low beam YAMAHA BANSHEE 350 2001 Manuale de Empleo (in Spanish)

Cooling system ...................................8-23
Spark plug inspection .........................8-39
Air filter cleaning .................................8-43
Carburetor settings .............................8-51
Idle speed adjustment ........................8-67
Throttle lever adjustment ....................8-71
Front and rear brake pad
inspection .........................................8-73
Inspecting the brake fluid level ...........8-75
Brake fluid replacement......................8-79
Front brake lever free play
adjustment ........................................8-81
Rear brake adjustment .......................8-83
Parking brake adjustment...................8-85
Clutch adjustment ...............................8-89
Drive chain slack check ......................8-89
Drive chain slack adjustment ..............8-91
Drive chain cleaning and
lubrication .........................................8-93
Cable inspection and lubrication ........8-95Brake and shift pedal/brake and
clutch lever lubrication ......................8-97
Upper arm and lower arm pivot
lubrication .........................................8-97
Rear arm pivot lubrication ..................8-99
Wheel removal .................................8-101
Wheel installation .............................8-101
Replacing the headlight bulb ............8-103
Headlight beam adjustment..............8-105
Troubleshooting................................8-107
Troubleshooting chart.......................8-111
CLEANING AND STORAGE ...................9-1
A. Cleaning ...........................................9-1
B. Storage ............................................9-7
SPECIFICATIONS .................................10-1
HOW TO USE THE CONVERSION
TABLE ....................................................11-1
11
10
9

4-3
EBU00053
Handlebar switches
EBU00054
Engine stop switch “ENG. STOP”
Make sure that the engine stop switch is in the
“RUN” position. The engine stop switch controls
ignition and can be used at all times to stop the
engine, especially in an emergency. The engine
will not start or run when the engine stop switch
is turned to “OFF”.
EBU00736
Light switch “LIGHTS”
Turn the switch to the “LO” position to switch on
the low beam and the taillight.
Turn the switch to the “HI” position to switch on
the high beam and the taillight.
Turn the switch to the “OFF” position to switch off
the headlight and the taillight.
NOTE:
The headlight and the taillight can be turned on
only when the engine is started.
q
w
1. Lights switch “LIGHTS” 2. Engine stop switch
“ENG. STOP”
1. Contacteur d’éclairage 2. Coupe-circuit du moteur
“LIGHTS” “ENG. STOP”
1. Interruptor de luces 2. Interruptor de paro del
“LIGHTS” motor “ENG. STOP”