low beam VOLVO S60 TWIN ENGINE 2020 User Guide

||
LIGHTING
156rain. When active high beams become availa- ble again, or the windshield sensors are nolonger blocked, the message will disappear and the
symbol will be displayed.
WARNING
Automatic high beam is an aid in using the best possible light based on prevailing con-ditions. The driver is always responsible for man- ually switching between high and lowbeam when traffic situations or weatherconditions require this.
Related information

Lighting control and panel (p. 150)
Using high beam (p. 154)
Camera/radar sensor limitations (p. 301)
Using turn signals
The vehicle's turn signals are controlled using the left-side steering wheel lever. The turnsignals flash three times or continuously,depending on how far up or down the lever ismoved.
Turn signals.
Triple flash indicatorMove the steering wheel lever up or down to the first position and release. The turnsignals will flash three times. If the func-tion is deactivated via the center display,the signals will flash once.
NOTE
This automatic flashing sequence can be interrupted by immediately movingthe lever in the opposite direction.
If the turn signal indicator flashes morequickly than normal, refer to the mes-sage in the instrument panel.
Continuous flashing sequenceMove the lever up or down as far as possi- ble.
The lever will stop in its end position and canbe moved back manually or automatically bymoving the steering wheel.
Related information
Hazard warning flashers (p. 160)
Adjusting light functions via the centerdisplay (p. 151)

LIGHTING
}}
* Option/accessory.157
Active Bending Lights *
Active Bending Lights (ABL) are designed to help provide extra illumination in curves andintersections. Depending on equipment level, vehicles with LED 3
headlights * may be equip-
ped with Active Bending Lights.
Headlight pattern with function deactivated (left) and activated (right).
Active Bending Lights follow the movement of the steering wheel to help provide extra illumi-nation in curves and intersections, helping toimprove visibility for the driver. The function is automatically activated when the engine is started. If a fault is detected in the system, the
symbol will illuminate in
the instrument panel and a message will be displayed. The function is only active in weak daylight ordark conditions and only when the vehicle ismoving and the low beams are on.
Deactivating/activating the functionThe function is activated as the default factorysetting and can be activated and deactivatedin the center display's Function view:
Tap the
Active Bending
Lights button.
Related information
Adjusting light functions via the center display (p. 151)
Front fog lights/corner illumination
*
(p. 157)
Front fog lights/corner illumination *
The fog lights can be activated manually when driving in fog and are activated auto-matically when backing up to help augmentthe backup light. If the vehicle is equipped with corner illumi- nation *, the fog lights are activated automati-
cally in weak daylight or dark conditions to illuminate the area diagonally in front of thevehicle.
Front fog lights button.
The front fog lights can be turned on when the ignition is in mode II and the lighting ring is in
position
, or .
Tap the button to activate or deactivate the function. The
symbol in the instrument
3 LED (Light Emitting Diode)

||
WINDOWS, GLASS AND MIRRORS
* Option/accessory.
180
CAUTION
Avoid activating the washer system when it is frozen or the fluid reservoir is empty.Otherwise, there is a risk of damaging thepump.
Headlight washer *To save washer fluid, the headlights are washed automatically according to a definedinterval when the headlights are on.
Reduced washingWhen there is about 1 liter (1 qt) of washer fluid left in the reservoir and the Washer fluid
Level low, refill message is displayed in the
instrument panel together with the
sym-
bol, the washer fluid supply to the headlights is cut off. This is to prioritize windshield clean-ing and visibility through it. The headlights areonly washed if high or low beam is on.
Related information
Using the rain sensor (p. 178)
Wiper blades and washer fluid (p. 177)
Using the rain sensor's memory function(p. 179)
Filling washer fluid (p. 621)
Putting the wiper blades in service posi-tion (p. 620)
Replacing windshield wiper blades(p. 619)
Using the windshield wipers (p. 177)

DRIVER SUPPORT
* Option/accessory.
300
Camera The camera is used by several driver support systems to e.g. detect lane marker lines orroad signs.
Location of the camera.
The camera is used by the following functions:
Adaptive Cruise Control
*
Pilot Assist
*
Lane Keeping Aid
*
Steering assistance at risk of collision
City Safety
Driver Alert Control
*
Road Sign Information
*
Active high beams
*
Park Assist
*
Related information
Driver support systems (p. 260)
Camera/radar sensor limitations (p. 301)
Recommended camera and radar sensor maintenance (p. 305)

INDEX
642Front seats, power 183
adjusting passenger seat from driv-
er's seat 191
adjusting seat 183
Lumbar support 189
massage 186, 187, 188
multifunction control 186, 187, 188, 189
Side bolsters 189
store position 184, 185
FSC, environmental labeling 23
Fuel 429 Travel Link service 469
Fuel filling 428
Fuel gauge 83
Fuel requirements 429, 430 Fuel tank volume 634
Fuse box 585
Fuses 585 below the glove compartment 594
in engine compartment 587
in trunk 600
replacing 585
G
Gasoline grade 429 Gaugefuel gauge 83
hybrid battery 84
Gear selector positions automatic transmission 407
Glass, laminated/reinforced 166
Glove compartment 555Gracenote ® 475
Grocery bag holders 559
Gross vehicle weight 629
H
Handbrake 400
Hand wash 611 Hard disk space 504
Hazard warning flashers 160
HD radio 459 Headlamp beam adjustment 152
Headlight pattern, adjustment 152
Head restraint 193
Head-up display 139 activating/deactivating 141
cleaning 606
Distance Alert 265
replacing windshield 571
settings 141
store position 141, 184, 185
Heated wiper blades 177
Heater 227 auxiliary heater 227
parking heater 227
Heating Seats 210, 211
steering wheel 212
windows 215
high beams 154, 155
High engine temperature 433
Hill Start Assist 405 Hill Start Assist (HSA) 405
Hoisting the vehicle 569Hold vehicle function 424
HomeLink ® 442
programming 443
type approval 446
use 445
HomeLink ® remote control
programmable 442

INDEX
644Keyless
locking/unlocking 247
settings 248
touch-sensitive surfaces 246
Key tag 232
L
Labels location 624
Laminated glass 166 Lamps changing 578
Trailer 439
Lane Keeping Aid 336 activating/deactivating 338
display 342
limitations 339
see Lane Keeping Aid 336
select assistance option 338
Symbols and messages 340
Language 129
Large Animal Detection (LAD) 310Leather upholstery, cleaning instruc-
tions 608 Leveling control suspension 419
License agreement 95, 505
Lifting tools 533Light bulbschanging 578
Light control 150, 162Lighting Active Bending Lights 157
approach lighting 160
automatic high beam 155
brake lights 159
control, instrument, display 162
controls 150, 161
cornering illumination 158
daytime running lights 153
emergency brake lights 159
front fog lights 157
Hazard warning flashers 160
high beams 154, 155
home safe lighting 160
in passenger compartment 161
low beams 154
position lights 152
rear fog light 158
settings 151
Turn signals 156
Lighting, replacing bulbs 578
Limp home 406Load anchoring eyelets cargo compartment 560Load anchoring hooks 559
Load carriers 558
Load index 522Loadinggeneral 557
load anchoring eyelets 560
long load 558
Lock indication 230 setting 231
Locking/unlocking trunk lid 249
Locking wheel bolts 533 Locks locking/unlocking 234
Long-term storage 390 Low battery charge level start battery 434
Low beams 154
Low oil level 575
M
Maintained climate comfort 224 start/stop 224
Maintenance 562 corrosion protection 616