tire pressure YAMAHA BIG BEAR PRO 400 2003 Notices Demploi (in French)

Tires ....................................................5-21
How to measure tire pressure .............5-25
Tire wear limit......................................5-27
OPERATION ............................................6-1
Starting a cold engine ...........................6-3
Starting a warm engine .........................6-9
Warming up...........................................6-9
Drive select lever operation
and reverse driving ...........................6-11
Reverse lock release wire ...................6-15
Shifting ................................................6-17
To start out and accelerate: ................6-19
To decelerate: .....................................6-21
Engine break-in ...................................6-23
Parking ................................................6-27
Parking on a slope ..............................6-27
Accessories and loading .....................6-29
Accessories.........................................6-29
RIDING YOUR ATV..................................7-1
Getting to know your ATV .....................7-3
Ride with care and good judgement .....7-5
Be careful where you ride ...................7-27
Turning your ATV ................................7-41
Climbing uphill.....................................7-47
Riding downhill ....................................7-57
67
Crossing a slope ................................. 7-61
Crossing through shallow water ......... 7-65
Riding over rough terrain .................... 7-69
Sliding and skidding............................ 7-71
What to do if ....................................... 7-75
What to do .......................................... 7-75
PERIODIC MAINTENANCE AND
ADJUSTMENT ......................................... 8-1
Owner’s manual and tool kit ................. 8-3
Periodic maintenance/lubrication.......... 8-7
Engine oil ............................................ 8-13
Transfer gear oil replacement............. 8-23
Final gear oil ....................................... 8-27
Differential gear oil replacement ......... 8-31
Axle boots ........................................... 8-35
Spark plug inspection ......................... 8-37
Air filter cleaning ................................. 8-43
Carburetor adjustment ........................ 8-49
Idle speed adjustment ........................ 8-51
Valve clearance adjustment ............... 8-53
Select lever safety system
cable adjustment .............................. 8-53
Throttle lever adjustment .................... 8-55
Front brake pad inspection ................. 8-55
Rear brake shoe inspection ................ 8-57
Brake fluid level inspection ................. 8-57
8
EE.book Page 2 Monday, June 18, 2001 10:18 AM

2-13

Never operate an ATV in fast flowing water or
in water deeper than that recommended in this
manual. Remember that wet brakes may have
reduced stopping ability. Test your brakes after
leaving water. If necessary, apply them several
times to let friction dry out the linings.


Always be sure there are no obstacles or peo-
ple behind you when you operate in reverse.
When it is safe to proceed in reverse, go slowly.


Always use the size and type tires specified in
this manual.


Always maintain proper tire pressure as de-
scribed in this manual.


Never modify an ATV through improper instal-
lation or use of accessories.


Never exceed the stated load capacity for an
ATV. Cargo should be properly distributed and
securely attached. Reduce speed and follow
instructions in this manual for carrying cargo or
pulling a trailer. Allow greater distance for brak-
ing.
EE.book Page 13 Monday, June 18, 2001 10:18 AM

5-1
EBU00113
1-PRE-OPERATION CHECKS
Before using this machine, check the following points:
ITEM ROUTINE PAGE
Front brakeCheck operation, free play, fluid level and fluid leakage.
Fill with DOT 4 brake fluid if necessary.5-5 ~ 5-7,
8-55 ~ 8-73
Rear brakeCheck operation, pedal height and free play.
FuelCheck fuel level.
Fill with fuel if necessary.5-9 ~ 5-11
Engine oil/
Transfer gear oilCheck oil level.
Fill with oil if necessary.5-13 ~ 5-15,
8-13 ~ 8-25
Final gear oil/
Differential gear oilCheck for leakage. 5-17, 8-27 ~ 8-35
ThrottleCheck for proper throttle cable operation. 5-17, 8-55
Wheels and tiresCheck tire pressure, wear and damage.5-21 ~ 5-27,
8-79 ~ 8-83
Fittings and FastenersCheck all fittings and fasteners. 5-19
LightsCheck for proper operation. 5-19, 8-91 ~ 8-95
Axle bootsCheck operation. 8-35
EE.book Page 1 Monday, June 18, 2001 10:18 AM

5-23
2. The tires should be set to the recommend-
ed pressure:

Recommended tire pressure
Front 25 kPa (0.25 kgf/cm
2, 0.25 bar)
Rear 25 kPa (0.25 kgf/cm2, 0.25 bar)


Check and adjust tire pressures when the
tires are cold.


