radiator cap YAMAHA BANSHEE 350 2002 Notices Demploi (in French)

3-1
EBU00032
DESCRIPTION AND MACHINE
IDENTIFICATION1. Tail/brake light 13. Rear wheel
2. Seat 14. Starter (choke)
3. Kick starter 15. Shift pedal
4. Fuel tank cap 16. Clutch lever
5. Headlight 17. Parking brake
6. Brake pedal 18. Main switch
7. Rear brake light switch 19. Front brake lever
8. Front wheel 20. Throttle lever
9. Front shock absorber 21. Handlebar switch
10. Radiator
11. Fuel cock
12. Rear shock absorberNOTE:
The machine you have purchased may differ
slightly from those shown in the figures of this
manual.
e
r
t
y
w
q
u
!6 !7
!8!9
@1 @0i!0!1
o
!2
!3
!4 !5
5FK-9-63-0~3 2/7/02 1:24 PM Page 46

8-29
EBU00766To change the coolantwWait for the engine and radiator to cool
before removing the radiator cap. You could
be burned by hot fluid and steam blown out
under pressure. Always put a thick rag over
the cap when opening. Allow any remaining
pressure to escape before completely
removing the cap.1. Put the ATV on a level place.
2. Remove the radiator cover bolts, and then
remove the radiator cover.
3. Place a container under the engine and
remove the coolant drain bolts.
q
w
w
q
q
1. Radiator cover 2. Radiator cover bolt (
×3)
1. Cache de radiateur 2. Boulons du cache de
radiateur (×3)1. Cubierta del radiador 2. Pernos de la cubierta del
radiador (×3)
1. Drain bolt (×2)1. Boulon de vidange (×2)1. Perno de drenaje (×2)
5FK-9-63-8 2/7/02 1:28 PM Page 30

8-31
4. Remove the radiator cap.
5. Remove the coolant reservoir cap.
q
q
1. Radiator cap1. Bouchon de radiateur1. Tapa del radiador
1. Coolant reservoir cap1. Bouchon du vase d’expansion1. Tapa del depósito de refrigerante
5FK-9-63-8 2/7/02 1:28 PM Page 32

8-35
cCHard water or salt water is harmful to the
engine. You may use soft water if you can’t
get distilled water.11. Install the radiator cap.Recommended antifreeze:
High quality ethylene glycol antifreeze
containing corrosion inhibitors for
aluminum engines.
Antifreeze and water mixing ratio:
1:1Total amount:
1.5 L Coolant reservoir capacity:
0.28 L
5FK-9-63-8 2/7/02 1:28 PM Page 36

8-37
12. Run the engine several minutes. Stop the
engine, and then check the coolant level in
the radiator. If it is low, add more coolant
until it reaches the top of the radiator.
13. Fill the coolant reservoir with coolant up to
the maximum level.
14. Install the coolant reservoir cap and check
for coolant leakage.NOTE:If any leakage is found, ask a Yamaha dealer to
inspect the cooling system.15. Install the radiator cover by installing the
bolts.
5FK-9-63-8 2/7/02 1:28 PM Page 38

8-118
Engine overheatingWait until the
engine has cooled.
Check the coolant level in the
reservoir tank and/or radiator.
Level is OK.Level is low, check the
cooling system for leakage.
No
leakage.Leakage.
Ask a Yamaha dealer
to inspect and repair
the cooling system.Add coolant.
(See NOTE.)
Restart the engine. If the engine overheats
again, ask a Yamaha dealer to inspect and
repair the cooling system.
NOTE:If it is difficult to get recommended coolant, tap water can be temporarily used, provided that it is
changed to the recommended coolant as soon as possible.wWait for the engine and radiator to cool before removing the radiator cap. You could be burned
by hot fluid and steam blown out under pressure. Always put a thick rag over the cap when
opening. Allow any remaining pressure to escape before completely removing the cap.
5FK-9-63-8 2/7/02 1:28 PM Page 119