wheel torque YAMAHA BANSHEE 350 2002 Manuale de Empleo (in Spanish)

8-87
5. Screw in the adjusting bolt on the brake
caliper by hand until it feels tight, then
screw it out 1/4 turn. Tighten the adjusting
bolt locknut to the specified torque.
wOperating with improperly adjusted brakes
could cause the brakes to malfunction
resulting in reduced braking performance.
This could increase the chance of a collision
or accident.
After adjusting the parking brake, block the
rear of the machine off the ground and spin
the rear wheels. Check to make sure there is
no brake drag. If brake drag is noticed, per-
form the adjustment again.
q
w
1. Ajusting bolt 2. Locknut1. Boulon de réglage 2. Contre-écrou1. Perno de ajuste 2. Contratuerca
Tightening torque:
16 Nm (1.6 m0kg)
5FK-9-63-8 2/7/02 1:28 PM Page 88

8-105
EBU00373Wheel removal
1. Elevate the wheel by placing a suitable
stand under the frame.
2. Remove the nuts from the wheel.
3. Remove the wheel assembly.EBU00740Wheel installation
When installing the wheel, reverse the removal
procedure.
Tighten the wheel nuts to the specified torque.
FrontAvantDelanteraRearArrièreTrasera
Tightening torque:
Wheel nut:
Front: 45 Nm (4.5 m0kg)
Rear: 45 Nm (4.5 m0kg)
5FK-9-63-8 2/7/02 1:28 PM Page 106