maintenance VOLVO V60 2011 Owner's Manual
[x] Cancel search | Manufacturer: VOLVO, Model Year: 2011, Model line: V60, Model: VOLVO V60 2011Pages: 388, PDF Size: 9.32 MB
Page 316 of 388
08 Maintenance and service
Lamps
08
316
Lamp housing, rear
The reversing, fog and direction indicator bulbs
in the rear lamp cluster are replaced from inside
the cargo area.
1. Open the panel.
2. Remove the insulation that is fitted in front
of the bulb holder by pulling it straight out.
3. Press down the catch and pull out the bulb
holder.
4. Remove the blown bulb by pressing it in
and turning anticlockwise.
5. Fit a new bulb, press down and turn clock-
wise.
6. Press down the catch when the bulb holder
is refitted.7. Refit the insulation and panel.
NOTE
If an error message remains after the broken
bulb has been replaced then we recom-
mend that you visit an authorised Volvo
workshop.
Location of rear bulbs
Lamp lens, right-hand side
Brake light (LED)
Direction indicators
Reversing lamp
Rear fog lamp (driver's side)
Number plate lighting
1. Remove the screws with a screwdriver.
2. Carefully detach the whole lamp housing
and withdraw it.
3. Replace the bulb.
4. Refit the whole lamp housing and screw it
into place.
ProCarManuals.com
Page 317 of 388
08 Maintenance and service
Lamps
08
317 Lighting, cargo area
G031942
1. Insert a screwdriver and gently prize so
that the lamp housing comes loose.
2. Replace the bulb.
3. Check that the bulb illuminates and press
back the lamp housing.
Vanity mirror lighting
Removing the mirror glass
1. Insert a screwdriver under the lamp lens
and gently prize up the lug on the edge.
2. Carefully detach and lift aside the mirror
glass.
3. Pull the bulb straight out and replace with
a new one.
Securing the lamp lens1. Refit the mirror glass.
2. Press it into place.
Specification, bulbs
LightingWType
Extra main beam,
Xenon, ABL65H9
Dipped beam, hal-
ogen55H7 LL
Main beam, Halo-
gen65H9
Front direction
indicators21HY21W
Cargo area light-
ing, number plate
lighting10Tubular
lamp
SV8.5
Vanity mirror1.2w2x4.6d
12v
Glovebox lighting5Tubular
lamp
SV8.5
Direction indica-
tors, rear21SVPY21W
Rear fog lamp21H21W
ProCarManuals.com
Page 318 of 388
08 Maintenance and service
Lamps
08
318
LightingWType
Reversing lamp21P21W
---
ProCarManuals.com
Page 319 of 388
08 Maintenance and service
Wiper blades and washer fluid
08
319 Wiper blades
Service position
In order to change, clean or lift the wiper blades
(for scraping off ice from the windscreen) they
must be in service position.
1. Make sure that the driver's door is closed.
2. Insert the remote control key in the ignition
switch.
3. Set the remote control key in ignition posi-
tion II, see page 81.
4. Turn the remote control key to key position
0 and keep the remote control key in the
ignition switch.5. Move the right-hand stalk switch up for
about 1 second. The wipers then move to
standing straight up.
The wipers return to the starting position when
the car is started.
Replacing the wiper blades
Lift up the wiper arm. Press the button
located on the wiper blade mounting and
pull straight out parallel with the wiper arm.
Slide in the new wiper blade until a "click"
is heard.
Check that the blade is firmly installed.
G021763
ProCarManuals.com
Page 320 of 388
08 Maintenance and service
Wiper blades and washer fluid
08
320
NOTE
The wiper blades are different lengths. The
blade on the driver's side is longer than the
blade on the passenger side.
CleaningFor cleaning wiper blades and windscreen, see
page 336 and onwards.
IMPORTANT
Check the wiper blades regularly.
Neglected maintenance shortens the serv-
ice life of the wiper blades.
Filling washer fluid
The windscreen and headlamp washers share
a common reservoir.
IMPORTANT
Add washer antifreeze during the winter so
that the fluid does not freeze in the pump,
reservoir and hoses.
For capacities, see page 352.
ProCarManuals.com
Page 321 of 388
08 Maintenance and service
Battery
08
321 Warning symbols on the battery
Use protective goggles.
Further information in the
owner's manual.
Store the battery out of
the reach of children.
The battery contains cor-
rosive acid.
Avoid sparks and naked
flames.
Risk of explosion.
Must be taken for recy-
cling.
NOTE
An expended battery must be recycled in an
environmentally responsible manner - it
contains lead.
Operation
•Check that the cables to the battery are
correctly connected and properly tight-
ened.
•Never disconnect the battery when the
engine is running.
The service life and function of the battery is
influenced by factors such as the number of
starts, discharging, driving style, driving con-
ditions, climatic conditions etc.
IMPORTANT
Never use a quick charger to charge the
battery.
WARNING
Batteries can generate oxyhydrogen gas,
which is highly explosive. One spark, which
can be generated if the jump leads are con-
nected incorrectly, is sufficient to make the
battery explode. The battery contains sul-
phuric acid, which can cause serious burns.
If sulphuric acid comes into contact with
eyes, skin or clothing, flush with large quan-
tities of water. If acid splashes into the eyes,
seek medical attention immediately.
