spare wheel VOLVO V70 2008 User Guide

wear worse.
If you do rotate your tires...
Please follow the tire manufacturer's recommendations, as outlined in the tire manufacturers tire warranty pamphlet.
262 06 Maintenance and specifications
Wheels and tires
Changing a wheel
Spare wheel
The spare wheel (Temporary spare) is only intended for temporary use. Replace the spare wheel with a normal wheel
as soon as possible. The car's handling may be altered by the use of the spare wheel. The correct tire pressure for the
spare wheel is stated in the tire pressure tables, see pages 250 and 251
.
WARNING
Current legislation prohibits the use of the "Temporary Spare" tire other than as a temporary replacement for a
punctured tire. It must be replaced as soon as possible by a standard tire. Road holding and handling may be affected
with the "Temporary Spare" in use.
CAUTION
The vehicle must never be driven with more than one temporary spare wheel.
The spare wheel is located in the spare wheel well with the rim side down. There are two foam blocks, one under the
spare wheel and one over/inside. The upper one contains all tools.
The same bolt runs through to secure the spare wheel and the foam blocks.
Taking out the spare wheel
1. Fold the rear edge of the floor mat forward.
2. Open the floor hatch.
3. Undo the retaining bolt.
4. Lift out the foam block with tools.
5. Lift out the spare wheel.
ProCarManuals.com

The other two blocks can remain in the wheel well.
After use
The foam block and spare wheel must be replaced in the reverse order. Note the arrow on the upper foam block. It
should point forward.
263 06 Maintenance and specifications
Wheels and tires
NOTE
If the floor hatch is not completely closed, the private locking feature (see page 58
) will not function.
Changing a tire:
1. Apply the parking brake.
2. Put the gear selector in P .
3. Block the wheels that are on the ground with wooden blocks or large stones.
4. Remove the wheel cover (where applicable) using the lug wrench in the tool bag.With the vehicle still on the
ground, use the lug wrench to loosen the wheel nuts 1/2-1 turns by exerting downward pressure.
5. Turn the nuts counterclockwise to loosen.
6. There are two jack attachment points on each side of the vehicle. Position the jack correctly in the attachment (see
illustration above) and crank while simultaneously guiding the base of the jack to the ground. The base of the jack
must be flat on a level, firm, non-slippery surface. Before raising the vehicle, check that the jack is still correctly
ProCarManuals.com

Automatic locking retractor/Emergency locking retractor33
buckling16
maintenance16
pretensioners16
reminder16
reminder warning light77
securing child restraint systems36, 38, 41
unbuckling16
use during pregnancy17
using16
Seats, front 82-83
Setting the clock79
Shiftlock override113
Side door mirrors101
Side impact airbags25
Side marker lights, changing bulbs231
Sirius satellite radio145-148
Snow chains259
Snow tires259
Sound settings, audio system139
Spare tire260
Speed -dependent steering155
Spin control153
SRS18
Stability system


indicator light 76
introduction153
operation153
symbols in the instrument panel154
Start inhibitor (immobilizer) 53
Starting the engine109
with keyless drive110
Starting the vehicle


after a crash (crash mode) 30
Steel grid in cargo area 208
Steering wheel


adjusting 87
horn88
keypad87, 124, 136
lock110
Storage spaces 186
Studded tires259
Sunroof (moonroof)103-104
Supplemental restraint system18
ProCarManuals.com