spare tire VOLVO XC70 2007 User Guide

2007 Volvo XC70
NOTE: Please consult state or provincial regulations restricting the use of s\
tudded winter tires before
installing such tires.
1. Where permitted
pg. 171 Wheels and tires
Temporary spare
The spare tire in your vehicle is called a "Temporary Spare".
Recommended tire pressure (see the placard on the B-pillar or on the fu\
el filler door) should be
maintained irrespective of which position on the vehicle the temporary s\
pare tire is used on.
In the event of damage to this tire, a new one can be purchased from you\
r Volvo retailer.
WARNING!
Current legislation prohibits the use of the "Temporary Spare" tire othe\
r than as a temporary
replacement for a punctured tire. It must be replaced as soon as possibl\
e by a standard tire. Road
holding and handling may be affected with the "Temporary Spare" in use. \
Do not exceed 50 mph (80
km/h). Do not drive farther than 50 miles (80 km) on a temporary spar\
e tire.
CAUTION!
The vehicle must not be driven with wheels of different dimensions or wi\
th a spare tire other than the
one that came with the vehicle. The use of different size wheels can ser\
iously damage your vehicle's
transmission.
pg. 172 Wheels and tires
Temporary spare
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (18 of 24)12/30/200\
6 5:51:40 PM

2007 Volvo XC70
The spare tire, jack and tool bag are located under the floor of the car\
go space. To access the spare tire:
- Remove the rear hinged floor panel by raising it approx. 6 inches (15\
cm) and then pulling it
backwards out of the cargo area.
- Unscrew and remove the accessory plastic floor tray (if fitted).
- Unstrap and lift out the jack and tool bag.
- Unscrew the securing bracket and remove the spare tire from the storag\
e well.
- When putting the tire back into the well, perform these steps in rever\
se order. Make sure the spare tire,
jack and tool bag are properly secured.
WARNING!
Make sure that the spare tire, jack and tool bag are properly secured wi\
th the securing bracket and
strap to help keep these components in place in the event of a sudden st\
op.
pg. 173 Wheels and tires
Temporary spare
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (19 of 24)12/30/200\
6 5:51:40 PM

2007 Volvo XC70
Spare tire, tool bag, jack - vehicles with subwoofer (option)
The spare tire, jack and tool bag are located under the floor of the car\
go space in a compartment in front
of the spare tire. To access the spare tire:
- Remove the rear hinged floor panel by raising it approx. 6 inches (15\
cm) and then pulling it rearward
out of the cargo area.
- Raise the other floor panel to upright position and lock it there.
- Remove the mat.
- Loosen the wheel and turn the clip 90°.
- Lift the subwoofer inward-upward with both hands and tilt it leftward.\

- Unstrap and lift out the jack and tool bag.
- Unscrew the securing bracket and remove the spare tire from the storag\
e well.
- When putting the tire and subwoofer back into place, perform these ste\
ps in reverse order. Make sure
the spare tire, jack, tool bag and subwoofer are properly secured.
WARNING!
Make sure that the spare tire, jack and tool bag are properly secured wi\
th the securing bracket and
strap to help keep these components in place in the event of a sudden st\
op.
pg. 174 Wheels and tires
Changing wheels
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (20 of 24)12/30/200\
6 5:51:40 PM

2007 Volvo XC70
CAUTION!
- The vehicle must not be driven with wheels of different dimensions or \
with a spare tire other than
the one that came with the vehicle. The use of different size wheels can\
seriously damage your
vehicle's transmission.
- Correct tightening torque on wheel bolts must be observed. The wheel b\
olts should never be greased
or lubricated. The extended, chromed wheel bolts must not be used with s\
teel rims, as they make it
impossible to fit the hub caps.
- Locking wheel bolts can be used on both aluminum and steel wheels. If \
hub caps are used on steel
wheels, the locking wheel bolt should be mounted in the hole as far from\
the tire's inflation valve as
possible. It would otherwise not be possible to mount the hub cap on the\
wheel.
pg. 175 Wheels and tires
Changing wheels
- Position the jack correctly on the bar in the attachment (see illustr\
ation above) and crank while
simultaneously guiding the base of the jack to the ground. The base of t\
he jack must be flat on a level,
firm, non-slippery surface. Before raising the vehicle, check that the j\
ack is still correctly positioned in
the attachment.
- Raise the vehicle until the wheel to be changed is lifted off the grou\
nd.
- Unscrew the wheel bolts completely and carefully remove the wheel so a\
s not to damage the threads on
the studs.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (22 of 24)12/30/200\
6 5:51:40 PM