oil dipstick YAMAHA BEAR TRACKER 250 2003 Owners Manual

8-13 1. Oil filler cap 2. Dipstick
3. Maximum level mark 4. Minimum level mark
1. Bouchon de remplissage d’huile 2. Jauge
3. Repère de niveau maximum 4. Repère de niveau minimum
1. Tapa de relleno de aceite 2. Varilla de nivel de aceite
3. Marca de nivel máximo 4. Marca de nivel mínimo
EBU01100
Engine oil
Engine oil level measurement
1. Place the machine on a level surface.
2. Warm up the engine for several minutes and
stop it. Wait at least ten minutes for the oil to
drain back into the crankcase before check-
ing the oil level.NOTE:_ Be sure to wait at least ten minutes until the oil lev-
el settles before checking. _3. Remove the engine oil filler cap and wipe the
dipstick off with a clean rag. Insert the dip-
stick in the filler hole without screwing it in.
4. Remove the dipstick and check the oil level.
5. The oil level should be between the maxi-
mum and minimum marks. If the level is low,
add oil to raise it to the proper level.
6. Install the engine oil filler cap.CAUTION:_ Make sure no foreign material enters the
crankcase. _
U4XE64.book Page 13 Thursday, May 30, 2002 1:49 PM