drain bolt YAMAHA BEAR TRACKER 250 2004 Notices Demploi (in French)

8-15 1. Engine oil drain bolt 2. O-ring
3. Compression spring 4. Engine oil strainer
1. Boulon de vidange de l’huile moteur
2. Joint torique
3. Ressort de compression
4. Crépine à huile de moteur
1. Perno de drenaje del aceite de motor
2. Junta tórica
3. Muelle de compresión
4. Tamiz de aceite de motor
Engine oil replacement and oil filter element
cleaning
1. Place the machine on a level surface.
2. Warm up the engine for several minutes and
stop it.
3. Place a container under the engine to collect
the used oil.
4. Remove the engine oil filler cap and then the
drain bolt to drain the oil.CAUTION:_ When removing the drain bolt, the compres-
sion spring, oil strainer and O-ring will fall out.
Take care not to lose these parts. _
U4XE65.book Page 15 Tuesday, May 6, 2003 1:38 PM

8-17 1. Oil filter cover
2. Engine oil filter element
3. O-ring
1. Couvercle du filtre à huile
2.Élément du filtre à huile de moteur
3. Joint torique
1. Tapa del filtro de aceite
2. Elemento del filtro de aceite de motor
3. Junta tórica
5. Remove the oil filter cover and oil filter ele-
ment.
6. Clean the oil strainer and oil filter element
with solvent.
7. Inspect the O-ring and replace it if damaged.
8. Install the oil filter element, O-ring and oil filter
cover.
9. Install the oil strainer, compression spring,
O-ring and drain bolt.
10. Tighten the drain bolt and the oil filter cover
bolts to the specified torques.CAUTION:_ Before installing the drain bolt, be sure to in-
stall the O-ring, compression spring and oil
strainer. _11. Fill the engine with oil and install the engine
oil filler cap. Tightening torque:
Drain bolt (engine):
43 Nm (4.3 m·kgf)
Oil filter cover bolt:
10 Nm (1.0 m·kgf)
U4XE65.book Page 17 Tuesday, May 6, 2003 1:38 PM

8-23 1. Final gear case cover 2. Bolt (× 3)
1. Couvercle du carter de transmission finale 2. Boulon (× 3)
1. Cubierta del cárter de la transmisión final 2. Perno (× 3)
1. Final gear oil drain bolt
1. Boulon de vidange du carter de transmission finale
1. Perno de drenaje del aceite del cárter de la transmisión final
Final gear oil replacement
1. Remove the final gear case cover by remov-
ing the bolts.
2. Place the machine on a level surface.
3. Place a container under the final gear case to
collect the used oil.
4. Remove the oil filler bolt and the drain bolt to
drain the oil.
5. Install the drain bolt, and then tighten it to the
specified torque.
6. Add the recommended final gear oil to the
brim of the filler hole. Tightening torque:
Final gear oil drain bolt:
23 Nm (2.3 m·kgf)
Recommended oil:
See page 10-3.
Oil quantity:
0.25 L
U4XE65.book Page 23 Tuesday, May 6, 2003 1:38 PM