ProCarManuals.com
Page 322 of 388
08 Maintenance and service
Battery
08
322
NOTE
The life of the battery is shortened if it
becomes discharged repeatedly.
The life of the battery is affected by several
factors, including driving conditions and cli-
mate. Battery starting capacity decreases
gradually with time and therefore needs to
be recharged if the car is not used for a
longer time or when it is only driven short
distances. Extreme cold further limits star-
ting capacity.
To maintain the battery in good condition, at
least 15 minutes of driving/week is recom-
mended or that the battery is connected to
a battery charger with automatic trickle
charging.
A battery that is kept fully charged has a
maximum service life.
Changing
Removal
Switch off the ignition and wait for 5 minutes.
Open the clips on the front cover and
remove the cover.
Release the rubber moulding so that the
rear cover is free.
Remove the rear cover by screwing one
quarter turn and lifting it away.
ProCarManuals.com
Page 323 of 388
08 Maintenance and service
Battery
08
* Option/accessory, for more information, see Introduction.323
WARNING
Connect and disconnect the positive and
negative cables in the correct sequence.
Detach the black negative cable
Detach the red positive cable
Detach the ventilation hose from the bat-
tery
Loosen the screw holding the battery
clamp.
Move the battery to the side and lift it up.
Installation
1. Lower the battery into the battery box.2. Move the battery inward and to the side
until it reaches the rear edge of the box.
3. Secure the battery using the battery clamp.
4. Connect the ventilation hose.
5. Connect the red positive cable.
6. Connect the black negative cable.
7. Press in the rear cover. (See Removal).
8. Reinstall the rubber moulding. (See
Removal).
9. Reinstall the front cover and secure it with
the clips. (See Removal).
Eco Start/Stop DRIVe*
The car is equipped with two 12 V batteries -
an extra heavy-duty battery for starting and a
support battery which assists the
Eco Start/Stop DRIVe function's starting
sequence.
BatteryStartSupport
Cold start
capacityA,
CCA (A)
760120
SizeB,
L×B×H (mm)278×175×19
0150×90×106
Capacity
(Ah)708
AIn accordance with the SAE standard.BLargest possible size.
NOTE
•The higher the current take-off in the car
(extra cooling/heating, etc.) the more
the batteries must be charged =
increased fuel consumption.
•When the capacity of the battery has
fallen below the lowest permissible level
then the Start/Stop function is disen-
gaged.
Temporarily reduced Start/Stop function due
to high current take-off means:
•The engine auto-starts1 without the driver
depressing the clutch pedal.
1Auto-start can only take place if the gear lever is in neutral position.
ProCarManuals.com
Page 324 of 388
08 Maintenance and service
Battery
08
324
Battery location
A: Left-hand drive car. B: Right-hand drive car. 1.
Battery for starting2 2. Support battery.
The support battery normally requires no more
service than the normal battery that is used for
starting.
IMPORTANT
If the following instruction is not observed
then the Start/Stop function may cease to
work after the temporary connection of an
external battery or battery charger:
•The negative battery terminal on the
car's battery must never be used for
connecting an external battery or bat-
tery charger - only the car chassis may
be used as the grounding point.
See the section "Start assistance" in "Star-
ting and driving" - where there is a descrip-
tion of how the cable clamps must be fitted.
NOTE
If the battery has become so discharged
that everything is "black" and in principle
the car does not have all the normal electri-
cal functions and the engine is subsequently
started using an external battery or battery
charger, then the Start/Stop function will be
activated. It will then be possible for the
engine to be auto-stopped but in the event
of an auto-stop the Start/Stop function may
fail to auto-start the engine due to inade-
quate capacity in the battery.
The battery must first be charged in order to
ensure a successful auto-start after an auto-
stop. At an outside temperature of +15 °C
the battery needs to be charged for at least
1 hour. At a lower outside temperature a
charging time of 3-4 hours is recom-
mended. The recommendation is that the
battery is charged using an external battery
charger.
If this is not possible then the recommen-
dation is to temporarily deactivate the func-
tion until the battery has been adequately
recharged.
For more information about recharging the
battery, see the section "Battery" in the
chapter "Maintenance and service".
2The battery for starting is described in detail on page 321.
ProCarManuals.com
Page 325 of 388
08 Maintenance and service
Fuses
08
325 General
All electrical functions and components are
protected by a number of fuses in order to pro-
tect the car's electrical system from damage by
short circuiting or overloading.
If an electrical component or function does not
work, it may be because the component's fuse
was temporarily overloaded and failed. If the
same fuse fails repeatedly then there is a fault
in the circuit. Volvo recommends that you visit
an authorised Volvo workshop for checking.
Changing1. Look in the fuse diagram to locate the fuse.
2. Pull out the fuse and check from the side
to see whether the curved wire has blown.
3. If this is the case, replace it with a new fuse
of the same colour and amperage.
WARNING
Never use a foreign object, or a fuse with an
amperage higher than that specified when
replacing a fuse. This could cause signifi-
cant damage to the electrical system and
possibly lead to fire.
Location, central electrical units
Central electrical unit locations in a left-hand
drive car. In a right-hand drive car the central
electrical unit under the glovebox changes
sides.
Under the glovebox
Engine compartment
Cargo area under the cargo floor
Engine compartment, cold zone*
ProCarManuals.com