radio VOLVO V60 CROSS COUNTRY 2021 Sensus Navigation Manual

NAVIGATION
}}
* Option/accessory.9
Activating and deactivating the navigation system * in the
instrument panel
The navigation system will be automatically displayed in the instrument panel when adestination is set. The navigation system canalso be displayed without entering a destina-tion.
1. Pull down the center display's Top view. 2. Tap
Settings.
3. Tap
My CarDisplaysDriver Display
Information.
4. Tap the
Show Map radio button to dis-
play the navigation system in the instru- ment panel without entering a destination.
Related information
 Navigation system
* in the instrument
panel (p. 8)
Navigation system * in head-up
display *
The navigation system can be presented and controlled in several different ways, e.g. viathe head-up display.
Navigation system in windshield.
The driver can also get guidance and informa- tion from the navigation system in the head-updisplay on the lower section of the windshield. You can make settings to specify if the naviga- tion system should be shown in the head-updisplay, as well as the position of the informa-tion field.
Related information
 Navigation system
* in center display (p. 6)
 Navigation system
* in the instrument
panel (p. 8)
Voice control for navigation system *
If your vehicle is equipped with Sensus
Navigation, you can use voice commands tocontrol parts of your navigation system.
Start navigationHere is an introduction to how you can begin using voice commands to control the naviga-tion system in your vehicle.
To activate a navigation command–Press the steering wheel keypad's voice control button
.
> You can now give commands, e.g. "
Navigation", which will start a naviga-
tion dialog and show examples of com- mands.
NOTE
Not all system languages support voice control. If a language supports voice con- trol, it is marked with a
symbol in the
list of available system languages. Read more about where the information is foundin the section on voice control settings.
Using voice control to get directions to an address
To get directions to a specific address, use the command Go to followed by the address. It is