seats VOLVO V70 2007 User Guide

You can switch between these three functions by repeatedly pressing
Keep the following in mind:
Make it a rule to have the Air quality sensor activated at all times.
Recirculation is limited in cold climates to avoid misting up.
If misting occurs, you should deactivate the Air quality sensor.
If the windows mist up, you can also use the windshield and side window defroster functions. See page 49.
The filter should be changed at the intervals listed in the Warranty and Service Records Information booklet.
However, if the car is used in a severely contaminated environment, it may be necessary to change the filter more
frequently.
pg. 52 Manual climate control with air conditioning, A/C
pg. 53 Manual climate control with air conditioning, A/C
A/C - ON/OFF
The air conditioning function is engaged by pressing ON and disengaged by pressing OFF. When you select Defroster
, the air conditioning is automatically engaged if the fan is not set to position 0.
Heated front seats (option)
Please see page 38 for more information on this function.
Heated rear window/sideview mirrors

2 0 0 4
VOLVO V70
Chapter 4 - Interior
pg. 55 Interior
Front seats (electrically operated)56
Front seats (manually operated)58
Storage compartments59
Storage compartment, front60
Folding table in rear seat62
Rear seat and cargo area63
Spare tire72
Auxiliary seat in cargo area, Extra handgrip - V7073
Interior lighting74
pg. 56 Front seats
Electrically operated front seats (option)
From the time the driver's door is unlocked, the driver's seat can be adjusted with the ignition off during a 10 minute
period, if the door remains opened. If the door is closed, the seat can be adjusted for 40 seconds.
1 - Power seat control panel
2 - Lumbar support

Turn the control for softer or firmer lumbar support.
Move the seat as far rearward as possible for easiest access to the lumbar support control.
Electrically operated seats with memory function (option)*
Power seat control panel
A Front edge of seat (raise/lower)
B Forward - rearward
C Rear edge of seat (raise/lower)
D Backrest tiltWARNING!
Because the driver's seat can be adjusted with the ignition off, children should never be left unattended in the car.
Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel.
Do not adjust the seat while driving. The seat should be adjusted so that the brake pedal can be depressed fully. In
addition, position the seat as far rearward as comfort and control allow.
The seat rails on the floor must not be obstructed in any way when the seat is in motion.
Programming the memory
Three seat positions can be programmed. To program a seat position:
1 Adjust the seat to the desired position.
2 Hold down the MEM button.
3 While holding down the MEM button, press button 1 to program the current position of the seat.
Buttons 2 and 3 can be programmed in the same way.
To move the seat to a programmed position, press and hold down button 1, 2 or 3 until the seat moves to the preset
position and stops.
As a safety precaution, the seat will stop automatically if the button is released before the seat has reached the
programmed position.
NOTE: The seat has an overload protector which engages if an object blocks the movement of the seat. If this

happens, remove the object and wait 20 seconds before operating the seat again.
* This option is only available on the driver's seat.
pg. 57 Front seats
Electrically operated seats - general information
Adjusting the front seats:
Passengers's seat: The passenger's seat can only be adjusted if the ignition key is in position I or II.
Driver's seat: The driver's seat can be adjusted if the ignition key is in position I or II (see page 36
). However, it can
also be adjusted:
Within 40 seconds after the ignition has been switched off (even if the key has been removed from the ignition
switch).
Within 40 seconds after the driver's door has been unlocked with the key or remote control and opened. The key
does not have to be in the ignition switch during this period.
Remote keyless entry system and driver's seat
The remote control transmitter also controls the electrically operated driver's seat in the following way:
Adjust the seat to your preferences.
When you leave your car, lock it using the remote control.
The next time you unlock the driver's door with the same remote control(the one you used to lock the doors with)
and open the driver's door , the driver's seat will automatically move to the position in which you left it.
The seat will move to this position even if someone else has adjusted it since you last unlocked the car with the same
remote control.
NOTE:
This feature will work in the same way with all of the remote control transmitters (up to 3) that you use with your
car.
This feature will not function if you lock your car with the key.
Folding front seat backrest
The passenger seat backrest can be folded down to the horizontal position for carrying long loads. To fold down the

backrest:
Move the seat as far rearward as possible
Adjust the backrest tilt to the most upright position
Lift the catches on the lower rear side of the backrest
Without releasing the catches, push the backrest forward
Move the seat as far forward as possible
WARNING!
Cover sharp edges on the load to help prevent injury to occupants. Secure the load to help prevent shifting during
sudden stops.
pg. 58 Front seats
Manual height adjustment - front seat
The front edges of the driver and passenger seat cushions can be adjusted to seven different settings and the rear edges
to nine different settings.
Lever (A) - adjusting the front edge of the seat.
Lever (B) - adjusting the rear edge of the seat.
Manual front-rear adjustment
The seat can be moved forward or rearward by pulling up on the front -rear adjustment bar.
Check that the seat is securely locked into position after adjusting. WARNING!
Do not adjust the seat while driving. The seat should be adjusted so that the brake pedal can be depressed fully. In
addition, position the seat as far rearward as comfort and control allow.
pg. 59 Storage compartments

