the (P)ark position (Shiftlock). See
also page 147
.
Manual transmission : the clutch must be fully depressed.
3. The vehicle is equipped with an autostart feature. Without touching the throttle pedal, turn the key to position III
and release it. The starter motor will then operate automatically (for up to ten seconds) until the engine starts. If the
engine fails to start, repeat this step.
NOTE
After a cold start, idle speed may be noticeably higher than normal for a short period. This is done to help bring
components in the emission control system to their normal operating temperature as quickly as possible, which
enables them to control emissions and help reduce the vehicle's impact on the environment.
4. To release the gear selector from the (P)ark position, the engine must be running (or the ignition key must be in
position II) and the brake pedal must be depressed.
5. Select the desired gear. On models with an automatic transmission, the gear engages after a very slight delay which
is especially noticeable when selecting R.
NOTE
Immobilizer : If two of the keys to your vehicle are close together, e.g., on the same key ring when you try to start
the vehicle, this could cause interference in the immobilizer system and result in the vehicle not starting. If this
should occur, remove one of the keys from the key ring before trying to start the vehicle again.
Keylock: Models equipped an automatic transmission have a keylock system. When the engine is switched off, the
gear selector must be in the ( P)ark position before the key can be removed from the ignition switch
1.
When starting in cold weather, the transmission may shift up at slightly higher engine speeds than normal until the
automatic transmission fluid reaches normal operating temperature.
Do not race a cold engine immediately after starting. Oil flow may not reach some lubrication points fast enough
to prevent engine damage.
1The optional keyless drive start control does not need to be removed from the ignition switch.
142 06 Starting and driving
Starting the vehicle

replacing209
specifications255
warning symbols209
Blind Spot Information System (BLIS)156, 157, 158
Booster cushions40
Brake fluid206
Brake lights58
Brake system148
warning light55
Bulbs
list of256
replacing211
C
Capacities250
Cargo area
lighting102
load anchoring eyelets112
net112
Cargo area cover
hard110
soft111
Catalytic converter257
CD player239
Central locking system
immobilizer116
locking and unlocking the vehicle from the inside126
panic alarm118
remote control116, 117
Chains (winter driving)177
Changing a wheel182
Check engine light53
Child restraints
booster cushions40
convertible seats37, 38, 39
infant seats35, 36
introduction33, 34
ISOFIX/LATCH anchors41
recalls and registration43
top tether anchors42
Child safety31
Climate system
air distribution95
air vents88
electronic climate control92, 93, 94

warning141
Fluid capacities250
Fluids206
Front airbags19, 20, 21
Front fog lights58
Front passenger's side airbag, disabling22, 23
Front seats
manual adjustment98
power99, 100, 101
Fuel filler cap6
Fuel filler door6
unlocking59
Fuel level warning light53
Fuel requirements136, 137, 138
Fuses219 - 224
G
Geartronic automatic transmission145, 146
shiftlock override147
Generator warning light54
Glove compartment105
locking/unlocking127
H
Hazard warning flashers68
Headlights
high beams60
low beam60
washers63
Home Link® Universal Transceiver80, 81, 82
Home safe lighting60
Hood opening201
I
Ignition switch139
Immobilizer116
Infant seats35, 36
Inflatable Curtain26, 27
Inflation pressure168
Inflation pressure tables, Canadian models171
Inflation pressure tables, U.S. models170
Information display messages56, 57
Inspection readiness200
Instrument and warning symbols51, 52, 53
Instrument overview47, 48
Instrument panel49, 50
lighting58