headlights VOLVO XC70 2007 User Guide

2007 Volvo XC70
l An automatic wash is a simple and quick way to clean your vehicle, but i\
t is worth remembering that
it may not be as thorough as when you yourself go over the vehicle with \
sponge and water. Keeping the
underbody clean is most important, especially in the winter. Some automa\
tic washers do not have
facilities for washing the underbody.
l Before driving into an automatic car wash, make sure that side view mirr\
ors, auxiliary lamps, etc, are
secure, and that any antenna(s) are retracted or removed. Otherwise th\
ere is risk of the machine
dislodging them.
Exterior lighting
Condensation may form temporarily on the inside of the lenses of exterio\
r lights such as headlights, fog
lights, or tail lights. This is normal and the lights are designed to wi\
thstand moisture. Normally,
condensation will dissipate after the lights have been on for a short ti\
me.
Polishing and waxing
l Normally, polishing is not required during the first year after delivery\
, however, waxing may be
beneficial.
l Before applying polish or wax the vehicle must be washed and dried. Tar \
spots can be removed with
kerosene or tar remover. Difficult spots may require a fine rubbing comp\
ound.
l After polishing use liquid or paste wax.
l Several commercially available products contain both polish and wax.
l Waxing alone does not substitute for polishing a dull surface.
l A wide range of polymer-based waxes can be purchased today. These waxes \
are easy to use and
produce a long-lasting, high-gloss finish that protects the bodywork aga\
inst oxidation, road dirt and
fading.
l Do not polish or wax your vehicle in direct sunlight (the surface of th\
e vehicle should not be warmer
than 113° F (45° C).
CAUTION!
Volvo does not recommend the use of long-life or durable paint protectio\
n coatings, some of which
may claim to prevent pitting, fading, oxidation, etc. These coatings hav\
e not been tested by Volvo for
compatibility with your vehicle's clear coat. Some of them may cause the\
clear coat to soften, crack,
or cloud. Damage caused by application of paint protection coatings may \
not be covered under your
vehicle's paint warranty.
Side windows with the water repellent glass coating-option
l Do not apply wax, degreasing agents, etc to this glass. This could damag\
e the coating.
l Clean the glass surface with care to avoid scratching.
l Use only suitable plastic scrapers to remove ice or snow from the window\
s.
NOTE: The water repellent coating is subject to natural wear.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_08.htm (3 of 7)12/30/2006 \
5:51:41 PM

2007 Volvo XC70
pg. 185 Maintenance and servicing
Maintaining your car
Owner maintenance
Periodic maintenance requirements and intervals are described in your ve\
hicle's Warranty and Service
Records Information booklet.
The following points can be carried out between the normally scheduled m\
aintenance services.
Each time the vehicle is refueled:
l Check the engine oil level
l Clean the windshield, windshield wipers, headlights, and tail lights
Monthly:
l Check cold tire pressure in all tires. Inspect the tires for wear.
l Check that engine coolant and other fluid levels are between the indicat\
ed "min" and "max" markings.
l Clean interior glass surfaces with a glass cleaner and soft paper towels\
.
l Wipe driver information displays with a soft cloth.
l Visually inspect battery terminals for corrosion. Corrosion may indicate\
a loose terminal connector, or
a battery near the end of its useful service life. Consult your Volvo re\
tailer for additional information.
As needed:
l Wash the vehicle, including the undercarriage, to reduce wear that can b\
e caused by a buildup of dirt,
and corrosion that can be caused by salt residues.
l Clean leaves and twigs from air intake vents at the base of the windshie\
ld, and from other places
where they may collect.
NOTE: Complete service information for qualified technicians is available onl\
ine for purchase or
subscription at
www.volvotechinfo.com.
pg. 186 Maintenance and servicing
Emission inspection readiness
What is an Onboard Diagnostic System (OBD II)?
OBD II is part of your vehicle's computerized engine management system. \
It stores diagnostic
information about your vehicle's emission controls. It can light the Che\
ck Engine light (MIL) if it detects
an emission control "fault." A "fault" is a component or system that is \
not performing within an expected
range. A fault may be permanent or temporary. OBD II will store a messag\
e about any fault.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (3 of 38)12/30/2006\
5:51:43 PM

