start stop button VOLVO S60T8 2019 Quick Guide

CHARGING THE HYBRID BATTERY
Your Volvo is equipped with an electric motor that primarily powers the vehicle at low speeds and a combustion engine that powers the vehicleat higher speeds and during more active driving. The time required tocharge the hybrid battery depends on the charging current the wallsocket can supply. The hybrid battery is also recharged during light
braking or engine braking, e.g. on a downslope. All types of chargingare indicated in the instrument panel. Storing the charging cable The charging cable is located under the trunk floor. Starting charging The start battery is charged while the hybrid battery is charging and will stop charging when the hybrid battery is fully charged.
1. Connect the charging cable to a wall socket. Never use an extension cord.
2. Open the charger door by pressing it lightly.
3. Push the charging handle all the way into the vehicle's socket. The charging cable will automatically lock into the charging socket and charging will begin within approximately 5 seconds.
Stopping charging
1. Press the
2 button on the remote key to unlock the vehicle. Charg-
ing will stop.
2. Press the lock button on the charging socket and then remove the charging cable from the vehicle.
3. Close the charger door.
4. Disconnect the charging cable from the wall socket.
5. Replace the charging cable under the trunk floor. If the charging cable is not removed from the socket it will automatically relock into place after a short period after unlocking in order to helpmaximize charging and driving range and to enable preconditioning of the vehicle before driving. The charging cable can be released from thesocket again if the vehicle is unlocked using the remote key. For vehi- cles with keyless locking/unlocking
*, the vehicle can be locked and
unlocked using the door handle.
2 This must be done even if the vehicle's doors are already unlocked. If the vehicle is not unlocked using the unlock button, the charging cable or the system could be damaged.
02

PARKING ASSISTANCE SYSTEMS
Park Assist Pilot *
Park Assist Pilot can help the driver steer the vehicle while parking. The driver's task is to check the area around the vehicle, follow the instruc-tions provided in the center display, select the appropriate gear, controlthe vehicle's speed and be prepared to apply the brakes to stop thevehicle.
Parking with Park Assist Pilot
Do not drive faster than 30 km/h (20 mph) when parking. The distance between the vehicle and the parking spaceshould be about 1 meter (3 feet) when the function is look-ing for parking.
1. Tap
Park In in Function view or Camera view.
2. Be prepared to stop the vehicle when notified by a graphic and a message in the center display that a suita- ble parking space has been found. A pop-up window willappear.
3. Select
Parallel parking or Perpendicular parking and
engage reverse gear.
Pulling out of a parallel parking space with Park Assist Pilot
This function can only be used when the vehicle has been parallel parked.
1. Tap Park Out in Function view or camera view.
2. Use the turn signals to indicate the direction in which the vehicle will pull out of the parking space.
3. Follow the instructions in the center display.
Park Assist Camera *
The Park Assist Camera can help the driver steer the vehicle in tight spaces by alerting the driver to obstacles using the camera screen andgraphics in the center display. Camera views and guiding lines can beselected in the center display. Note that objects/obstacles may be closer to the vehicle than they appear on the display. The Park AssistCamera starts automatically when reverse gear is engaged. It can alsobe started manually from the center display.
–Tap the Camera button in Function view to manually
activate/deactivate the function.
05