Tire pressures must be equal on both
sides.
3. Tire pressure below the minimum speci-
fied could cause the tire to dislodge from
the rim under severe riding conditions.
The following are minimums:
Front 22 kPa (0.22 kgf/cm
2, 0.22 bar)
Rear 22 kPa (0.22 kgf/cm2, 0.22 bar)
4. Use no more than the following pressures
when seating the tire beads.
Front 250 kPa (2.5 kgf/cm2, 2.5 bar)
Rear 250 kPa (2.5 kgf/cm2, 2.5 bar)
Higher pressures may cause the tire to
burst. Inflate the tires very slowly and
carefully. Fast inflation could cause the
tire to burst.
EE.book Page 23 Monday, June 18, 2001 10:18 AM

5-25 1. Low-pressure tire gauge
1. Manomètre basse pression pour pneus
1. Manómetro de baja presión
EBU00159
How to measure tire pressure
Use the low-pressure tire gauge.NOTE:The low-pressure tire gauge is included as stan-
dard equipment. Make two measurements of the
tire pressure and use the second reading. Dust or
dirt in the gauge could cause the first reading to be
incorrect.Set pressure with tires cold.
Set tire pressures to the following specifications:ACE-02EACE-02E
Recommended
pressureMinimum Maximum
Front25 kPa
(0.25 kgf/cm
2,
0.25 bar)22 kPa
(0.22 kgf/cm
2,
0.22 bar)28 kPa
(0.28 kgf/cm
2,
0.28 bar)
Rear25 kPa
(0.25 kgf/cm
2,
0.25 bar)22 kPa
(0.22 kgf/cm
2,
0.22 bar)28 kPa
(0.28 kgf/cm
2,
0.28 bar)
EE.book Page 25 Monday, June 18, 2001 10:18 AM

7-15
WARNING
Always use the size and type tires specified in
the Owner’s Manual for this vehicle on pages
5-21 ~ 5-23. Always maintain proper tire pres-
sure as described in the Owner’s Manual on
page 5-25. Use of improper tires on this ATV,
or operation of this ATV with improper or un-
even tire pressure, may cause loss of control,
increasing your risk of an accident.Do not operate at speeds too fast for your
skills or the conditions.
WARNING
Always go at a speed that is proper for the ter-
rain, visibility and operating conditions, and
your experience. Operating this ATV at speeds
too fast for your skills or the conditions in-
creases your chances of losing control of the
ATV, which can result in an accident.
EE.book Page 15 Monday, June 18, 2001 10:18 AM

8-3 1. Owner’s manual
2. Low-pressure tire gauge
1. Manuel du propriétaire
2. Manomètre basse pression pour pneus
1. Manual del propietario
2. Manómetro de baja presión
1. Owner’s tool kit
1. Trousse à outils
1. Equipo de herramientas
EBU00256
Owner’s manual and tool kit
You are recommended to put this owner’s manual
and low-pressure tire gauge in the vinyl bag and
always carry them in the storage box. Put the own-
er’s tool kit in the space under the seat. The ser-
vice information included in this manual is
intended to provide you, the owner, with the nec-
essary information for completing your own pre-
ventive maintenance and minor repairs. The tools
provided in the Owner’s tool kit are sufficient for
this purpose, except that a torque wrench is also
necessary to properly tighten nuts and bolts.NOTE:If you do not have a torque wrench available dur-
ing a service operation requiring one, take your
machine to a Yamaha dealer to check the torque
settings and adjust them as necessary.
EE.book Page 3 Monday, June 18, 2001 10:18 AM