2007 Volvo XC70
pg. 198 Maintenance and servicing
Replacing bulbs
When replacing bulbs, keep the following points in mind:
l Never touch the glass of bulbs with your fingers. Grease and oils from y\
our fingers vaporize in the
heat and will leave a deposit on the reflector, which will damage it.
l The optional Active Bi-Xenon headlight bulbs contain trace amounts of me\
rcury. These bulbs should
always be disposed of by an authorized Volvo retailer.
l The following bulbs should only be replaced by an authorized Volvo servi\
ce technician:
- Active Bi-Xenon headlights,
- Courtesy (dome) lighting,
- Reading lights,
- Glove compartment lights
- Turn signals and courtesy lights in the side door mirrors
- High-mounted brake lights
- Diodes in the rear tail lights
Replacing bulbs at the front of the vehicle
All front bulbs (except the optional front fog lights) are replaced fr\
om the engine compartment.
WARNING!
Active Bi-Xenon headlights (option) - due to the high voltage used by \
these headlights, these bulbs
should only be replaced by an authorized Volvo service technician.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (20 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
Location of the bulbs in the headlight housing
1. Side marker light
2. Turn signal
3. Low beam headlight/parking light (halogen headlights)
4. High beam headlight, parking light (Active Bi-Xenon headlights)
Certain models may have a plastic tube that may hinder access to the bul\
bs. This tube can be broken off
and discarded.
NOTE: If you encounter difficulty when changing a bulb, please contact a Volv\
o workshop.
pg. 199 Maintenance and servicing
Replacing bulbs
Low beam headlight
(Halogen headlights)
Removing the defective bulb:
- Switch off the headlights and turn the ignition switch to position 0. \
- Remove the plastic cover.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (21 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
- Disconnect the wiring connector.
- Loosen the retaining spring by first moving it to the right and then m\
oving it outward and downward,
out of the way.
- Pull out the defective bulb.
Installing the new bulb:
- Insert the new bulb, without touching the glass, with the guide lug up\
ward. The bulb will only seat
properly in this position.
- Move the retaining spring up and push it slightly to the left until it\
seats properly.
- Reconnect the wiring connector.
- Reinstall the plastic cover.
NOTE: If the vertical aim of your headlights needs to be adjusted for any rea\
son (e.g., towing a trailer
for extended periods), this should be done by an authorized Volvo retai\
ler.
High beam headlight
(Halogen headlights)
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (22 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
Removing the defective bulb:
- Switch off the headlights and turn the ignition switch to position 0. \
- Remove the cover to access the bulb assembly.
- Turn the bulb counterclockwise and pull it out.
- Disconnect the wiring connector by pressing the lock tab out and pulli\
ng.
- Twist the bulb counterclockwise, and pull it out of the holder.
pg. 200 Maintenance and servicing
Replacing bulbs
Installing the new bulb:
- Connect the wiring connector to the new bulb until it clicks into plac\
e.
- Insert the bulb into the headlight housing and turn it until it is sec\
urely in place.
- Press the cover back into place.
Parking light
(Halogen headlights)
Removing the defective bulb:
- Switch off the headlights and turn the ignition switch to position 0. \
- Remove the plastic cover of the low beam headlight assembly. Pull out \
the parking light holder.
- Pull the bulb out of the holder.
Installing the new bulb:
- Press a new bulb into the holder.
- Reinsert the bulb and holder into place.
- Reinstall the plastic cover.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (23 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
Parking light
(Active Bi-Xenon headlights)
Removing the defective bulb:
- Switch off the headlights and turn the ignition switch to position 0. \
- Remove the plastic cover of the high beam headlight assembly. Pull out\
the parking light holder.
- Pull the bulb out of the holder.
Installing the new bulb:
- Press a new bulb into the holder.
- Reinsert the bulb and holder into place.
- Reinstall the plastic cover.
pg. 201 Maintenance and servicing
Replacing bulbs
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (24 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
Turn signal, driver's side
Removing the defective bulb:
- Switch off the headlights and turn the ignition switch to position 0. \
- Pull out the bulb holder by twisting it counterclockwise.
- Remove the bulb from the holder by pressing it in and turning it count\
erclockwise.
Installing the new bulb:
- Insert the new bulb into the holder by pressing it in and turning it c\
lockwise.
- Reinsert the bulb holder in the headlight housing and twist it clockwi\
se until it seats properly.
Turn signal, passenger's side
- Switch off the headlights and turn the ignition switch to position 0. \
- Remove radiator pipe (1) from the box.
- Remove filler pipe screw (2).
- Pull the filler pipe (3) straight up.
- Remove vent hose (4) from filler pipe.
Installing the new bulb:
- Replace the bulb (same procedure as the driver's side bulb).
- Ensure that the seal between the washer fluid reservoir and the filler\
pipe is correctly positioned.
- Press the filler pipe (3) back into position.
- Press the vent hose (4) into place on the filler pipe.
- Reinstall and tighten the filler pipe screw (2).
- Reinstall the radiator pipe to the box (1).
pg. 202 Maintenance and servicing
Replacing bulbs
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (25 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
Side marker light
- Turn the lamp holder counterclockwise and pull it out.
- Pull out the defective bulb and insert a new one.
- Reinsert the lamp holder and turn it clockwise until it seats properly\
.
Front fog lights (option)
Removing the defective bulb:
- Switch off the headlights and turn the ignition switch to position 0. \
- Turn the bulb holder slightly counterclockwise.
- Pull out and remove the bulb.
Installing the new bulb:
- Insert the new bulb (it can only be inserted in one position).
- Reinsert the bulb holder and turn it clockwise. "TOP" must be upward. \
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (26 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
8. Alarm siren5
9. Brake light switch feed 5
10. Instrument panel, climate system, power driver's seat (option),
occupant weight sensor 10
11. 12-volt sockets - front and rear seats 15
12. -
13. -
14. Headlight wipers (V70 R) 15
15. ABS, STC/DSTC 5
16. Power steering, Active Bi-Xenon headlights (option) 10
17. Driver's side front foglight (option) 7.5
18. Passenger's side front foglight (option) 7.5
19. -
20. -
21. Transmission control module, reverse gear block (M66) 10
22. Driver's side high beam 10
23. Passenger's side high beam 10
24. -
25. -
26. -
27. -
28. Power passenger's seat (option), audio system 5
29. -
30. -
31. -
32. -
33. Vacuum pump 20
34. Washer pump - headlight wipers (V70 R) 15
35. -
36. -
pg. 208 Maintenance and servicing
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (33 of 38)12/30/200\
6 5:51:44 PM