lights VOLVO V50 2010 Quick Guide

key blade
Used to lock/unlock the glove compartment or the driver’s door if the vehicle has no electrical current.
remote key & key blade
locks the doors and tailgate, and arms the alarm.
Unlocks the doors and tailgatea and disarms the alarm.
Unlocks (but does not open) the tailgate.
approach lighting illuminates lights in door mirrors, cabin, footwells, license plates. Turn signals and parking lights illuminate.
“Panic” alarm. – Press and hold to sound the alarm. Turn off alarm with unlock button.a. automatic relock occurs if no door/tailgate is opened within 2 minutes after unlock.
note
after cold starts, your engine will idle at a higher speed for a short time.
cold Start
aUtoStart
depress the clutch and/or brake pedal. Turn
the key/keyless drive start control to posi-tion III and release it. The engine will start automatically.
tUrn SIgnalS
A lane-change sequence, three flashes. B Full turn sequence. warn
Ing
Never adjust the steering wheel while driving.
SteerIng wheel adjUStment

lIghtIng panel
automatic headlights. High beam flash only.
Parking lights.
Headlights: turn off when ignition is switched off, high/low beams.
active bending lights*, headlight beams follow movements of the steer-ing wheel.
display & instrument panel lighting.
Front fog lights*.
Rear fog light (driver’s side only).
AHigh beam flash.
BToggle between high/low beams, home safe lighting.
wIperS and raIn SenSor*
1Rain sensor on/off with the lever in the 0 position.
2Turn to adjust intermittent wiper speed or rain sensor sensitivity where applicable.
3Tailgate wiper – normal/interval.
ASingle wiper sweep.
0Off
BIntermittent wipers. Turn (2) to adjust interval.
CNormal wiper speed.
DHigh wiper speed.
EWindshield and headlight washer.
FTailgate washer.
displayed when the rain sensor is active.

1
l ow fuel level indicator When the symbol illuminates, refuel as soon as possible.
2 Fuel gauge The fuel filler door is on the right, as indi-cated by the arrow.
3 Information display (trip computer infor-mation, messages, clock and ambient temperature).
4 a short press toggles between t 1 & t 2.
a long press resets the displayed odom-eter.
5 The trip odometer display shows two separate trip odometers, t 1 & t 2.
trIp compUter and odometer
IndIcator and warnIng lIghtS
See the information in the display.
abS warning light. Stop safely.Restar t the enginea.
Stop safely and take the action shown in the display.brake failure warning light, stop safely. Check brake fluid levelb.
low oil pressure,
stop safely and check the oil levelb. dSTC stability system, flashes when
the system is working.a. Contact a Volvo retailer if the symbol stays on after the engine has been restarted. b. Have the vehicle towed if the symbol remains illuminated.
6 Press to display or erase a message.
7 Turn to show trip computer information alternatives
8 a short press resets current function.
a long press resets all functions.
note
The display text mIleS to empty tank is an approximation, based on recent average fuel consumption.

FoldIng the rear Seat backreSt
1. Press this button to open the fuel filler door. 2. Hang the fuel filler cap on the hook while refueling. reFUelIngemergency brake aSSISt (eba)
blInd Spot InFormatIon
SyStem (blIS)*
If the blIS indicator lights illuminate occasion
-ally even when there are no other vehicles in the blind area, this may be caused by light re-flected from a wet road surface, the vehicle’s own shadow against a large, light, smooth surface, or sunlight directly in the camera when the sun is low on the horizon.
In the event of a fault, blInd Spot SySt.
ServIce reqUIred will be displayed. See
the Owner’s Manual for other blIS-related
messages. eba is designed to provide full brake effect
immediately in the event of sudden, hard
braking. When eba is activated, the brake
pedal will go down more than usual.
– Press and hold the brake pedal for as long as necessar y – there will be no braking ef-fect if the pedal is released.
Place the head restraint in the plastic tubes, which are now accessible on the underside of the seat cushions.
Fold the backrest down completely.
1 Hang the seat belt in the jacket holder.
Fold up the seat cushion.
Release the catch and fold the backrest down partially.
Press the catch at the base of the head restraint and move the head restraint upward.
Remove the head restraint. note
The front passenger’s seat backrest can also
be folded down. See point 6 of adJUSTING
THe FRONT SeaT.
car care
Hand washing is gentler on the paint than an automatic car wash. Since the paint on a new vehicle may take several months to harden completely, we recommend washing the vehicle by hand during this period. Use clean water, a suitable car washing detergent and
a sponge.
keep in mind that dirt or grit on the
sponge can scratch the paint.