position light VOLVO S80 2004 Owner's Manual

programming the HomeLink® Universal Transceiver, call toll-free 1-800-355-3515 (Internet: www.HomeLink.com).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used in place of hand -held transmitters.
To operate, the key must be turned to the "accessory" position (II) or the engine must be running. Press the
programmed HomeLink® button to activate the garage door, driveway gate, security lighting, home security system,
etc.
Your original hand -held transmitters may, of course, be used at any time.
pg. 155 HomeLink® Universal Transceiver (option)
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed buttons:
1. Turn the ignition key to the "accessory" position (II).
2. Hold down the two outside buttons on the HomeLink® Universal Transceiver for about 20 seconds, until
HomeLink®'s indicator light begins to flash.
3. Release both buttons.
The HomeLink® buttons can be reprogrammed using the procedures described on the previous pages.
Reprogramming a single HomeLink® button
1. Press and hold the desired HomeLink® button. Do not release the button until step 3 has been completed.
2. When the indicator light begins to flash slowly (after approximately 20 seconds), position the hand -held transmitter
2 to 5 in. (5 to 12 cm) away from the HomeLink® surface.
3. Press and hold the hand -held transmitter button. The HomeLink® indicator light will flash first slowly, then rapidly.
When the indicator light flashes rapidly, release both buttons.
The previously programmed device has now been erased and the new device can be activated by pressing the
HomeLink® button that has just been programmed. This procedure will not affect any other programmed HomeLink®
buttons.
NOTE:
Retain the original transmitter(s) for future programming procedures (i.e., if you purchase a new car).
For your own security, erase all programmed buttons on the HomeLink® Universal Transceiver when you sell your
car.
Metallic sun protection films should not be used on any windows in a car equipped with HomeLink® Universal
Transceiver. This could interfere with the transceiver's function.

Contents | Top of Page
ProCarManuals.com

Opening the trunk from the inside..........63
P
Paint touch-up..........113
Panic function (alarm)..........65
Parking Assistance, rear..........79
Parking brake..........38
Parking brake reminder light..........26
Parking lights..........32
Passenger's seat backrest - folding..........53
PCV system..........119
Polishing..........115
Power moonroof..........41
Power seats..........52
Power steering - speed-sensitive..........81
Power steering fluid ........ 124, 133
Power windows..........39
PROPOSITION 65 WARNING..........125
R
Rain sensor - windshield wipers..........35
Reading lights - front/rear ........ 54
Rear door step lights - replacing..........110
Rear fog light..........27, 32
Rear Parking Assistance..........79
Rear reading lights..........54
Rear seat backrests - folding..........58
Rear suspension..........134
Rear window - heated..........37
Rearview mirror..........40
Refrigerant..........48, 133
Refueling..........72
Remote control - keyless entry system..........61
Remote control - keyless entry system and sideview mirrors..........40
Remote keyless entry system..........61
Remote keyless entry system - replacing batteries..........62
Remote keyless entry system and driver's seat..........53
Replacing bulbs..........106-112
Replacing fuses..........102
Replacing wiper blades..........127
Reporting safety defects..........11
Road assistance..........136
Roadholding..........81
Roof load - maximum..........131
Roof racks..........82
S
ProCarManuals.com