cooling YAMAHA BANSHEE 350 2001 Notices Demploi (in French)

Cooling system ...................................8-23
Spark plug inspection .........................8-39
Air filter cleaning .................................8-43
Carburetor settings .............................8-51
Idle speed adjustment ........................8-67
Throttle lever adjustment ....................8-71
Front and rear brake pad
inspection .........................................8-73
Inspecting the brake fluid level ...........8-75
Brake fluid replacement......................8-79
Front brake lever free play
adjustment ........................................8-81
Rear brake adjustment .......................8-83
Parking brake adjustment...................8-85
Clutch adjustment ...............................8-89
Drive chain slack check ......................8-89
Drive chain slack adjustment ..............8-91
Drive chain cleaning and
lubrication .........................................8-93
Cable inspection and lubrication ........8-95Brake and shift pedal/brake and
clutch lever lubrication ......................8-97
Upper arm and lower arm pivot
lubrication .........................................8-97
Rear arm pivot lubrication ..................8-99
Wheel removal .................................8-101
Wheel installation .............................8-101
Replacing the headlight bulb ............8-103
Headlight beam adjustment..............8-105
Troubleshooting................................8-107
Troubleshooting chart.......................8-111
CLEANING AND STORAGE ...................9-1
A. Cleaning ...........................................9-1
B. Storage ............................................9-7
SPECIFICATIONS .................................10-1
HOW TO USE THE CONVERSION
TABLE ....................................................11-1
11
10
9

6-23
Each full throttle acceleration sequence should
be followed with a substantial rest period for the
engine by cruising at lower r/min so the engine
can rid itself of the temporary build up of heat.
If any abnormality is noticed during this period,
consult a Yamaha dealer.
1. 0 ~ 10 hours:
Avoid continuous operation above half throt-
tle. Allow a cooling off period of five to ten
minutes after every hour of operation. Vary
the speed of the machine from time to time.
Do not operate it at one set throttle position.
2. 10 ~ 20 hours:
Avoid prolonged operation above 3/4 throt-
tle. Rev the machine freely through the
gears but do not use full throttle at any time.
3. After break-in:
Avoid prolonged full throttle operation. Vary
speeds occasionally.