lock VOLVO C30 2009 Quick Guide

AUTOSTART
Depress the clutch and/or brake pedal. Turn
the key/keyless drive start control to position III
and release it. The engine will start automati-
cally.


key

blAde
Used to lock/unlock the glove compartment or
the driver’s door if the vehicle has no electrical
current.
c O ld START
n
OT e
After cold starts, your engine will idle at a
higher speed for a short time.
key &
RemOTe cOnTROl
l
ocks the doors and liftgate, and arms
the alarm.
Unlocks the doors and liftgateA and
disarms the alarm.
Unlocks the liftgate. (Does not open
the liftgate).
Approach lighting (30 secondsB)
illuminates lights in door mirrors, cabin,
footwells, license plates. Turn signals
and parking lights illuminate.
“Panic” alarm. Press and hold to
sound the alarm. Turn off alarm with
unlock button.
A. Automatic relock occurs if no door/liftgate is opened within 2 minutes after unlock.
B. The time can be set to 30, 60, or 90 seconds.
TURn SIgnAlS
A. Lane-change sequence, three flashes.
B. Full turn sequence. Adjust tilt and telescope.
W

AR nIng ! Never adjust the steering wheel
while driving. S
TeeRIng Wheel AdjUSTmenT

FUel
1 low fuel level indicator
When the symbol illuminates, refuel as
soon as possible.
2 Fuel gauge
The fuel filler door is on the right, as indi-
cated by the arrow.
TRIP O

dOmeTeR
3 Press quickly to toggle between T1 &
T2 . Press and hold to reset the displayed
odometer.
4 The trip odometer display shows two
separate trip odometers, T1 & T2.
d
ISP lAy
5 Information display (trip computer
information, messages, clock and am-
bient temperature).
O

dOmeTeR And TRIP cOmPUTeR
blIS – blInd SPOT InFORmATIOn SySTem (OPTIOn) TRIP cOmPUTeR
6
Press to erase a displayed message.
7 Turn to show trip computer information
such as mIl eS TO emPTy TA nk in the
information display.
8 Reset current function. A long press
resets all functions.
n
OT e
mIle S TO emPTy TA nk is an approxima-
tion, based on recent average fuel consump-
tion.
If the BLIS indicator lights illuminate occasionally even when there are no other vehicles in the blind
area, this may be caused by light reflected from a wet road surface, the vehicle’s own shadow
against a large, light, smooth surface, or sunlight directly in the camera when the sun is low on the
horizon.
In the event of a fault, b
lind spot syst. service required will be displayed.

D
C
SOFT cARgO AReA cOveR (OPTIOn)
RIgId cARgO AReA cOveR (OPTIOn)
Installing
Pull all four locking buttons back as far as pos-
sible. Carefully lift in the cover, place the front
section on the two supports behind (A) on both
sides.

hO
ldeRS FOR FlOOR hATch
Attach the hooks near the floor (A).
Press together the spring-loaded rails and
insert them in the attachments (B) on both
sides.
Insert the attachments in (C) in the same way.
Place the hooks in (D).
Remove the attachments at (D) and (C) if
necessary on both sides when loading the
cargo area.
Remove (D), (C), (B), and (A) and roll up the
cover when it is not in use.


Open floor hatch without/with cargo area
cover.
Place one rear lock at (B) and press the lock
button forward. Lock the other buttons in the
same way.
Removing
Pull the lock buttons rearward as far as possible
at (A) first, then at (B). Lift out the cover. F OldIng dOWn The ReAR SeAT
bAckReSTS

+-6
A
E
B
F
G *CD
AdjUSTIng The FROnT SeAT
1 l umbar support
2 b ackrest tilt
3 Raise/lower the seat
4 Raise/lower the front edge of the seat
cushion
5 Forward/rearward
6 Access to rear seat
TP 10155 (USA & Canada) AT 0820. Printed in Sweden, Göteborg 2008, Copyright © 2000 -2008 Volvo Car Corporation
ReFUelIng
Press this button to unlock the fuel filler
door.
Hang the fuel filler cap on the hook while
refueling. e
nTeRIng The ReAR SeAT
m anual seat
m o

ving the seat forward:
A. Remove the seat belt from the guide.
B. Pull up the handle and hold it up. Fold the
backrest forward until it locks in position.
C. Move the seat forward.
m o

ving the seat rearward:
D. Move the seat rearward until it reaches its
original position.
E. When the seat has reached its original
position, pull up the handle (B) and return the
backrest to the upright position.
F. Put the seat belt back into the guide.
Power seat (option)
m o

ving the seat forward:
A. Remove the seat belt from the guide.
B. Pull up the handle and fold the backrest
forward.
G. Press and hold the button while the seat
moves forward.
m o

ving the seat rearward:
G. Hold in the button again reaches its origi-
nal position. Pull up the handle (B) and return
the backrest to the upright position.
F. Put the seat belt back into the guide.
n
OT e
When putting on the seat belt, it is easiest
to reach the lower section of the belt, near
the guide, instead of reaching over your
shoulder.