drain bolt YAMAHA BANSHEE 350 2002 Owners Manual

8-19
Transmission oil replacement
1. Place the machine on a level place.
2. Warm up the engine for several minutes
and then stop it.
3. Place a container under the engine.
4. Remove the dipstick and drain bolt to drain
the oil.
5. Install the drain bolt and then tighten it to
the specified torque.
6. Fill the engine with oil and install the dip-
stick.
q
1. Drain bolt1. Boulon de vidange1. Perno de vaciado
Tightening torque:
Drain bolt:
20 Nm (2.0 m0kg)
5FK-9-63-8 2/7/02 1:28 PM Page 20

8-29
EBU00766To change the coolantwWait for the engine and radiator to cool
before removing the radiator cap. You could
be burned by hot fluid and steam blown out
under pressure. Always put a thick rag over
the cap when opening. Allow any remaining
pressure to escape before completely
removing the cap.1. Put the ATV on a level place.
2. Remove the radiator cover bolts, and then
remove the radiator cover.
3. Place a container under the engine and
remove the coolant drain bolts.
q
w
w
q
q
1. Radiator cover 2. Radiator cover bolt (
×3)
1. Cache de radiateur 2. Boulons du cache de
radiateur (×3)1. Cubierta del radiador 2. Pernos de la cubierta del
radiador (×3)
1. Drain bolt (×2)1. Boulon de vidange (×2)1. Perno de drenaje (×2)
5FK-9-63-8 2/7/02 1:28 PM Page 30

8-33
6. Disconnect the hose on the coolant reser-
voir side and drain the coolant from the
coolant reservoir.
7. After draining the coolant, thoroughly flush
the cooling system with clean tap water.
8. Replace the coolant drain bolt washers if
they are damaged, and then tighten the
coolant drain bolts to the specified torque.
9. Install the coolant reservoir hose.
10. Pour the recommended coolant into the
radiator until it is full.
q
w
1. Coolant reservoir hose
2. Coolant reservoir1. Flexible du vase d’expansion
2. Vase d’expansion1. Manguera del depósito de refrigerante
2. Depósito de refrigerante
Tightening torque
Coolant drain bolt:
14 Nm (1.4 m0kg)
5FK-9-63-8 2/7/02 1:28 PM Page 34