jump start terminals VOLVO XC90 TWIN ENGINE HYBRID 2017 Owners Manual

STARTING AND DRIVING
}}
395
Jump starting
Follow the instructions provided here to jumpstart your vehicle or to jump start another vehi-cle.
Jumper cable connecting terminals

NOTE
The vehicle cannot be started if the hybridbattery is discharged.

CAUTION
The vehicle's jumper cable connecting termi-nals may only be used to start your vehicle.They are not intended to be used to help startanother vehicle. If they are used to startanother vehicle, a fuse may blow and the ter-minal will not function.
If a fuse blows, 12 V Battery Fuse failureService required will be displayed in the instru-ment panel. Contact a trained and qualified Volvoservice technician.
Use the following steps when jump starting yourvehicle to help prevent short circuits or otherdamage.
1.Switch the ignition off completely (mode 0).
2.Ensure that the auxiliary battery to be used is12-volt.
3. If the 12-volt auxiliary battery to be used is inanother vehicle, switch off that vehicle's igni-tion and be sure that the vehicles are nottouching each other.
4. Connect one of the red jumper cable'sclamps to the auxiliary battery's positive (+)terminal (1).
CAUTION
Connect the jumper cables carefully to avoidshort circuits with other components in theengine compartment.
5. Open the cover over the positive (+) jumpstart terminal (2).
6.Connect the red jumper cable's other clampto your vehicle's positive (+) jump start termi-nal (2).
7. Connect one of the black jumper cable'sclamps to the auxiliary battery's negative (–)terminal (3).
8. Connect the black jumper cable's otherclamp to your vehicle's negative (–) jumpstart terminal (4).
9. Check that the jumper cables are securelyattached to help avoid sparks when the vehi-cle is started.
10. Start the engine in the assisting vehicle andrun it for a short time at approx. 1,500 rpm.

||
STARTING AND DRIVING
396
11. Start the engine in your vehicle. If the vehicledoes not start, allow an additional10 minutes of charging time and then try tostart the engine again.

NOTE
During normal starts, the electric motor is pri-oritized and the gasoline engine will not start.This means that when the start knob hasbeen turned toward START and released, theelectric motor is activated ("started") and thevehicle is ready to be driven. The warning andinformation symbols in the instrument panelwill go out and the chosen theme will be dis-played to indicate that the electric motor hasbeen activated.

CAUTION
Do not touch the jumper cable connectionswhile the vehicle is being started. This couldgenerate sparks.
12. After the vehicle has started, carefullyremove the jumper cables in reverse order,beginning with the black one.
Ensure that the black jumper cable's clampsdo not come in contact with the vehicle's orthe auxiliary battery's positive terminals orthe red jumper cable's clamps while it is con-nected.
WARNING
PROPOSITION 65 WARNING!
Battery posts, terminals, and related accesso-ries contain lead and lead compounds, chemi-cals known to the state of California to causecancer and reproductive harm. Wash handsafter handling.

WARNING
•Do not connect the jumper cable to anypart of the fuel system or to any movingparts. Avoid touching hot manifolds.
•Batteries generate hydrogen gas, whichis flammable and explosive.
•Battery fluid contains sulfuric acid. Do notallow battery fluid to contact eyes, skin,fabrics or painted surfaces. If contactoccurs, flush the affected area immedi-ately with water. Obtain medical helpimmediately if eyes are affected.
•Never expose the battery to open flameor electric spark.
•Do not smoke near the battery.
•Failure to follow the instructions for jumpstarting can lead to injury.

Related information
•Ignition modes (p. 400)
•Starting the engine (p. 402)
•Turning the engine off (p. 404)
•Start battery (p. 512)
•Opening and closing the hood (p. 539)
•Charging the hybrid battery (p. 413)