remove seats VOLVO V90 2017 Owners Manual

||
SAFETY
72sitting on the front passenger seat then he/she could suffer serious injury if the airbag deploys. If the passenger airbag is deactivated then rear- facing child seats can be fitted on the front pas-senger seat.
NOTE
Regulations regarding the placement of chil- dren in cars vary from country to country.Check what does apply.
WARNING
Never allow anybody to stand or sit in front of the front passenger seat. Never use a rear-facing child seat on the front passenger seat if the airbag is activated. Front-facing passengers (children and adults) must never sit on the front passenger seat ifthe passenger airbag is deactivated. Failure to follow the advice given above can endanger life or lead to serious personalinjury.
Child seat installationThe following points are important to consider when a child seat is being fitted in the car.
WARNING
Booster cushions/child seats with steel braces or some other design that could reston the seatbelt buckle's opening button mustnot be used, as they could cause the seatbeltbuckle to open accidentally. Do not secure the straps for the child seat into the seat's horizontal adjustment bar or insprings, rails or beams under the seat. Sharpedges may damage the straps. Do not allow the upper section of the child seat to rest against the windscreen.
Installation in the front seat
•
When fitting rear-facing child seats, check that the passenger airbag is deactivated.
• When fitting front-facing child seats, checkthat the passenger airbag is activated.
• Only use child seats that are recommendedby Volvo, are universally approved or aresemi-universal, and where the car is includedon the manufacturer's vehicle list.
• ISOFIX child seats can only be fitted when the car is equipped with the ISOFIX console 2
accessory.
• If the child seat is equipped with lower straps, Volvo recommends that the lower mounting points are used with these 2
. •
The ISOFIX guide can be used in order to facilitate child seat installation.
Installation in the rear seat
•Only use child seats that are recommended by Volvo, are universally approved or aresemi-universal, and where the car is includedon the manufacturer's vehicle list.
• A child seat with support legs must not befitted in the centre seat.
• The outer seats are equipped with theISOFIX fixture system and are approved for i- Size3
.
• The outer seats are equipped with upper mounting points. Volvo recommends thatchild seat's upper straps should be pulledthrough the hole in the head restraint beforebeing tensioned at the mounting point. If thisis not possible, follow the recommendationsfrom the child seat manufacturer.
• If the child seat is equipped with lowerstraps, never adjust the position of the seatin front after the straps have been fitted inthe lower mounting points. Always rememberto remove the lower straps when the childseat is not installed.
2
The accessory range varies depending on market.
3 Varies depending on market.

||
SAFETY
* Option/accessory.
74
WARNING
The child seat's upper straps must be routed through the hole in the head restraint legbefore they are tensioned at the mountingpoint. If this is not possible, follow the recom-mendations from the child seat manufacturer.
NOTE
Fold the head restraints in order to facilitate fitting this type of child seat in cars with fold-ing head restraints on the outer seats.
NOTE
In cars with a cargo cover over the luggage compartment, this must be removed beforechild seats can be attached to the securingpoints.
Related information
• Child seats (p. 71)
• Lower mounting points for child seats (p. 74)
• i-Size/ISOFIX mounting points (p. 77)
• Table for location of child seats using thecar's seatbelts (p. 75)
Lower mounting points for child seats
The car is equipped with lower mounting points for child seats in the front seat * and the rear
seat.
The lower mounting points are designed to be used in conjunction with certain rear-facing childseats. Always follow the manufacturer's installation instructions when connecting a child seat to thelower mounting points.
The location of the mounting points
Mounting point locations in the front seat.
The mounting points in the front seat are located on the sides of the passenger seat's legroom. The mounting points in the front seat are onlymounted if the vehicle is equipped with a switch to activate/deactivate the passenger airbag
*.
Mounting point locations in the rear seat.
The mounting points in the rear seat are located on the rear section of the front seat's floor rails.
Related information
• Child seats (p. 71)
• Upper mounting points for child seats (p. 73)
• i-Size/ISOFIX mounting points (p. 77)
• Table for location of child seats using thecar's seatbelts (p. 75)
• Activating/deactivating the passenger air- bag
* (p. 66)

INSTRUMENTS AND CONTROLS
* Option/accessory.121
Manual front seat
The car's front seats have different setting options for optimum seating comfort.
Raise/lower the front edge of the seat cush- ion * by pumping up/down.
Change the length of the seat cushion by pulling the lever up and moving the seatcushion forward/backward by hand.
Adjust the seat forward/backward by lifting the handle and adjusting the distance to thesteering wheel and pedals. Check that theseat is locked after the position has beenadjusted.
Change the lumbar support * by pressing the
button upward/downward/forward/back.
Raise/lower the seat by means of adjusting the control up/down.
Change the backrest rake by turning the control knob.
WARNING
Adjust the position of the driver's seat before setting off, never while driving. Make sure thatthe seat is in locked position in order to avoidpersonal injury in the event of heavy brakingor an accident.
Related information
• Power front seat
* (p. 121)
• Multi-functional front seat
* (p. 123)
• Activating/deactivating heating of the seats
*
(p. 203)
• Seatbelt (p. 59)
Power front seat
*
The car's front seats have different setting options for optimum seating comfort. The powerseat can be moved forward/backward and up/down. The front edge of the seat cushion can beraised/lowered and the backrest rake can bechanged. The lumbar support can be adjustedupward/downward/forward/backward.
The power seats have overload protection which is tripped if a seat is blocked by an object. If thishappens, remove the object and then operate theseat again. The seat can be adjusted for a period of time after unlocking the door without the engine run-ning. Seat adjustment can always be performedwhen the engine is running. Adjustment can alsobe performed for a period of time after theengine has been switched off.
Related information
• Multi-functional front seat
* (p. 123)
• Adjusting the power front seat
* (p. 122)
• Using the memory function in the power front seat
* (p. 122)
• Manual front seat (p. 121)
• Activating/deactivating heating of the seats
*
(p. 203)

||
CLIMATE CONTROL
* Option/accessory.
204
Seat heating indication and controls on the climate panel at the rear of the tunnel console.
–Press repeatedly on the left or right-hand side's buttons for heated seats on the tunnelconsole's climate panel to switch between the four levels:
Off, High, Medium and Low.
> The level changes and the screen in the climate panel shows the set level.
WARNING
Heated seats must not be used by people who find it difficult to perceive an increase intemperature due to a lack of sensation or whootherwise have problems operating the con-trols for the heated seats. Otherwise they maysuffer burn injuries.
Activating/deactivating automatic start of heated seats
It is possible to set whether automatic start of heated seats should be activated/deactivatedwhen the engine is started. With automatic startactivated, heating will start in the event of lowambient temperature. 1. Press
Settings in the top view in the centre
display.
2. Press
Climate.
3. Under
Auto Driver Seat Heating Level andAuto Passenger Seat Heating Level,
select Off,Low,Medium or High in order to
activate/deactivate the automatic starting of the heating for the driver and passengerseats and to select the level.
Related information
• Climate controls (p. 186)
• Climate controls in the centre display(p. 187)
• Climate controls at the rear of the tunnel console
* (p. 188)
Activating/deactivating ventilation of the seats *
The seats can be ventilated, for example, to remove moisture from clothes.
The ventilation system consists of fans in the seats and backrests that draw air through theseat upholstery. The cooling effect increases thecooler the passenger compartment air becomes.The system can be activated when the engine isrunning and takes seat temperature, solar radia-tion and outside temperature into consideration.