button again (within 10 seconds) to unlock all doors, and the tailgate.
NOTE:
If the doors are unlocked with the remote, the locks will automatically reengage (re-lock) and the alarm will reset
after 2 minutes unless a door has been opened.
The lock/unlock and alarm features can also be utilized by using the keys.
FCC ID:LQNP2T-APU
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Canadian 2306104388
Model 504 2927 by Donnelly
Operation is subject to the following conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Canadian 2306104388A
Model 509 977 by Connaught Electronics
Operation is subject to the following conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
pg. 78 Remote keyless entry system
Remote keyless entry system - replacing batteries
If the range of the transmitter is noticeably reduced, this indicates that the battery is weak and should be replaced.
To replace the battery
Remove the cover by carefully prying up its rear edge with a small screwdriver
Replace the battery with a new 3-volt, CR 2032 battery. The battery should be inserted with the plus side upward.
Avoid touching the contact surfaces of the battery with your fingers.
Press the cover back into place. Ensure that the rubber seal seats correctly to help prevent moisture from entering the
unit.

Installing a new bulb
To install a new low beam bulb (H7):
Insert the new bulb, without touching the glass, with the guide lug upward (1). The bulb will only seat properly in
this position.
Move the retaining spring up and push it slightly to the left until it seats properly (2).
Press the connector into place on the bulb (3).
Reinstall the plastic cover and turn it clockwise until it is correctly in place (4). "TOP" must be upward.
NOTE: If the vertical aim of your headlights needs to be adjusted for any reason (e.g., towing a trailer for extended
periods), this should be done by an authorized Volvo retailer.
pg. 123 Replacing bulbs
To remove and install a high beam bulb (HB3):
Switch off all lights and turn the ignition switch to position 0.
Open the hood.
Remove the cover by twisting it counterclockwise.
Twist the bulb holder counterclockwise, pull it out and fit a new bulb. Note its position.
Refit the bulb holder. It can only be fitted in one way.
Screw the cover back on. The word TOP should be upwards.

Climate system - general information47
Clock27
Clutch interlock89
Coat hanger61
Coin compartment59
Cold weather driving105
Combination filter48, 51
Coolant133
Cooling system - general information97
Courtesy light76
Courtesy lights (front) - replacing126
Courtesy lights - exterior76
Cruise control33
Cup holder59
Cup holder in the center console60
D
Detachable trailer hitch - installing103
Dimensions145
Direction indicators36
Distributor ignition system149
Door step courtesy lights - replacing125
Doors and locks76
Drive belt133
Driver's seat and remote keyless entry system57
Driving economy96
Driving mode indicator27
Driving mode W91, 93, 105
Driving with trunk open97
E
Economical driving96
Electric socket in cargo compartment67
Electrical system150
Electrical system - general information97
Electrically operated front seats56
Electrically operated moonroof42
Electrically operated sideview mirrors41
Electrically operated windows40
Electronic Brake Force Distribution19
Electronic Climate Control (ECC)48 - 51
Emergency Locking Retractor (ELR)14
Emergency towing100, 101
Emergency warning flashers38
Emissions systems132
Engine - specifications147

Engine - starting87, 88
Engine air filter134
Engine compartment136
Engine oil105, 137, 138
Extension of cargo compartment63
Exterior courtesy lights76
Exterior features - overview25
Extra seat73
F
Fog light - rear29
, 35
Fog lights - front35
Folding passenger's seat backrest57
Folding table62
Four-C active chassis system31, 95
Front airbags - SRS4 - 7
Front airbags - SRS - warning light28
Front courtesy lights - replacing126
Front fog lights35
Front fog lights - replacing125
Front reading lights74
Front seats - adjusting56
Front seats - heated38
Front seats - manual adjustment58
Front suspension149
Fuel84
Fuel filler cap86
Fuel filter134
Fuel gauge27
Fuel requirements84
Fuel system132, 134, 149
Fuel tank cover86
Fuel/emissions systems132
Fuses118-121
G
Gas cap86
Gasoline84
Gear indicator27
Geartronic (automatic transmission)92, 93
Generator150
Generator warning light28
H
Hand brake39
Handgrip - V7055, 73
Handling96

Hazard warning flashers38
Head restraint (center) - 3-section rear seat64
Head restraint - center rear3
Headlight bulbs - replacing122
Headlight wiper blades - replacing142
Headlights34
Heated front seats38
Heated rear window38
Heated sideview mirrors38
Heating48-51
Hoisting the car135
Holder for grocery bags67
Home Safe System76
HomeLink®169-171
Hood - opening136
I
Ignition switch35, 36
Immobilizer (start inhibitor)76, 87
Indicator lights28, 29
Inflatable curtain (IC)9
Instrument illumination34
Instrument panel27
Instruments26
Integrated booster cushion12
Interior Air Quality system51
Interior features - overview24
Interior lighting74
J
Jack72
, 114
Jump starting104
K
Key - removing from ignition switch87
Keyless entry system77, 78
Keyless entry system - replacing batteries78
Keylock87
Keys76
Kickdown91, 92
L
Label information144
License plate lights - replacing126
Lifting the car135
Lights - accessory31
Load carriers98
Locking and unlocking the car76