193 5
During programming, your hand-held transmitter may automatically stop
transmitting. To successfully train HomeLink®, continue to hold the
HomeLink® button. At the same time, repeatedly press and hold your
hand-held transmitter’s button at two-second intervals until HomeLink®
has learned your transmitter’s code. The HomeLink® indicator light
will flash first slowly, and then rapidly to indicate that the button has
been successfully programmed.
Determining if your garage door uses a rolling code
Determine, in one of the following ways, if your garage door uses a
rolling code system and is manufactured after 1996:
•"
C
•
GY
=
•9
GY
GY
8
*
To train a rolling code garage door opener, follow these instructions
after programming the desired transceiver button according to “Program-
ming the transceiver.” The help of a second person may make training
easier.
%
G
,$
C
% &22 -FF -F%F , #
G
1
*
9 :
;
:
;
-
9
GY
9
GY
)
$
GY=
The remaining two HomeLink® buttons can be programmed in the
same way. In the event of any problems in programming the
HomeLink® Universal Transceiver, call toll-free 1-800-355-3515
(Internet: www.HomeLink.com).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used
in place of your hand-held transmitters.
To operate, the key must be turned to the “accessory” position (II) or
the engine must be running. Press the programmed HomeLink® button
to activate the garage door, driveway gate, security lighting, home
security system, etc.
Your original hand-held transmitters may, of course, be used at any
time.
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed
buttons:
%
:
; ,1
*
GY=
*2 GYC
-
"
The HomeLink® buttons can be reprogrammed using the procedures
described on the previous page.
,GY
8
1
HomeLink® Universal Transceiver (option)
