engine overheat YAMAHA BIG BEAR PRO 400 2003 Manuale de Empleo (in Spanish)

4-3 1. Reverse indicator light “REVERSE”
2. Neutral indicator light “NEUTRAL”
3. Oil temperature indicator light “”
1. Témoin de marche arrière “REVERSE”
2. Témoin de point mort “NEUTRAL”
3. Témoin de température d’huile “”
1. Luz de control de marcha atrás “REVERSE”
2. Luz de control de punto muerto “NEUTRAL”
3. Luz de control de la temperatura del aceite “”
EBU00802
Indicator and warning lights
EBU00044
Reverse indicator light “REVERSE”
This indicator light comes on when the transmis-
sion is in reverse.
EBU00045
Neutral indicator light “NEUTRAL”
This indicator light comes on when the transmis-
sion is in neutral.
EBU00732
Oil temperature warning light “”
When the oil temperature reaches a specified lev-
el, this light comes on to warn that the engine oil
temperature is too hot. If the warning light comes
on during operation, stop the engine as soon as it
is safe to do so and allow the engine to cool down
for about 10 minutes.CAUTION:_

The engine may overheat if the ATV is
overloaded. If this happens, reduce the
load to specification.


Restart after making sure that the warning
light is out. Continuous use while the
warning light is on may cause damage to
the engine.
_
U4SH6A.book Page 3 Thursday, May 30, 2002 1:25 PM

4-25 1. Lock plate
1. Verrou de stationnement
1. Placa de bloqueo
EBU00075
Parking brake
Use the parking brake when you have to start the
engine or park the machine, especially on a slope.
Apply the rear brake lever and push down the lock
plate to apply the parking brake. Squeeze the rear
brake lever to release the parking brake.
WARNING


Always set the parking brake before start-
ing the engine. The ATV could start mov-
ing unexpectedly if the parking brake is not
applied. This could cause loss of control or
a collision.


Always be sure you have released the
parking brake before you begin to ride. The
brake could overheat if you ride the ATV
without releasing the parking brake. You
could lose braking performance which
could cause an accident. You could also
wear out the brakes prematurely.
U4SH6A.book Page 25 Thursday, May 30, 2002 1:25 PM

8-47
8. Reinstall the element to the element guide.
9. Reinstall the element assembly and parts re-
moved for access.NOTE:The air filter element should be cleaned every 20–
40 hours. It should be cleaned and lubricated more
often if the machine is operated in extremely dusty
areas. Each time filter element maintenance is
performed, check the air inlet to the filter case for
obstructions. Check the air cleaner rubber joint to
the carburetor and manifold fittings for an air-tight
seal. Tighten all fittings securely to avoid the pos-
sibility of unfiltered air entering the engine.CAUTION:
Never operate the engine with the air filter ele-
ment removed. This will allow unfiltered air to
enter, causing rapid engine wear and possible
engine damage. Additionally, operation with-
out the filter element will affect carburetor jet-
ting with subsequent poor performance and
possible engine overheating.
U4SH6A.book Page 47 Thursday, May 30, 2002 1:25 PM